參數資料
    型號: A29L320
    廠商: AMIC Technology Corporation
    英文描述: 4M X 8 Bit / 2M X 16 Bit CMOS 3.3 Volt-only, Boot Sector Flash Memory
    中文描述: 4米× 8位/ 2米× 16位CMOS 3.3伏只,引導扇區閃存
    文件頁數: 13/44頁
    文件大小: 588K
    代理商: A29L320
    A29L320 Series
    PRELIMINARY
    (September, 2005, Version 0.0)
    12
    AMIC Technology, Corp.
    Sector Protection/Unprotection
    The hardware sector protection feature disables both
    program and erase operations in any sector. The hardware
    sector unprotection feature re-enables both program and
    erase operations in previously protected sectors.
    It is possible to determine whether a sector is protected or
    unprotected. See “Autoselect Mode” for details.
    Sector protection / unprotection can be implemented via two
    methods. The primary method requires VID on the
    RESET
    pin only, and can be implemented either in-system or
    via programming equipment. Figure 2 shows the algorithm
    and the Sector Protect / Unprotect Timing Diagram illustrates
    the timing waveforms for this feature. This method uses
    standard microprocessor bus cycle timing. For sector
    unprotect, all unprotected sectors must first be protected
    prior to the first sector unprotect write cycle. The alternate
    method
    must
    be
    implemented
    equipment. The procedure requires a high voltage (V
    ID
    ) on
    address pin A9 and the control pins.
    The device is shipped with all sectors unprotected.
    It is possible to determine whether a sector is protected or
    unprotected. See "Autoselect Mode" for details.
    using
    programming
    Hardware Data Protection
    The requirement of command unlocking sequence for
    programming or erasing provides data protection against
    inadvertent writes (refer to the Command Definitions table).
    In addition, the following hardware data protection measures
    prevent accidental erasure or programming, which might
    otherwise be caused by spurious system level signals during
    V
    CC
    power-up transitions, or from system noise. The device
    is powered up to read array data to avoid accidentally writing
    data to the array.
    Write Pulse "Glitch" Protection
    Noise pulses of less than 5ns (typical) on
    OE
    ,
    CE
    or
    WE
    do not initiate a write cycle.
    Logical Inhibit
    Write cycles are inhibited by holding any one of
    OE
    =V
    IL
    ,
    CE
    = V
    IH
    or
    WE
    = V
    IH
    . To initiate a write cycle,
    CE
    and
    WE
    must be a logical zero while
    OE
    is a logical one.
    Power-Up Write Inhibit
    If
    WE
    =
    CE
    = V
    IL
    and
    OE
    = V
    IH
    during power up, the
    device does not accept commands on the rising edge of
    WE
    . The internal state machine is automatically reset to
    reading array data on the initial power-up.
    Temporary Sector Unprotect
    This feature allows temporary unprotection of previous
    protected sectors to change data in-system. The Sector
    Unprotect mode is activated by setting the
    RESET
    pin to V
    ID
    .
    During this mode, formerly protected sectors can be
    programmed or erased by selecting the sector addresses.
    Once V
    ID
    is removed from the
    RESET
    pin, all the previously
    protected sectors are protected again. Figure 1 shows the
    algorithm, and the Temporary Sector Unprotect diagram
    shows the timing waveforms, for this feature.
    START
    RESET = V
    ID
    (Note 1)
    Perform Erase or
    Program Operations
    RESET = V
    IH
    Temporary Sector
    Unprotect
    Completed (Note 2)
    Notes:
    1. All protected sectors unprotected.
    2. All previously protected sectors are protected once again.
    Figure 1. Temporary Sector Unprotect Operation
    相關PDF資料
    PDF描述
    A29L320TG-70 4M X 8 Bit / 2M X 16 Bit CMOS 3.3 Volt-only, Boot Sector Flash Memory
    A29L320TG-70F 4M X 8 Bit / 2M X 16 Bit CMOS 3.3 Volt-only, Boot Sector Flash Memory
    A29L320TG-70I 4M X 8 Bit / 2M X 16 Bit CMOS 3.3 Volt-only, Boot Sector Flash Memory
    A29L320TG-70IF 4M X 8 Bit / 2M X 16 Bit CMOS 3.3 Volt-only, Boot Sector Flash Memory
    A29L320TG-70U 4M X 8 Bit / 2M X 16 Bit CMOS 3.3 Volt-only, Boot Sector Flash Memory
    相關代理商/技術參數
    參數描述
    A29L320A 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:4M X 8 Bit / 2M X 16 Bit CMOS 3.0 Volt-only, Boot Sector Flash Memory
    A29L320ATV-70F 制造商:AMIC Technology 功能描述:IC SM FLASH 32MB 3V TOP BOOT 制造商:AMIC Technology 功能描述:IC, SM, FLASH, 32MB, 3V, TOP BOOT
    A29L320AUG-120 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:4M X 8 Bit / 2M X 16 Bit CMOS 3.0 Volt-only, Boot Sector Flash Memory
    A29L320AUG-120F 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:4M X 8 Bit / 2M X 16 Bit CMOS 3.0 Volt-only, Boot Sector Flash Memory
    A29L320AUG-120I 制造商:AMICC 制造商全稱:AMIC Technology 功能描述:4M X 8 Bit / 2M X 16 Bit CMOS 3.0 Volt-only, Boot Sector Flash Memory