![](http://datasheet.mmic.net.cn/50000/92HD87B1A5NDGXYYX8_datasheet_1923403/92HD87B1A5NDGXYYX8_37.png)
IDT CONFIDENTIAL
37
V 0.995 01/11
2009 INTEGRATED DEVICE TECHNOLOGY, INC.
92HD87
SINGLE CHIP PC AUDIO SYSTEM, CODEC+STEREO SPEAKER AMPLIFIER+CAPLESS HP+LDO
4.75V
30
mA
D2 Didd
3.3V, 1.8V, 1.5V
7
mA
D2 Aidd
4.75V
15
mA
D3 (Beep enabled) Didd13
3.3V, 1.8V, 1.5V
2
mA
D3 (Beep enabled) Aidd13
4.75V
10
mA
D3 Didd13
3.3V, 1.8V, 1.5V
2
mA
D3 Aidd13
4.75V
5
mA
D3cold Didd13
3.3V, 1.8V, 1.5V
1
mA
D3cold Aidd13
4.75V
5
mA
Vendor D4 Didd
3.3V, 1.8V, 1.5V
0.4
mA
Vendor D4 Aidd
4.75V
5
mA
Vendor D5 Didd
3.3V, 1.8V, 1.5V
0.4
mA
Vendor D5 Aidd
4.75V
0.6
mA
One Stereo ADC Didd
3.3V, 1.8V, 1.5V
4
mA
One Stereo ADC Aidd
4.75
8
mA
One Stereo DAC Didd
3.3V, 1.8V, 1.5V
4
mA
One Stereo DAC Aidd
4.75V
6
mA
Voltage Reference Outputs
VREFOut14
All
-
0.5 X
AVdd
-V
VREFOut Drive
All
1.6
mA
VREFILT (VAG)
All
0.45 X
AVdd
V
Phased Locked Loop
PLL lock time
All
96
200
usec
PLL (or HD Audio Bit CLK) 24MHz clock
jitter
All
150
500
psec
ESD / Latchup
Latch-up
As described in JESD78A Class II
All
70
degC
ESD - Human Body Model
As described in JESD22-A114-B
All
2K
3K
V
Charged Device Model
As described in JESD22-C101
All
500
1K
V
1.Dynamic Range is the ratio of the full scale signal to the noise output with a -60dBFS signal as defined in AES17 as SNR in the
presence of signal and outlined in AES6id, measured “A weighted” over 20 Hz to 20 kHz bandwidth
2.Ratio of Full Scale signal to idle channel noise output is measured “A weighted” over a 20 Hz to a 20 kHz bandwidth.
(AES17-1991 Idle Channel Noise or EIAJ CP-307 Signal-to-noise Ratio).
3.THD+N ratio as defined in AES17 and outlined in AES6id,non-weighted, over 20 Hz to 20 kHz bandwidth.Results at the jack
are dependent on external components and will likely be 1 - 2dB worse.
4.Peak-to-Peak Ripple over Passband meets ± 0.125dB limits, 48 kHz or 44.1 kHz Sample Frequency. 1dB limit.
5.Peak-to-Peak Ripple over Passband meets ± 0.125dB limits, 48 kHz or 44.1 kHz Sample Frequency. 1dB limit.
6.Stop Band rejection determines filter requirements. Out-of-Band rejection determines audible noise.
7.The integrated Out-of-Band noise generated by the DAC process, during normal PCM audio playback, over a bandwidth 28.8
to 100 kHz, with respect to a 1 Vrms DAC output.
8.± 1dB limits for Line Output & 0 dB gain, at -20dBV
Parameter
Conditions
AVdd
Min
Typ
Max
Unit
Table 13. 92HD87 Analog Performance Characteristics