- 您現在的位置：買賣IC網 > PDF目錄369351 > 78Q2120-64CGT (Electronic Theatre Controls, Inc.) 10/100BASE-TX Ethernet Transceiver PDF資料下載
參數資料
| 型號： | 78Q2120-64CGT |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | 10/100BASE-TX Ethernet Transceiver |
| 中文描述： | 10/100BASE-TX以太網收發器 |
| 文件頁數： | 16/33頁 |
| 文件大?。?/td> | 200K |
| 代理商： | 78Q2120-64CGT |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁當前第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁
78Q2120
10/100BASE-TX
Ethernet Transceiver
MR16 - VENDOR SPECIFIC REGISTER
(continued)
16
BIT
SYMBOL
TYPE
DESCRIPTION
16.1
PCSBP
R,W,0
PCS BYPASS: When set, the 100BASE-TX PCS is bypassed, as
are the scrambler and descrambler functions. Scrambled 5-bit code
groups for transmission are applied to the TX_ER, TXD[3:0] pins
and received on the RX_ER, RXD[3:0] pins. The RX_DV and
TX_EN signals are not valid in this mode. PCSBP mode is only valid
when 100BASE-TX is enabled.
16.0
RXCC
R,W,0
RECEIVE CLOCK CONTROL: When set, the RX_CLK signal will
be held in logic low (only in 100BASE-TX mode) when there is no
data being received (to save power). The RX_CLK signal will restart
1 clock cycle before the assertion of RX_DV and be shut off 64 clock
cycles after RX_DV goes low. RXCC is disabled when loopback
mode is enabled (MR0.14 is high). This bit should be kept at logic
zero when the chip is in PCS Bypass mode.
MR17 - INTERRUPT CONTROL/STATUS REGISTER
The Interrupt Control/Status Register provides the means for controlling and observing the events which trigger
an interrupt on the INTR pin. This register can also be used in a polling mode via the MII serial interface as a
means to observe key events within the PHY via one register address. These bits are cleared after the register is
read. Bits 8-15 of this register, when set to logic one, enable their corresponding bit in the lower byte to signal an
interrupt on the INTR pin. The level of this interrupt can be set via MR16.14.
17.15
17.14
17.13
17.12
17.11
17.10
17.9
17.8
17.7
JABBER IE
RXER IE
PRX IE
PFD IE
LP-AC K IE
LS-CHG IE
RFAULT IE
ANEG-COMP IE
JABBER INT
R, W, 0
R, W, 0
R, W, 0
R, W, 0
R, W, 0
R, W, 0
R, W, 0
R, W, 0
RC, 0
JABBER INTERRUPT ENABLE BIT
RECEIVE ERROR INTERRUPT ENABLE BIT
PAGE RECEIVED INTERRUPT ENABLE BIT
PARALLEL DETECT FAULT INTERRUPT ENABLE BIT
LINK PARTNER ACKNOWLEDGE INTERRUPT ENABLE BIT
LINK STATUS CHANGE INTERRUPT ENABLE BIT
REMOTE FAULT INTERRUPT ENABLE BIT
AUTO-NEGOTIATION COMPLETE INTERRUPT ENABLE BIT
JABBER INTERRUPT: This bit is set when a jabber event is indicated
by the 10BASE-T circuitry.
RECEIVE ERROR INTERRUPT: This bit is set when the RX_ER
signal transitions high.
PAGE RECEIVE INTERRUPT: This bit is set when a new page has
been received from the link partner during auto-negotiation.
PARALLEL DETECT FAULT INTERRUPT: This bit is set by the auto-
negotiation logic when a parallel detect fault condition is indicated.
LINK PARTNER ACKNOWLEDGE INTERRUPT: This bit is set by the auto-
negotiation logic when FLP bursts are received with the acknowledge bit set.
LINK STATUS CHANGE INTERRUPT: This bit is set when the link
transitions from an OK status to a fail status or vice versa.
REMOTE FAULT INTERRUPT: This bit is set when a remote fault
condition has been indicated by the link partner.
AUTO-NEGOTIATION COMPLETE INTERRUPT: This bit is set by the
auto-negotiation logic upon successful completion of auto-negotiation.
17.6
RXER INT
RC, 0
17.5
PRX INT
RC, 0
17.4
PDF INT
RC, 0
17.3
LP-ACK INT
RC, 0
17.2
LS-CHG INT
RC, 0
17.1
RFAULT INT
RC, 0
17.0
ANEG-COMP INT
RC, 0
相關PDF資料 |
PDF描述 |
|---|---|
| 78Q2120-64T | 10/100BASE-TX Ethernet Transceiver |
| 78Q2120-CGT | 10/100BASE-TX Ethernet Transceiver |
| 78Q8392L | Low Power Ethernet Coaxial Transceiver |
| 78Q8392L-28CH | Low Power Ethernet Coaxial Transceiver |
| 78Q8392L-CP | Low Power Ethernet Coaxial Transceiver |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 78Q2120-64T | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:10/100BASE-TX Ethernet Transceiver |
| 78Q2120C | 制造商:TDK 制造商全稱:TDK Electronics 功能描述:10/100BASE - TX Transceiver |
| 78Q2120C09-64CGT | 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:10/100BASE-TX Transceiver |
| 78Q2120C09-64CGT/F | 功能描述:以太網 IC 10-100 Fast Ethernet Transceiver RoHS:否 制造商:Micrel 產品:Ethernet Switches 收發器數量:2 數據速率:10 Mb/s, 100 Mb/s 電源電壓-最大:1.25 V, 3.45 V 電源電壓-最小:1.15 V, 3.15 V 最大工作溫度:+ 85 C 封裝 / 箱體:QFN-64 封裝:Tray |
| 78Q2120C09-64CGTR/F | 功能描述:TXRX 10/100 BASE 3.3V 64-LQFP RoHS:是 類別:集成電路 (IC) >> 接口 - 驅動器，接收器，收發器 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:25 系列:- 類型:收發器 驅動器/接收器數:2/2 規程:RS232 電源電壓:4.5 V ~ 5.5 V 安裝類型:通孔 封裝/外殼:16-DIP（0.300"，7.62mm） 供應商設備封裝:16-PDIP 包裝:管件 |
發布緊急采購，3分鐘左右您將得到回復。