- 您現在的位置：買賣IC網 > PDF目錄364551 > 8XL58 LOW VOLTAGE CHMOS SINGLE-CHIP 8-BIT MICROCONTROLLERS PDF資料下載
參數資料
| 型號： | 8XL58 |
| 英文描述： | LOW VOLTAGE CHMOS SINGLE-CHIP 8-BIT MICROCONTROLLERS |
| 中文描述： | 低壓CHMOS單片8位微控制器 |
| 文件頁數： | 4/20頁 |
| 文件大?。?/td> | 284K |
| 代理商： | 8XL58 |
8XL52/54/58
PIN DESCRIPTIONS
V
CC
: Supply voltage.
V
SS
: Circuit ground.
Port 0: Port 0 is an 8-bit, open drain, bidirectional I/O
port. As an output port each pin can sink several
inputs. Port 0 pins that have 1’s written to them float,
and in that state can be used as high-impedance
inputs.
Port 0 is also the multiplexed low-order address and
data bus during accesses to external Program and
Data Memory. In this application it uses strong inter-
nal pullups when emitting 1’s, and can source and
sink several inputs.
Port 0 also receives the code bytes during OTP
ROM programming, and outputs the code bytes dur-
ing program verification. External pullup resistors are
required during program verification.
Port 1: Port 1 is an 8-bit bidirectional I/O port with
internal pullups. The Port 1 output buffers can drive
several inputs. Port 1 pins that have 1’s written to
them are pulled high by the internal pullups, and in
that state can be used as inputs. As inputs, Port 1
pins that are externally pulled low will source current
(I
IL
, on the data sheet) because of the internal pull-
ups.
In addition, Port 1 serves the functions of the follow-
ing special features of the 8XL5X:
Port Pin
Alternate Function
P1.0
T2 (External Count
Input to Timer/
Counter 2), Clock
Out
P1.1
T2EX (Timer/
Counter 2 Capture/
Reload Trigger and
Direction Control)
Port 1 receives the low-order address bytes during
OTP ROM programming and verifying.
Port 2: Port 2 is an 8-bit bidirectional I/O port with
internal pullups. The Port 2 output buffers can drive
several inputs. Port 2 pins that have 1’s written to
them are pulled high by the internal pullups, and in
that state can be used as inputs. As inputs, Port 2
pins that are externally pulled low will source current
(I
IL
, on the data sheet) because of the internal pull-
ups.
Port 2 emits the high-order address byte during
fetches from external Program Memory and during
accesses to external Data Memory that use 16-bit
addresses (MOVX
uses strong internal pullups when emitting 1’s. Dur-
ing accesses to external Data Memory that use 8-bit
addresses (MOVX
@
Ri), Port 2 emits the contents of
the P2 Special Function Register.
@
DPTR). In this application it
Some Port 2 pins receive the high-order address bits
during OTP ROM programming and program verifi-
cation.
Port 3: Port 3 is an 8-bit bidirectional I/O port with
internal pullups. The Port 3 output buffers can drive
several inputs. Port 3 pins that have 1’s written to
them are pulled high by the internal pullups, and in
that state can be used as inputs. As inputs, Port 3
pins that are externally pulled low will source current
(I
IL
, on the data sheet) because of the pullups.
Port 3 also serves the functions of various special
features of the MCS-51 Family, as listed below:
Port Pin
Alternate Function
P3.0
P3.1
P3.2
P3.3
P3.4
P3.5
P3.6
P3.7
RXD (serial input port)
TXD (serial output port)
INT0 (external interrupt 0)
INT1 (external interrupt 1)
T0 (Timer 0 external input)
T1 (Timer 1 external input)
WR (external data memory write strobe)
RD (external data memory read strobe)
RST: Reset input. A high on this pin for two machine
cycles while the oscillator is running resets the de-
vice. The port pins will be driven to their reset condi-
tion when a minimum V
IH2
voltage is applied wheth-
er the oscillator is running or not. An internal pull-
down resistor permits a power-on reset with only a
capacitor connected to V
CC
.
4
相關PDF資料 |
PDF描述 |
|---|---|
| 8XL52 | FUSE KIT, ASSORTED; Depth, external:165mm; Height:50mm; Width, external:260mm |
| A-1855-06111-UNILAP100E | INSTALLATION TESTER |
| A-1855-06211GB-UNILAP100XE | INSTALLATION TESTER |
| A-225 | Preamp， Non-Audio |
| A-2510-11000-00(SE102-1) | CHART RECORDER 1 CHANNEL DC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 8XLT12.5TAM/BLK)2UGRAAGPS | 功能描述:按鈕開關 8POS BLK P/B ASSY RoHS:否 制造商:C&K Components 觸點形式:2 NC - 2 NO 開關功能:ON ? OFF 電流額定值:4 A 電壓額定值 AC:12 V to 250 V 電壓額定值 DC:12 V to 50 V 功率額定值: 安裝風格:Through Hole 照明:Illuminated 照明顏色:None IP 等級:IP 40 端接類型:Solder 觸點電鍍:Silver 執行器:Square 蓋顏色: 封裝: 可燃性等級:UL 94 V-0 |
| 8XTA102UGRAAGPN | 功能描述:SWITCH ASSY 8 POS CUSTOM RoHS:否 類別:開關 >> 配件 系列:- 標準包裝:100 系列:- 其它名稱:886.0007886.0007-ND |
| 8Y1011-Z | 功能描述:SWITCH PUSHBUTTON SPDT 6A 125V RoHS:是 類別:開關 >> 按鈕 系列:8Y 標準包裝:1 系列:A16 類型:標準，發光式 電路:雙刀雙擲 開關功能:開-瞬時 額定電流:5A（AC） 額定電壓 - AC:125V 額定電壓 - DC:- 觸動器類型:方形，按鈕 顏色 - 致動器/蓋:黃 發光類型，顏色:LED，黃 發光電壓:12 VDC 安裝類型:前面板安裝 端接類型:焊接，快速連接 - 0.110"（2.8mm） 防護等級:IP65 - 防塵/防油/防水 特點:- 面板切口尺寸:圓形 - 直徑 16.00mm 包裝:散裝 工作溫度:-10°C ~ 55°C 機械壽命:2,000,000 次循環 電氣壽命:100,000 次循環 其它名稱:A165LAYM12D2 |
| 8Y10131121 | 制造商:NICOMATIC LP 功能描述:FEMALE CONNECTOR |
| 8Y1021-Z | 功能描述:SWITCH PUSHBUTTON SPDT 6A 125V RoHS:是 類別:開關 >> 按鈕 系列:8Y 標準包裝:1 系列:A16 類型:標準，發光式 電路:雙刀雙擲 開關功能:開-瞬時 額定電流:5A（AC） 額定電壓 - AC:125V 額定電壓 - DC:- 觸動器類型:方形，按鈕 顏色 - 致動器/蓋:黃 發光類型，顏色:LED，黃 發光電壓:12 VDC 安裝類型:前面板安裝 端接類型:焊接，快速連接 - 0.110"（2.8mm） 防護等級:IP65 - 防塵/防油/防水 特點:- 面板切口尺寸:圓形 - 直徑 16.00mm 包裝:散裝 工作溫度:-10°C ~ 55°C 機械壽命:2,000,000 次循環 電氣壽命:100,000 次循環 其它名稱:A165LAYM12D2 |
發布緊急采購，3分鐘左右您將得到回復。