- 您現在的位置：買賣IC網 > PDF目錄375142 > A5347CA (Allegro MicroSystems, Inc.) KPT07A22-55SF80 PDF資料下載
參數資料
| 型號： | A5347CA |
| 廠商： | Allegro MicroSystems, Inc. |
| 英文描述： | KPT07A22-55SF80 |
| 中文描述： | 煙霧報警器與互連和定時器 |
| 文件頁數： | 5/8頁 |
| 文件大小： | 91K |
| 代理商： | A5347CA |
TYPICAL APPLICATION
Alarm Circuitry.
If smoke is detected, the
oscillator period changes to 40 ms and the
horn is enabled. The horn output is typically
160 ms ON, 80 ms OFF. During the OFF
time, smoke is again checked and will inhibit
further alarm output if smoke is not sensed.
During smoke conditions the low battery
alarm is inhibited and the LED is driven at a
1 Hz rate.
Sensitivity Adjust.
The detector sensitivity
to smoke is set internally by a voltage divider
connected between V
DD
and V
SS
. The
sensitivity can be externally adjusted to the
individual characteristics of the ionization
chamber by connecting a resistor between
pin 13 and V
DD
, or between pin 13 and V
SS
.
Low Battery.
The low battery threshold is
set internally by a voltage divider connected
between V
DD
and V
SS
. The threshold can be
increased by connecting a resistor between
pin 3 and V
DD
. The threshold can be de-
creased by connecting a resistor between
pin 3 and V
SS
. The battery voltage level is
checked every 40 seconds during the 10 mA,
10 ms LED pulse. If an LED is not used, it
should be replaced with an equivalent
resistor (typically 500
to 1000
) such that
the battery loading remains at 10 mA.
Timer.
An internal timer is provided that can
be used in various configurations to allow for
a period of reduced smoke detector sensitiv-
ity (“hush”). When a high-to-low transition
occurs at pin 1, the internal timer is reset,
the timer mode enabled, and the circuit reset
to a no alarm condition. The LED will flash
at a 10 second rate. If the level of smoke is
increased such that the reduced sensitivity
level is reached, the device will go into the
alarm condition. The timer, however, will
continue to completion of the nominal 10-1/4
minute period (368 clock cycles). If the timer
mode is not used, pin 1 should be tied low.
I/O.
A connection is provided at pin 2 to allow multiple smoke detec-
tors to be commoned. If any single unit detects smoke (I/O is driven
high), all connected units will sound their associated horns after a
nominal 3 second delay. The LED is suppressed when an alarm is
signaled from an interconnected unit.
Testing.
On power up, all internal counters are reset. Internal test
circuitry allows for low battery check by holding pins 8 and 12 low
during power up, then reducing V
DD
and monitoring HORN
1
(pin 10).
All functional tests can be accelerated by driving pin 12 with a 2 kHz
square wave. The 10 ms strobe period must be maintained for proper
operation of the comparator circuitry.
TIMER
MODE
TO
OTHER
UNITS
NOTE
1
NOTE
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
LOGIC
OSC. &
TIMING
HORN
DRIVER
V
DD
Dwg. EC-005-2
V
SS
9 V
NOTE 2
200 k
5
2
200
8.2 M
1
μ
F
0.1
μ
F
1
2
PUSH
TO
TEST
0.001
μ
F
330
NOTE 4
NOTE 1: Use an external resistor to adjust sensitivity for a particular smoke
chamber.
NOTE 2: Select resistor to reduce sensitivity during timer mode.
NOTE 3: A resistor to ground or V
DD
may be added to this pin to modify low battery
voltage threshold.
NOTE 4: Reverse battery protection must be supplied externally.
5347
SMOKE DETECTOR
with INTERCONNECT
and TIMER
相關PDF資料 |
PDF描述 |
|---|---|
| A5348CA | SMOKE DETECTOR WITH INTERCONNECT AND TIMER |
| A5349CA | AC SMOKE DETECTOR WITH INTERCONNECT AND TIMER |
| A5350CA | SMOKE DETECTOR WITH INTERCONNECT |
| A5354CA | SMOKE DETECTOR WITH INTERCONNECT |
| A5355CA | SMOKE DETECTOR WITH INTERCONNECT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| A5348 | 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:The A5348 is a low-current, BiCMOS circuit providing all of the required features for an ionization-type smoke detector. |
| A5348CA | 功能描述:IC SMOKE DETECTOR ION 16-DIP RoHS:否 類別:集成電路 (IC) >> 接口 - 傳感器和探測器接口 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:74 系列:- 類型:觸控式傳感器 輸入類型:數字 輸出類型:數字 接口:JTAG，串行 電流 - 電源:100µA 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:管件 |
| A5348CA-T | 功能描述:IC SMOKE DETECTOR ION 16-DIP RoHS:是 類別:集成電路 (IC) >> 接口 - 傳感器和探測器接口 系列:- 其它有關文件:Automotive Product Guide 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:74 系列:- 類型:觸控式傳感器 輸入類型:數字 輸出類型:數字 接口:JTAG，串行 電流 - 電源:100µA 安裝類型:表面貼裝 封裝/外殼:20-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:20-TSSOP 包裝:管件 |
| A5349CA | 制造商:ALLEGRO 制造商全稱:Allegro MicroSystems 功能描述:AC SMOKE DETECTOR WITH INTERCONNECT AND TIMER |
| A53506 | 制造商:n/a 功能描述:Ships in 2 days |
發布緊急采購，3分鐘左右您將得到回復。