- 您現在的位置：買賣IC網 > PDF目錄8729 > AD5433YRUZ-REEL (Analog Devices Inc)IC DAC 10BIT MULTIPLYING 20TSSOP PDF資料下載
參數資料
| 型號： | AD5433YRUZ-REEL |
| 廠商： | Analog Devices Inc |
| 文件頁數： | 17/29頁 |
| 文件大小： | 0K |
| 描述： | IC DAC 10BIT MULTIPLYING 20TSSOP |
| 產品培訓模塊： | Data Converter Fundamentals DAC Architectures |
| 標準包裝： | 2,500 |
| 設置時間： | 35ns |
| 位數： | 10 |
| 數據接口： | 并聯 |
| 轉換器數目： | 1 |
| 電壓電源： | 單電源 |
| 功率耗散（最大）： | 25µW |
| 工作溫度： | -40°C ~ 125°C |
| 安裝類型： | 表面貼裝 |
| 封裝/外殼： | 20-TSSOP（0.173"，4.40mm 寬） |
| 供應商設備封裝： | 20-TSSOP |
| 包裝： | 帶卷 (TR) |
| 輸出數目和類型： | 2 電流，單極；2 電流，雙極 |
| 采樣率（每秒）： | 20.4M |
| 配用： | EVAL-AD5433EBZ-ND - BOARD EVAL FOR AD5433 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁
Data Sheet
AD5424/AD5433/AD5445
Rev. D | Page 23 of 28
Provided the DAC switches are driven from true wideband
low impedance sources (VIN and AGND), they settle quickly.
Consequently, the slew rate and settling time of a voltage
switching DAC circuit is determined largely by the output op
amp. To obtain minimum settling time in this configuration, it
is important to minimize capacitance at the VREF node (voltage
output node in this application) of the DAC. This is done by using
low inputs capacitance buffer amplifiers and careful board design.
Most single-supply circuits include ground as part of the analog
signal range, which in turns requires an amplifier that can handle
rail-to-rail signals. There is a large range of single-supply
amplifiers available from Analog Devices.
PARALLEL INTERFACE
of an 8-, 10-, or 12-bit parallel word. Control lines CS and R/W
allow data to be written to or read from the DAC register. A
write event takes place when CS and R/W are brought low, data
available on the data lines fills the shift register, and the rising
edge of CS latches the data and transfers the latched data-word
to the DAC register. The DAC latches are not transparent, thus
a write sequence must consist of a falling and rising edge on CS
to ensure that data is loaded to the DAC register and its analog
equivalent is reflected on the DAC output.
A read event takes place when R/W is held high and CS is
brought low. New data is loaded from the DAC register back to
the input register and out onto the data line where it can be read
back to the controller for verification or diagnostic purposes.
MICROPROCESSOR INTERFACING
the ADSP-21xx series of DSPs as a memory-mapped device. A
single wait state may be necessary to interface the AD5424/
speed of the DSP. The wait state can be programmed via the
data memory wait state control register of the ADSP-21xx
(see the ADSP-21xx family user’s manual for details).
03160-056
R/W
DB0 TO DB11
AD5424/
AD5433/
AD5445*
ADDRESS
DECODER
CS
DATA 0 TO
DATA 23
ADDRESS BUS
ADDR0 TO
ADRR13
ADSP-21xx*
DATA BUS
DMS
WR
*ADDITIONAL PINS OMITTED FOR CLARITY
AD5445 and the 8xC51 family of DSPs. To facilitate external
data memory access, the address latch enable (ALE) mode is
enabled. The low byte of the address is latched with this output
pulse during access to external memory. AD0 to AD7 are the
multiplexed low order addresses and data bus and require
strong internal pull-ups when emitting 1s. During access to
external memory, A8 to A15 are the high order address bytes.
Since these ports are open drained, they also require strong
internal pull-ups when emitting 1s.
03160-063
R/W
DB0 TO DB11
AD5424/
AD5433/
AD5445*
ADDRESS
DECODER
CS
AD0 TO AD7
ADDRESS BUS
A8 TO A15
8051*
DATA BUS
WR
*ADDITIONAL PINS OMITTED FOR CLARITY
8-BIT
LATCH
ALE
asynchronous memory write cycle of the processor drives the
digital inputs of the DAC. The AMSx line is actually four memory
select lines. Internal ADDR lines are decoded into AMS3-0, these
lines are then inserted as chip selects. The rest of the interface is
a standard handshaking operation.
03160-057
R/W
DB0 TO DB11
AD5424/
AD5433/
AD5445*
ADDRESS
DECODER
CS
DATA 0 TO
DATA 23
ADDRESS BUS
ADDR1 TO
ADRR19
ADSP-BF5xx
DATA BUS
AMSx
AWE
*ADDITIONAL PINS OMITTED FOR CLARITY
相關PDF資料 |
PDF描述 |
|---|---|
| SY10H842LZH TR | IC CLK BUFFER 1:4 160MHZ 16-SOIC |
| VE-B6D-IU-B1 | CONVERTER MOD DC/DC 85V 200W |
| SY10H841ZH TR | IC CLK BUFFER 1:4 160MHZ 16-SOIC |
| SY10H841LZH TR | IC CLK BUFFER 1:4 160MHZ 16-SOIC |
| SY100H842ZH TR | IC CLK BUFFER 1:4 160MHZ 16-SOIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD5433YRUZ-REEL7 | 功能描述:IC DAC 10BIT MULTIPLYING 20TSSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 產品培訓模塊:LTC263x 12-, 10-, and 8-Bit VOUT DAC Family 特色產品:LTC2636 - Octal 12-/10-/8-Bit SPI VOUT DACs with 10ppm/°C Reference 標準包裝:91 系列:- 設置時間:4µs 位數:10 數據接口:MICROWIRE?，串行，SPI? 轉換器數目:8 電壓電源:單電源 功率耗散（最大）:2.7mW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:14-WFDFN 裸露焊盤 供應商設備封裝:14-DFN-EP（4x3） 包裝:管件 輸出數目和類型:8 電壓，單極 采樣率（每秒）:* |
| AD5439 | 制造商:AD 制造商全稱:Analog Devices 功能描述:Dual 8-,10-,12-Bit High Bandwidth Multiplying DACs with Serial Interface |
| AD5439YRU | 功能描述:IC DAC DUAL 10BIT MULT 16-TSSOP RoHS:否 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:- 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:* |
| AD5439YRU-REEL | 制造商:Analog Devices 功能描述:DAC 2-CH R-2R 10-bit 16-Pin TSSOP T/R 制造商:Analog Devices 功能描述:DAC 2CH R-2R 10-BIT 16TSSOP - Tape and Reel |
| AD5439YRU-REEL7 | 制造商:Analog Devices 功能描述:DAC 2-CH R-2R 10-bit 16-Pin TSSOP T/R 制造商:Analog Devices 功能描述:DAC 2CH R-2R 10-BIT 16TSSOP - Tape and Reel |
發布緊急采購，3分鐘左右您將得到回復。