參數資料
型號: AD5162BRMZ10-RL7
廠商: Analog Devices Inc
文件頁數: 5/20頁
文件大?。?/td> 0K
描述: IC POT DGTL DUAL 256POS 10MSOP
標準包裝: 1,000
接片: 256
電阻(歐姆): 10k
電路數: 2
溫度系數: 標準值 35 ppm/°C
存儲器類型: 易失
接口: 3 線串行(芯片選擇)
電源電壓: 2.7 V ~ 5.5 V
工作溫度: -40°C ~ 125°C
安裝類型: 表面貼裝
封裝/外殼: 10-TFSOP,10-MSOP(0.118",3.00mm 寬)
供應商設備封裝: 10-MSOP
包裝: 帶卷 (TR)
配用: AD5162EVAL-ND - BOARD EVAL FOR AD5162
AD5162
Rev. C | Page 13 of 20
THEORY OF OPERATION
The AD5162 is a 256-position, digitally controlled variable
resistor (VR) device.
An internal power-on preset places the wiper at midscale
during power-on, which simplifies the fault condition recovery
at power-up.
PROGRAMMING THE VARIABLE RESISTOR AND
VOLTAGE
Rheostat Operation
The nominal resistance of the RDAC between Terminal A and
Terminal B is available in 2.5 k, 10 k, 50 k, and 100 k.
The nominal resistance (RAB) of the VR has 256 contact points
accessed by the wiper terminal and the B terminal contact. The
8-bit data in the RDAC latch is decoded to select one of the
256 possible settings.
A
W
B
A
W
B
A
W
B
04108-0-034
Figure 33. Rheostat Mode Configuration
Assuming that a 10 k part is used, the first connection of the
wiper starts at the B terminal for Data 0x00. Because there is
a 50 wiper contact resistance, such a connection yields a
minimum of 100 (2 × 50 ) resistance between Terminal W
and Terminal B. The second connection is the first tap point,
which corresponds to 139 (RWB = RAB/256 + 2 × RW = 39 +
2 × 50 ) for Data 0x01. The third connection is the next tap
point, representing 178 (2 × 39 + 2 × 50 ) for Data 0x02,
and so on. Each LSB data value increase moves the wiper up the
resistor ladder until the last tap point is reached at 10,100
(RAB + 2 × RW).
D5
D4
D3
D7
D6
D2
D1
D0
RDAC
LATCH
AND
DECODER
RS
A
W
B
04108-0-035
Figure 34. AD5162 Equivalent RDAC Circuit
The general equation determining the digitally programmed
output resistance between W and B is
W
AB
WB
R
D
R
×
+
×
=
2
256
)
(
(1)
where:
D is the decimal equivalent of the binary code loaded in the
8-bit RDAC register.
RAB is the end-to-end resistance.
RW is the wiper resistance contributed by the on resistance of
the internal switch.
In summary, if RAB is 10 k and the A terminal is open
circuited, the output resistance, RWB, is set according to the
RDAC latch codes, as listed in Table 6.
Table 6. Codes and Corresponding RWB Resistance
D (Dec)
R
WB ()
Output State
255
9961
Full scale (R
AB 1 LSB + RW)
128
5060
Midscale
1
139
1 LSB
0
100
Zero scale (wiper contact resistance)
Note that in the zero-scale condition, a finite wiper resistance of
100 is present. Care should be taken to limit the current flow
between W and B in this state to a maximum pulse current of
no more than 20 mA. Otherwise, degradation or possible
destruction of the internal switch contact may occur.
Similar to the mechanical potentiometer, the resistance of the
RDAC between Wiper W and Terminal A also produces a
digitally controlled complementary resistance, RWA. When these
terminals are used, the B terminal can be opened. Setting the
resistance value for RWA starts at a maximum value of resistance
and decreases as the data loaded in the latch increases in value.
The general equation for this operation is
W
AB
WA
R
D
R
×
+
×
=
2
256
)
(
(2)
When RAB is 10 k and the B terminal is open circuited, the
output resistance, RWA, is set according to the RDAC latch
codes, as listed in Table 7.
Table 7. Codes and Corresponding RWA Resistance
D (Dec)
R
WA ()
Output State
255
139
Full scale
128
5060
Midscale
1
9961
1 LSB
0
10,060
Zero scale
Typical device-to-device matching is process-lot dependent and
may vary by up to ±30%. Because the resistance element is
processed in thin-film technology, the change in RAB with tem-
perature has a very low temperature coefficient of 35 ppm/°C.
相關PDF資料
PDF描述
M83723/76R2212N CONN PLUG 12POS STRAIGHT W/PINS
MS27473E22B1PC CONN PLUG 100POS STRAIGHT W/PINS
MS27484E20B41PB CONN PLUG 41POS STRAIGHT W/PINS
VI-B4X-IU-F3 CONVERTER MOD DC/DC 5.2V 200W
MS3108E24-5P CONN PLUG 16POS RT ANG W/PINS
相關代理商/技術參數
參數描述
AD5162BRMZ2.5 功能描述:IC POT DUAL 2.5K 256POS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:1 系列:- 接片:256 電阻(歐姆):100k 電路數:1 溫度系數:標準值 35 ppm/°C 存儲器類型:非易失 接口:3 線串口 電源電壓:2.7 V ~ 5.25 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WDFN 裸露焊盤 供應商設備封裝:8-TDFN-EP(3x3) 包裝:剪切帶 (CT) 產品目錄頁面:1399 (CN2011-ZH PDF) 其它名稱:MAX5423ETA+TCT
AD5162BRMZ2.5-RL7 功能描述:IC POT DGTL DUAL 256POS 10MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻(歐姆):10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行(芯片選擇,遞增,增/減) 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN(2x3) 包裝:帶卷 (TR)
AD5162BRMZ50 功能描述:IC POT DGTL DUAL 256POS 10-MSOP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,300 系列:WiperLock™ 接片:257 電阻(歐姆):100k 電路數:1 溫度系數:標準值 150 ppm/°C 存儲器類型:易失 接口:3 線 SPI(芯片選擇) 電源電壓:1.8 V ~ 5.5 V 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-VDFN 裸露焊盤 供應商設備封裝:8-DFN-EP(3x3) 包裝:帶卷 (TR)
AD5162BRMZ50-RL7 功能描述:IC POT DTL DUAL 256POS 10MSOP TR RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數字電位器 系列:- 標準包裝:3,000 系列:DPP 接片:32 電阻(歐姆):10k 電路數:1 溫度系數:標準值 300 ppm/°C 存儲器類型:非易失 接口:3 線串行(芯片選擇,遞增,增/減) 電源電壓:2.5 V ~ 6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:8-WFDFN 裸露焊盤 供應商設備封裝:8-TDFN(2x3) 包裝:帶卷 (TR)
AD5162EVAL 功能描述:BOARD EVAL FOR AD5162 RoHS:否 類別:編程器,開發系統 >> 評估演示板和套件 系列:- 標準包裝:1 系列:- 主要目的:數字電位器 嵌入式:- 已用 IC / 零件:AD5258 主要屬性:- 次要屬性:- 已供物品:板 相關產品:AD5258BRMZ1-ND - IC POT DGTL I2C1K 64P 10MSOPAD5258BRMZ10-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ100-ND - IC POT DGTL I2C 100K 64P 10MSOPAD5258BRMZ50-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ1-R7-ND - IC POT DGTL I2C 1K 64P 10MSOPAD5258BRMZ10-R7-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ50-R7-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ100-R7-ND - IC POT DGTL I2C 100K 64P 10MSOP