- 您現在的位置：買賣IC網 > PDF目錄57457 > A3340LLHLT-T MAGNETIC FIELD SENSOR-HALL EFFECT, 0.5-5mT, 270-500mV, RECTANGULAR, SURFACE MOUNT PDF資料下載
參數資料
| 型號： | A3340LLHLT-T |
| 元件分類： | 磁阻傳感器 |
| 英文描述： | MAGNETIC FIELD SENSOR-HALL EFFECT, 0.5-5mT, 270-500mV, RECTANGULAR, SURFACE MOUNT |
| 封裝： | LEAD FREE, SOT-23W, 3-PIN |
| 文件頁數： | 7/9頁 |
| 文件大?。?/td> | 257K |
| 代理商： | A3340LLHLT-T |
Chopper-Stabilized, Precision Hall-Effect Switch
A3340
7
Allegro MicroSystems, Inc.
115 Northeast Cutoff, Box 15036
Worcester, Massachusetts 01615-0036 (508) 853-5000
www.allegromicro.com
Dwg. EH-012
REG
X
SAMPLE
&
HOLD
+V CC
B
–VHALL
+VHALL
+B
0
FL UX DE NS IT Y
0
B
CC
V
B
+V
OP
RP
O
U
TP
U
T
VO
L
T
AG
E
V OUT(S AT)
SUPPLY
OUTPUT
Dwg. EH-013
0.1 μF
SUPPLY
X
PTCT
VCC
GND
VOUT
Chopper-Stabilized Technique. The Hall element can be
considered as a resistor array similar to a Wheatstone bridge. A
large portion of the offset is a result of the mismatching of these
resistors. These devices use a proprietary dynamic offset cancel-
lation technique, with an internal high-frequency clock to reduce
the residual offset voltage of the Hall element that is normally
caused by device overmolding, temperature dependencies, and
thermal stress. The chopper-stabilizing technique cancels the
mismatching of the resistor circuit by changing the direction of
the current flowing through the Hall plate using CMOS switches
and Hall voltage measurement taps, while maintaing the Hall-
voltage signal that is induced by the external magnetic flux. The
signal is then captured by a sample-andhold circuit and further
processed using low-offset bipolar circuitry. This technique pro-
duces devices that have an extremely stable quiescent Hall output
voltage, are immune to thermal stress, and have precise recover-
ability after temperature cycling. This technique will also slightly
degrade the device output repeatability. A relatively high sampling
frequency is used in order that faster signals can be processed.
More detailed descriptions of the circuit operation can be found
in: Technical Paper STP 97-10, Monolithic Magnetic Hall Sensor
Using Dynamic Quadrature Offset Cancellation and Technical
Paper STP 99-1, Chopper-Stabilized Amplifiers With A Track-and-
Hold Signal Demodulator. Operation. The output of these devices
switches high (turns off) when a magnetic field (south pole)
perpendicular to the Hall sensor exceeds the operate point thresh-
old (BOP). When the magnetic field is reduced below the release
point (BRP), the device output goes low (turns on). After turn-on,
the output is capable of sinking 25 mA and the output voltage is
VOUT(SAT). The difference in the magnetic operate and release
points is the hysteresis (Bhys) of the device. This built-in hyster-
esis allows clean switching of the output even in the presence of
external mechanical vibration and electrical noise. Applications.
It is strongly recommended that an external bypass capacitor be
connected (in close proximity to the Hall sensor) between the
supply and ground of the device to reduce both external noise and
noise generated by the chopperstabilization technique.
The simplest form of magnet that will operate these devices is a
ring magnet. Other methods of operation, such as linear magnets,
are possible. Extensive applications information on magnets and
Hall-effect sensors is also available in Application Note 27701, or
at www.allegromicro.com.
FUNCTIONAL DESCRIPTION
相關PDF資料 |
PDF描述 |
|---|---|
| A3422LKA | MAGNETIC FIELD SENSOR-HALL EFFECT, -85-85mT, 0.21-0.50V, RECTANGULAR, THROUGH HOLE MOUNT |
| A3507EU | MAGNETIC FIELD SENSOR-HALL EFFECT, 35mT, 0.50-4.80V, RECTANGULAR, THROUGH HOLE MOUNT |
| A3507EU | MAGNETIC FIELD SENSOR-HALL EFFECT, 3.5mT, RECTANGULAR |
| A3507LUA | MAGNETIC FIELD SENSOR-HALL EFFECT, 35mT, 4.50-4.80V, RECTANGULAR, THROUGH HOLE MOUNT |
| A3508EUA | MAGNETIC FIELD SENSOR-HALL EFFECT, 35mT, 4.50-4.80V, RECTANGULAR, THROUGH HOLE MOUNT |
相關代理商/技術參數 |
參數描述 |
|---|---|
| A3340LUA-T | 功能描述:IC HALL EFFECT SWITCH 3-SIP RoHS:是 類別:傳感器，轉換器 >> 磁性 - 霍爾效應，數字式開關，線性，羅盤 (IC) 系列:- 標準包裝:1 系列:- 傳感范圍:20mT ~ 80mT 類型:旋轉 電源電壓:4.5 V ~ 5.5 V 電流 - 電源:15mA 電流 - 輸出（最大）:- 輸出類型:數字式，PWM，8.5 位串行 特點:可編程 工作溫度:-40°C ~ 150°C 封裝/外殼:20-SSOP（0.209"，5.30mm 寬） 供應商設備封裝:20-SSOP 包裝:Digi-Reel® 其它名稱:AS5132-HSST-500DKR |
| A3342B | 制造商: 功能描述: 制造商:New Japan Radio Co Ltd (NJR/JRC) 功能描述: 制造商:undefined 功能描述: |
| A33463-000 | 功能描述:可復位保險絲 RoHS:否 制造商:TE Connectivity / Raychem 電流額定值: 電阻:0.08 Ohms (max) 最大直流電壓: 保持電流:2.5 A 安裝風格:Through Hole 端接類型: 跳閘電流:5 A 引線間隔: 系列:RXEF 工作溫度范圍:+ 85 C |
| A33466-000 | 制造商:TE Connectivity 功能描述:VARISTOR 200V 7MM STRAIGHT LEAD 制造商:TE Connectivity 功能描述:VARISTOR 200V 1.75KA DISC 7MM |
| A33485-000 | 制造商:TE Connectivity 功能描述:VARISTOR 680V 6KA DISC 14MM 制造商:TE Connectivity 功能描述:VARISTOR 680VDC 14MM 10% LEADED |
發布緊急采購，3分鐘左右您將得到回復。