參數資料
型號： 78M6618-IMR/F/P
廠商： MAXIM INTEGRATED PRODUCTS INC
元件分類： 模擬信號調理
英文描述： SPECIALTY ANALOG CIRCUIT, QCC68
封裝： 8 X 8 MM, ROHS COMPLIANT, TQFN-68
文件頁數： 3/32頁
文件大?。?/td> 419K
代理商： 78M6618-IMR/F/P
DS_6618_005
78M6618 Data Sheet
Rev. 1.4
11
1.16 LCD Drivers
The 78M6618 contains a total of 35 dedicated and multiplexed LCD drivers which are grouped as follows:
11 dedicated LCD segment drivers.
3 drivers multiplexed with the ICE interface (E_TCLK, E_RST, E_RXTX).
1 driver multiplexed with auxiliary signal CKTEST (SEG19).
4 drivers multiplexed with the SPI port (PCLK, PSDO, PCSZ, PSDI).
16 drivers multiplexed with general purpose DIO pins.
2 common drivers for multiplexing (50%, or 100% duty cycle) – always available.
With a minimum of 15 driver pins always available and a total of 35 driver pins in the maximum con-
figuration, the device is capable of driving between 30 to 70 pixels of LCD display. At eight pixels per digit,
this corresponds to 3 to 8 digits. The following dedicated and multi-use pins can be assigned as LCD
segment pins for the 78M6618:
11 dedicated LCD segment pins: SEG0 to SEG2, SEG7, SEG8, SEG12, SEG14 to SEG18.
8 dual-function pins: SEG3/PCLK, SEG4/PSDO, SEG5/PCSZ, SEG6/PSDI, E_RXTX/SEG9,
E_TCLK/SEG10, E_RST/SEG11, and SEG19/CKTEST.
16 combined DIO and segment pins: SEG24/DIO4 to SEG31/DIO11, SEG33/DIO13 to
SEG39/DIO19, and SEG63/DIO43. Of which, DIO7/SEG27 through DIO15/SEG35 can be used for
controlling relays.
See the 78M6618 Programmer’s Reference Manual for more information regarding the programmability
of the 78M6618 LCD drivers. See the 78M6618 Hardware Design Guidelines for more information
regarding connecting the 78M6618 LCD drivers to LCDs.
1.17 EEPROM Interface
The 78M6618 provides hardware support for an optional two-pin or a three-wire (
-wire) EEPROM
interface.
Two-Pin EEPROM Interface
The dedicated 2-pin serial interface communicates with external EEPROM devices. The interface is
multiplexed onto the DIO4 (SCK) and DIO5 (SDA) pins.
Three-Wire (
-Wire) EEPROM Interface
A 500 kHz three-wire interface, using SDATA, SCK and a DIO pin for CS is also available.
See the 78M6618 Programmer’s Reference Manual for more information regarding the programmability
of the 78M6618 EEPROM interfaces. See the 78M6618 Hardware Design Guidelines for more
information regarding connecting the 78M6618 EEPROM interfaces to various EEPROM.
1.18 SPI Slave Port
The slave SPI port communicates directly with the MPU data bus and is able to directly read and write
XRAM and IORAM locations. It is also able to send commands to the MPU. The interface to the slave
port consists of the PCSZ, PCLK, PSDI and PSDO pins. These pins are multiplexed with the LCD
segment driver pins SEG3 to SEG6.
A typical SPI transaction is as follows. While PCSZ is high, the port is held in an initialized/reset state.
During this state, PSDO is held in HiZ state and all transitions on PCLK and PSDI are ignored. When
PCSZ falls, the port will begin the transaction on the first rising edge of PCLK. A transaction consists of
an 8-bit command, a 16-bit address and then one or more bytes of data. The transaction ends when
PCSZ is raised. Some transactions may consist of a command only. The last SPI command and address
(if part of the command) are available in the IORAM.
相關PDF資料
PDF描述
7MBP150RTJ060 AC MOTOR CONTROLLER, 300 A, XMA25
7MBP25RU2A120 AC MOTOR CONTROLLER, 50 A, XMA22
7MBP50RTJ060 AC MOTOR CONTROLLER, 100 A, XMA25
7MBP50RU2A120 AC MOTOR CONTROLLER, 100 A, XMA22
7MBP75RU2A120 AC MOTOR CONTROLLER, 150 A, XMA22
相關代理商/技術參數
參數描述
78M6618-M/F/P1 功能描述:計量片上系統 - SoC 8 Out Sgl Phase Pwr & Energy Msrmt IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel
78M6618-M/F/P2 功能描述:IC PWR MEASUREMENT OCTAL 68QFN 制造商:maxim integrated 系列:- 包裝:管件 零件狀態:停產 輸入阻抗:40 千歐 ~ 90 千歐 測量誤差:0.5% 電壓 - I/O 高:2V 電壓 - I/O 低:0.8V 電流 - 電源:- 電壓 - 電源:3 V ~ 3.6 V 表計類型:單相 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:68-VFQFN 裸露焊盤 供應商器件封裝:68-QFN（8x8） 標準包裝:260
78M6618-MR/F/P1 功能描述:計量片上系統 - SoC 8 Out Sgl Phase Pwr & Energy Msrmt IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel
78M6618-MR/F/P2 功能描述:IC PWR MEASUREMENT OCTAL 68QFN 制造商:maxim integrated 系列:- 包裝:帶卷（TR） 零件狀態:停產 輸入阻抗:40 千歐 ~ 90 千歐 測量誤差:0.5% 電壓 - I/O 高:2V 電壓 - I/O 低:0.8V 電流 - 電源:- 電壓 - 電源:3 V ~ 3.6 V 表計類型:單相 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:68-VFQFN 裸露焊盤 供應商器件封裝:68-QFN（8x8） 標準包裝:2,500
78M6618-PDU1 功能描述:BOARD EVAL 78M6618 PDU1 RoHS:是 類別:編程器，開發系統 >> 評估演示板和套件 系列:* 產品培訓模塊:Obsolescence Mitigation Program 標準包裝:1 系列:- 主要目的:電源管理，電池充電器 嵌入式:否 已用 IC / 零件:MAX8903A 主要屬性:1 芯鋰離子電池 次要屬性:狀態 LED 已供物品:板
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*