- 您現在的位置：買賣IC網 > PDF目錄24772 > 935073600551 (NXP SEMICONDUCTORS) 8-BIT, MICROCONTROLLER, PQFP44 PDF資料下載
參數資料
| 型號： | 935073600551 |
| 廠商： | NXP SEMICONDUCTORS |
| 元件分類： | 微控制器/微處理器 |
| 英文描述： | 8-BIT, MICROCONTROLLER, PQFP44 |
| 封裝： | 10 X 10 X 1.75 MM, PLASTIC, QFP-44 |
| 文件頁數： | 50/80頁 |
| 文件大?。?/td> | 446K |
| 代理商： | 935073600551 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁當前第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁
1997 Dec 15
54
Philips Semiconductors
Product specication
8-bit microcontrollers
P83C524; P80C528; P83C528
Notes to the DC characteristics
1. Conditions for:
a) The operating supply current is measured with all output pins disconnected; XTAL1 driven with tr =tf = 5 ns;
VIL =VSS +0.5 V; VIH =VDD 0.5 V; XTAL2 not connected; EA = RST = Port 0 = P1.6 = P1.7 = VDD;
the WDT is disabled (by the external RESET).
2. Conditions for:
a) The Idle mode supply current is measured with all output pins disconnected; XTAL1 driven with tr =tf = 5 ns;
VIL =VSS +0.5 V; VIH =VDD 0.5 V; XTAL2 not connected; the WDT is disabled; EA = RST = VSS;
Port 0 = P1.6 = P1.7 = VDD.
3. Conditions for:
a) The Power-down current is measured with all output pins disconnected; XTAL2 not connected;
WDT is disabled; EA = RST = XTAL1 = VSS; Port 0 = P1.6 = P1.7 = VDD.
4. Capacitive loading on Port 0 and Port 2 may cause spurious noise pulses to be superimposed on the LOW level
output voltage of ALE, Port 1 and Port 3. The noise is due to external bus capacitance discharging into the Port 0
and Port 2 pins when these pins make a HIGH-to-LOW transition during bus operations. In the worst cases
(capacitive loading
> 100pF), the noise pulse on the ALE line may exceed 0.8 V. In such cases it may be desirable
to qualify ALE with a Schmitt Trigger, or use an address latch with a Schmitt Trigger STROBE input.
5. Capacitive loading on Port 0 and Port 2 may cause the HIGH level output voltage on ALE and PSEN to momentarily
fall below the 0.9 VDD specification when the address bits are stabilizing.
6. The input threshold voltage of P1.6 and P1.7 (SIO1) meets the I2C specification, so a voltage below 0.3 VDD will be
recognized as a logic 0 while an input above 0.7 VDD will be recognized as a logic 1.
7. Under steady state (non-transient) conditions, IOL must be externally limited as follows:
a) Maximum IOL per port pin:10 mA.
b) Maximum IOL per 8-bit port:- Port 0: 26 mA; Ports 1, 2 and 3: 15 mA.
c) Maximum total IOL for all output pins: 71 mA. If IOL exceeds the test condition,
VOL may exceed the related specification.
d) Pins are not guaranteed to sink current greater than the listed test conditions.
8. IDD max. at other frequencies can be derived from Fig.26 where f is the external oscillator frequency in MHz;
IDD max. is given in mA.
VOH1
HIGH level output voltage
Port0in in external bus mode,
ALE, PSEN, RST
IOH = 800 A;
VDD =5V± 10%
IOH = 300 A;
IOH = 80 A; note 5
2.4
0.75VDD
0.9VDD
V
RRST
RST pull
down resistor
50
150
k
CI/O
I/O pin capacitance
test frequency = 1 MHz;
Tamb =25 °C
10
pF
SYMBOL
PARAMETER
CONDITIONS
MIN.
MAX.
UNIT
相關PDF資料 |
PDF描述 |
|---|---|
| 935222940112 | 8-BIT, 24 MHz, MICROCONTROLLER, PQCC44 |
| 935208520112 | 8-BIT, 16 MHz, MICROCONTROLLER, PDIP40 |
| 935208560557 | 8-BIT, 16 MHz, MICROCONTROLLER, PQFP44 |
| 935264169557 | 8-BIT, MROM, 16 MHz, MICROCONTROLLER, PQFP44 |
| 935208580557 | 8-BIT, 16 MHz, MICROCONTROLLER, PQFP44 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 935079-000 | 制造商:TE Connectivity 功能描述:55A1841-16-MST4-9CS2275 - Cable Rools/Shrink Tubing |
| 935087-000 | 制造商:TE Connectivity 功能描述:301A511-51-05/164-0 - Bulk |
| 935087N001 | 制造商:TE Connectivity 功能描述:301A511-51-05/164-CS7092 制造商:TE Connectivity 功能描述:301A511-51-05/164-CS7092 - Bulk |
| 9350DC-200-0GZZZA | 制造商:Siemens 功能描述: |
| 9350DC-200-0ZZZTA | 制造商:Siemens 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。