- 您現在的位置：買賣IC網 > PDF目錄373862 > AD1954YST (ANALOG DEVICES INC) RESISTOR PDF資料下載
參數資料
| 型號： | AD1954YST |
| 廠商： | ANALOG DEVICES INC |
| 元件分類： | 消費家電 |
| 英文描述： | RESISTOR |
| 中文描述： | SPECIALTY CONSUMER CIRCUIT, PQFP48 |
| 封裝： | MS-026BBC, PLASTIC, LQFP-48 |
| 文件頁數： | 30/36頁 |
| 文件大?。?/td> | 1470K |
| 代理商： | AD1954YST |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁當前第30頁第31頁第32頁第33頁第34頁第35頁第36頁
AD1954
–30–
ANALOG OUTPUTSECTION
Figure 21 shows the block diagram of the analog output section.
A series of current sources are controlled by a digital
-
modu-
lator. Depending on the digital code from the modulator, each
current source is connected to the summing junction of either a
positive I-to-V converter or a negative I-to-V converter. Two extra
current sources that push instead of pull are added to set the
midscale common-mode voltage.
SWITCHED CURRENT
SOURCES
OUT+
OUT–
I
REF
I
REF
– DIG_IN
I
REF
+ DIG_IN
VREF IN
FROM DIGITAL
-
MODULATOR
(DIG_IN)
BIAS
I
REF
Figure 21. Internal DAC Analog Architecture
All current sources are derived from the VREF input pin. The
gain of the AD1954 is directly proportional to the magnitude of
the current sources, and therefore the gain of the AD1954 is pro-
portional to the voltage on the VREF pin. With VREF set to 2.5 V,
the gain of the AD1954 is set to provide signal swings of 2 V rms
differential (1 V rms from each pin). This is the recommended
operating condition.
When the AD1954 is used to drive an audio power amplifier and
the compression feature is being used, the VREF voltage should
then be derived by dividing down the supply of the amplifier.
This sets a fixed relationship between the digital signal level
(which is the only information available to the digital compres-
sor) and the full-scale output of the amplifier (just prior to the
onset of clipping). For example, if the amplifier power supply
drops by 10%, then the VREF input to the amplifier will also
drop by 10%, which will reduce the analog output signal swing
by 10%. The compressor will therefore be effective in preventing
clipping, regardless of any variation in amplifier supply voltage.
Since the VREF input effectively multiplies the signal, care must
be taken to ensure that no ac signals appear on this pin. This
can be accomplished by using a large decoupling capacitor in
the VREF external resistive divider circuit. If the VREF signal is
derived by dividing the 5 V analog supply, then the time constant
of the divider must effectively filter any noise on the supply. If
the VREF signal is derived from an unregulated power amplifier
supply, then the time constant must be longer, since the ripple on
the amplifier supply voltage will presumably be greater than in
the case of the 5 V supply.
The AD1954 should be used with an external third order filter
on each output channel. The circuit shown in Figures 22, 23, and
24 combine a third order filter and a single-ended-to-differential
converter in the same circuit. The values used in the main channel
(Figure 22) are for a 100 kHz Bessel filter, and those used in the
subwoofer channel (Figure 23) result in a 10 kHz Bessel filter.
1.50k
3.01k
2.80k
2.7nF
499
1.00k
806
1nF
820pF
270pF
2.2nF
549
– INPUT
+ INPUT
OUT
Figure 22. Recommended External Analog Filter
for Main Channel
3.01k
11k
56nF
1.5k
15nF
5.62k
5.62k
27nF
6.8nF
220nF
604
– INPUT
+ INPUT
OUT
560nF
270nF
68pF
150pF
2.2nF
11k
Figure 23. Recommended External Analog Filter
for Subchannel
The lower frequency filter is used on the subwoofer output because
there is no digital interpolation filter used in the subwoofer signal
path. When calculating the resistor values for the filter, it is impor-
tant to take into account the output resistance of the AD1954,
which is nominally 60
. For best distortion performance, 1% resis-
tors should be used. The reason for this is that the single-ended
performance of the AD1954 is about 80 dB. The degree to which
the single-ended distortion cancels in the final output is determined
by the common-mode rejection of the external analog filter, which in
turn depends on the tolerance of the components used in the filter.
The sub output of the AD1954 has a lower drive strength than
the left and right output pins (±0.25 mA peak versus ±0.5 mA
peak for the left and right outputs). For this reason, it is best to
use higher resistor values in the external sub filter.
Figure 24 shows a recommended filter design for the subwoofer
pins used as a full bandwidth channel in a custom designed pro-
gram. This design is also a 100 kHz Bessel filter.
3.01k
11k
56nF
1.5k
5.62k
27nF
150pF
68pF
2.2nF
604
– INPUT
+ INPUT
OUT
11k
5.62k
Figure 24. Recommended External Analog Filter for
Full Bandwidth Signals on the Subchannel Output
For best performance, a large (>10 μF) capacitor should be con-
nected between the FILTCAP pin and analog ground. This pin is
connected to an internal node in the bias generator, and by add-
ing an external capacitance to this pin, the thermal noise of the
left/right channels is minimized. The sub channel is not affected
by this connection.
REV. A
相關PDF資料 |
PDF描述 |
|---|---|
| AD1954YSTRL | Hook-Up Wire; Conductor Size AWG:12; No. Strands x Strand Size:65 x 30; Jacket Color:Yellow; Approval Bodies:UL, CSA; Approval Categories:UL AWM Style 1015, CSA Type TEW, JQA-F-, Passes VW-1 Flame Test; Conductor Material:Copper RoHS Compliant: Yes |
| AD1954YSTRL7 | 16-bit fixed point DSP with Flash |
| AD1955YRSRL | SPACER NYLON #2 SCREW 15/16,1 |
| AD1955YRS | High Performance Multibit DAC with SACD Playback |
| AD1955 | High Performance Multibit DAC with SACD Playback |
相關代理商/技術參數 |
參數描述 |
|---|---|
| AD1954YSTRL | 制造商:Analog Devices 功能描述:DAC 3-CH Delta-Sigma 24-bit 48-Pin LQFP T/R |
| AD1954YSTRL7 | 制造商:AD 制造商全稱:Analog Devices 功能描述:SigmaDSP⑩ 3-Channel, 26-Bit Signal Processing DAC |
| AD1954YSTZ | 功能描述:IC DAC AUDIO 3CHAN 26BIT 48LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:SigmaDSP® 標準包裝:1 系列:- 設置時間:4.5µs 位數:12 數據接口:串行，SPI? 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:- 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-SOICN 包裝:剪切帶 (CT) 輸出數目和類型:1 電壓，單極；1 電壓，雙極 采樣率（每秒）:* 其它名稱:MCP4921T-E/SNCTMCP4921T-E/SNRCTMCP4921T-E/SNRCT-ND |
| AD1954YSTZRL | 功能描述:IC DAC AUDIO 3CHAN 26BIT 48LQFP RoHS:是 類別:集成電路 (IC) >> 數據采集 - 數模轉換器 系列:SigmaDSP® 標準包裝:47 系列:- 設置時間:2µs 位數:14 數據接口:并聯 轉換器數目:1 電壓電源:單電源 功率耗散（最大）:55µW 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:28-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:28-SSOP 包裝:管件 輸出數目和類型:1 電流，單極；1 電流，雙極 采樣率（每秒）:* |
| AD1954YSZ | 制造商:Analog Devices 功能描述:DAC 3-CH Delta-Sigma 24-bit 44-Pin MQFP |
發布緊急采購，3分鐘左右您將得到回復。