- 您現在的位置：買賣IC網 > PDF目錄373866 > AD28MSP02BR (ANALOG DEVICES INC) Voiceband Signal Port PDF資料下載
參數資料
| 型號： | AD28MSP02BR |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 消費家電 |
| 英文描述： | Voiceband Signal Port |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PDSO28 |
| 封裝： | SOIC-28 |
| 文件頁數： | 3/20頁 |
| 文件大小： | 330K |
| 代理商： | AD28MSP02BR |
AD28msp02
REV. 0
–3–
D/A CONVERSION
The D/A conversion circuitry of the AD28msp02 consists of a
sigma-delta digital-to-analog converter (DAC), an analog
smoothing filter, a programmable gain amplifier, and a differen-
tial output amplifier.
DAC
The AD28msp02’s sigma-delta DAC implements digital filters
and a sigma-delta modulator with the same characteristics as the
filters and modulator of the ADC. The DAC consists of a digital
high-pass filter, an anti-imaging interpolation filter, and a digital
sigma-delta modulator.
The DAC receives 16-bit samples from the host DSP processor
via AD28msp02’s serial port at an 8 kHz rate. If the host pro-
cessor fails to write a new value to the serial port, the existing
(previous) data is read again. The data stream is filtered first by
the DAC’s high-pass filter and then by the anti-imaging interpo-
lation filter. These filters have the same characteristics as the
ADC’s anti-aliasing decimation filter and digital high-pass filter.
The output of the interpolation filter is fed to the DAC’s digital
sigma-delta modulator, which converts the 16-bit data to 1-bit
samples at a 1.0 MHz rate. The modulator noise-shapes the sig-
nal such that errors inherent to the process are minimized in the
passband of the converter. The bit stream output of the sigma-
delta modulator is fed to the AD28msp02’s analog smoothing
filter where it is converted to an analog voltage.
High-Pass Filter
The digital high-pass filter of the AD28msp02’s DAC has the
same characteristics as the high-pass filter of the ADC. The
high-pass filter removes frequency components at the low end of
the spectrum; it attenuates signal energy below the passband of
the converter. The DAC’s high-pass filter can be bypassed by
setting the DABY bit (Bit 2) of the AD28msp02’s control
register.
The high-pass filter is a 4th-order elliptic filter with a passband
cutoff at 150 Hz. Stopband attenuation is 25 dB. This filter has
the following specifications:
Filter type:
4th-order high-pass elliptic IIR
Sample frequency:
8.0 kHz
Passband cutoff:
150.0 Hz
Passband ripple:
±
0.2 dB
Stopband cutoff:
100.0 Hz
Stopband ripple:
–25.00 dB
(Note that these specifications apply only to this filter, and not to the entire DAC.
The specifications can be used to perform further analysis of the exact characteris-
tics of the filter, for example using a digital filter design software package.)
Figure 3 shows the frequency response of the high-pass filter.
Interpolation Filter
The anti-imaging interpolation filter contains two stages. The
first stage is an IIR low-pass filter that interpolates the data rate
from 8 kHz to 40 kHz and removes images produced by the in-
terpolation process. The output of this stage is then interpolated
to 1.0 MHz and fed to the second stage, a sinc
4
digital filter that
attenuates images produced by the 40 kHz to 1.0 MHz inter-
polation process.
PIN DESCRIPTIONS
Pin Name
I/O/Z Function
VIN
NORM
I
Analog input to inverting terminal of
NORM input amplifier.
Output terminal of NORM amplifier.
Analog input to inverting terminal of
AUX input amplifier.
Output terminal of AUX amplifier.
Analog output from noninverting
terminal of differential output amplifier.
Analog output from inverting terminal of
differential output amplifier.
On-chip bandgap voltage reference
(2.5 V
±
10%).
Master clock input; frequency must
equal 13.0 MHz to guarantee listed
specifications.
Serial clock used to clock data or control
bits to and from the serial port
(SPORT). The frequency of SCLK is
equal to the frequency of the master
clock (MCLK) divided by 5. SCLK is
3-stated when CS is low.
Serial data input of SPORT. Both data
and control information are input on
this pin. Input at SDI is ignored when
CS is low.
O/Z Serial data output of SPORT. Both data
and control information are output on
this pin. SDO is 3-stated when CS is
low.
I
Framing signal for SDI serial transfers.
Input at SDIFS is ignored when CS is
low.
O/Z
Framing signal for SDO serial transfers.
SDOFS is 3-stated when CS is low.
I
Configures AD28msp02 for either data
or control information transfers (via
SPORT).
I
Active-high chip select. Can be used to
3-state the SPORT interface; when CS
is low, the SCLK, SDO, and SDOFS
outputs are 3-stated and the SDI and
SDIFS inputs are ignored. If CS is de-
asserted during a serial data transfer, the
16-bit word being transmitted is lost.
I
Active low reset signal; resets Control
Register and clears digital filters.
RESET
does not 3-state the SPORT outputs
(SCLK, SDO, SDOFS).
Analog supply voltage; nominal +5 V.
Analog ground.
Digital supply voltage; nominal +5 V.
Digital ground.
VFB
NORM
VIN
AUX
O
I
VFB
AUX
VOUT
P
O
O
VOUT
N
O
V
REF
O
MCLK
I
SCLK
O/Z
SDI
I
SDO
SDIFS
SDOFS
DATA/
CNTRL
CS
RESET
V
CC
GND
A
V
DD
GND
D
相關PDF資料 |
PDF描述 |
|---|---|
| AD28MSP02KN | Voiceband Signal Port |
| AD28MSP02KR | ECONOLINE: RD & RC - Dual Output from a Single Input Rail- 1kVDC & 2kVDC Isolation- Power Sharing on Output- Custom Solutions Available- UL94V-0 Package Material- Efficiency to 86% |
| AD2S100 | AC Vector Processor |
| AD2S100AP | AC Vector Processor |
| AD2S105 | Three-Phase Current Conditioner |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD28MSP02KN | 制造商:AD 制造商全稱:Analog Devices 功能描述:Voiceband Signal Port |
| AD28MSP02KR | 制造商:AD 制造商全稱:Analog Devices 功能描述:Voiceband Signal Port |
| AD28MSP500CHIPSET | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:Telecommunication IC |
| AD-28PL-24DIP | 制造商:ICE TECHNOLOGY 功能描述:IC ADAPTER, 28-PLCC TO 24-DIP, Convert From:28-PLCC, Convert To:24-DIP, No. of C |
| AD-28SO-28DIP | 制造商:ICE TECHNOLOGY 功能描述:General memory microcontroller and logi |
發布緊急采購，3分鐘左右您將得到回復。