- 您現在的位置：買賣IC網 > PDF目錄25515 > 951901AF (INTEGRATED DEVICE TECHNOLOGY INC) 133.34 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 PDF資料下載
參數資料
| 型號： | 951901AF |
| 廠商： | INTEGRATED DEVICE TECHNOLOGY INC |
| 元件分類： | 時鐘產生/分配 |
| 英文描述： | 133.34 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 封裝： | 0.300 INCH, GREEN, MO-118, SSOP-48 |
| 文件頁數： | 6/21頁 |
| 文件大?。?/td> | 206K |
| 代理商： | 951901AF |
14
ICS951901
0670B—07/15/04
Fig. 1
Shared Pin Operation -
Input/Output Pins
The I/O pins designated by (input/output) on the ICS951901
serve as dual signal functions to the device. During initial
power-up, they act as input pins. The logic level (voltage)
that is present on these pins at this time is read and
stored into a 5-bit internal data latch. At the end of Power-
On reset, (see AC characteristics for timing values), the
device changes the mode of operations for these pins to
an output function. In this mode the pins produce the
specified buffered clocks to external loads.
To program (load) the internal configuration register for
these pins, a resistor is connected to either the VDD
(logic 1) power supply or the GND (logic 0) voltage
potential. A 10 Kilohm (10K) resistor is used to provide
both the solid CMOS programming voltage needed during
the power-up programming period and to provide an
insignificant load on the output clock during the subsequent
operating period.
Via to
VDD
Clock trace to load
Series Term. Res.
Programming
Header
Via to Gnd
Device
Pad
2K
W
8.2K
W
Figure 1 shows a means of implementing this function
when a switch or 2 pin header is used. With no jumper is
installed the pin will be pulled high. With the jumper in
place the pin will be pulled low. If programmability is not
necessary, than only a single resistor is necessary. The
programming resistors should be located close to the
series termination resistor to minimize the current loop
area. It is more important to locate the series termination
resistor close to the driver than the programming resistor.
相關PDF資料 |
PDF描述 |
|---|---|
| 951901AFLFT | 133.34 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 951 | WIRE TERMINAL |
| 952001AF | 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 952001AFLF | 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
| 952001AFLFT | 200 MHz, PROC SPECIFIC CLOCK GENERATOR, PDSO48 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 951901AFLF | 制造商:Integrated Device Technology Inc 功能描述:Programmable PLL Frequency Generator Dual 48-Pin SSOP Tube |
| 951901AFLFT | 制造商:Integrated Device Technology Inc 功能描述:Programmable PLL Frequency Generator Dual 48-Pin SSOP T/R |
| 951902 | 制造商:Weidmuller 功能描述:WPG-M25, CABLE GLAND, PA,BLA -EA - Bulk |
| 951903 | 制造商:Weidmuller 功能描述:WPG-M32, CABLE GLAND, PA,BLA -EA - Bulk |
| 951904 | 制造商:Weidmuller 功能描述:WPG-M40, CABLE GLAND, PA,BLA -EA - Bulk |
發布緊急采購，3分鐘左右您將得到回復。