- 您現在的位置：買賣IC網 > PDF目錄362093 > AD565AT (Analog Devices, Inc.) High Speed 12-Bit Monolithic D/A Converters PDF資料下載
參數資料
| 型號： | AD565AT |
| 廠商： | Analog Devices, Inc. |
| 英文描述： | High Speed 12-Bit Monolithic D/A Converters |
| 中文描述： | 高速12位單片D / A轉換 |
| 文件頁數： | 9/11頁 |
| 文件大?。?/td> | 152K |
| 代理商： | AD565AT |
AD565A/AD566A
REV. D
–
9
–
CONNECTING THE AD566A FOR BUFFERED VOLTAGE
OUTPUT
The standard current-to-voltage conversion connections using
an operational amplifier are shown here with the preferred trim-
ming techniques. If a low offset operational amplifier (AD510L,
AD517L, AD741L, AD301AL, AD OP07) is used, excellent
performance can be obtained in many situations without trim-
ming (an op amp with less than 0.5 mV max offset voltage
should be used to keep offset errors below 1/2 LSB). If a 50
fixed resistor is substituted for the 100
trimmer, unipolar zero
will typically be within
±
1/2 LSB (plus op amp offset), and full
scale accuracy will be within 0.1% (0.25% max). Substituting a
50
resistor for the 100
bipolar offset trimmer will give a
bipolar zero error typically within
±
2 LSB (0.05%).
The AD509 is recommended for buffered voltage-output appli-
cations which require a settling time to
±
1/2 LSB of one micro-
second. The feedback capacitor is shown with the optimum
value for each application; this capacitor is required to compen-
sate for the 25 picofarad DAC output capacitance.
FIGURE 4. UNIPOLAR CONFIGURATION
This configuration will provide a unipolar 0 volt to +10 volt
output range. In this mode, the bipolar terminal, Pin 7, should
be grounded if not used for trimming.
100k
+15V
–
15V
R1
50k
19.95k
20k
0.5mA
I
REF
DAC
I
OUT
=
4 I
CODE
AD566A
9.95k
5k
8k
I
O
20V SPAN
10V SPAN
DAC
OUT
POWER
GND
–
V
EE
REF
GND
BIPOLAR OFF
5k
CODE
INPUT
LSB
MSB
R2
100
10pF
AD509
2.4k
100
10V
E
AD561
+V
REF
IN
Figure 4. 0 V to +10 V Unipolar Voltage Output
STEP I . . . ZERO ADJUST
Turn all bits OFF and adjust zero trimmer, R1, until the output
reads 0.000 volts (1 LSB = 2.44 mV). In most cases this trim is
not needed, but Pin 7 should then be connected to Pin 12.
STEP II . . . GAIN ADJUST
Turn all bits ON and adjust 100
gain trimmer, R2, until the
output is 9.9976 volts. (Full scale is adjusted to 1 LSB less than
nominal full scale of 10.000 volts.) If a 10.2375 V full scale is
desired (exactly 2.5 mV/bit), insert a 120
resistor in series
with the gain resistor at Pin 10 to the op amp output.
FIGURE 5. BIPOLAR CONFIGURATION
This configuration will provide a bipolar output voltage from
–5.000 volts to +4.9976 volts, with positive full scale occurring
with all bits ON (all 1s).
19.95k
20k
0.5mA
I
REF
DAC
I
OUT
4 I
REF
CODE
AD566A
9.95k
5k
8k
I
O
20V SPAN
10V SPAN
DAC
OUT
POWER
GND
–
V
EE
REF
GND
BIPOLAR OFF
5k
CODE
INPUT
LSB
MSB
R2
100
10pF
AD509
2.4k
10V
E
AD561
+V
REF
IN
R1
100
Figure 5.
±
5 V Bipolar Voltage Output
STEP I . . . OFFSET ADJUST
Turn OFF all bits. Adjust 100
trimmer R1 to give –5.000
output volts.
STEP II . . . GAIN ADJUST
Turn ON all bits. Adjust 100
gain trimmer R2 to give a read-
ing of +4.9976 volts.
Please note that it is not necessary to trim the op amp to obtain
full accuracy at room temperature. In most bipolar situations,
an op amp trim is unnecessary unless the untrimmed offset drift
of the op amp is excessive.
相關PDF資料 |
PDF描述 |
|---|---|
| AD565ATD | RECTIFIER BRIDGE 1.5A 800V WOG |
| AD566A | High Speed 12-Bit Monolithic D/A Converters |
| AD566AJD | High Speed 12-Bit Monolithic D/A Converters |
| AD566ASD | High Speed 12-Bit Monolithic D/A Converters |
| AD566ATD | High Speed 12-Bit Monolithic D/A Converters |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD565ATD | 功能描述:數模轉換器- DAC IC MONO 12-BIT D/A CONV RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| AD565ATD/883B | 功能描述:數模轉換器- DAC IC MONO 12-BIT D/A CONV RoHS:否 制造商:Texas Instruments 轉換器數量:1 DAC 輸出端數量:1 轉換速率:2 MSPs 分辨率:16 bit 接口類型:QSPI, SPI, Serial (3-Wire, Microwire) 穩定時間:1 us 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-14 封裝:Tube |
| AD565ATD883B | 制造商:AD 功能描述:New |
| AD565ATQ | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:12-Bit Digital-to-Analog Converter |
| AD5660 | 制造商:Analog Devices 功能描述:2.7V TO 5.5V, 16-BIT DAC WITH 10PPM REF - Bulk |
發布緊急采購，3分鐘左右您將得到回復。