- 您現在的位置：買賣IC網 > PDF目錄68811 > 71M6533-IGTR/F (MAXIM INTEGRATED PRODUCTS INC) SPECIALTY ANALOG CIRCUIT, PQFP100 PDF資料下載
參數資料
| 型號： | 71M6533-IGTR/F |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 模擬信號調理 |
| 英文描述： | SPECIALTY ANALOG CIRCUIT, PQFP100 |
| 封裝： | LEAD FREE, LQFP-100 |
| 文件頁數： | 57/124頁 |
| 文件大?。?/td> | 2008K |
| 代理商： | 71M6533-IGTR/F |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁當前第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁第120頁第121頁第122頁第123頁第124頁
71M6533/71M6534 Data Sheet
FDS_6533_6534_004
38
2007-2009 TERIDIAN Semiconductor Corporation
v1.1
The PLL has a 2x emulator clock which is controlled by ECK_DIS. Since clock noise from this feature
may disturb the ADC, it is recommended that this option be avoided when possible.
The MPU clock frequency CKMPU is determined by another divider controlled by the I/O RAM register
MPU_DIV and can be set to MCK/2
(MPU_DIV+2) Hz where MPU_DIV varies from 0 to 6. The circuit also ge-
nerates the 2 x CKMPU clock for use by the emulator. The emulator clock is not generated when
ECK_DIS is asserted.
During a power-on reset, [M40MHZ, M26MHZ] defaults to [0,0], and the MCK divider is set to divide by 4.
When [M40MHZ, M26MHZ] = [1,0], the CE clock frequency may be set to 5 MHz or 10 MHz, using the I/O
RAM register CE10MHZ. In this mode, the ADC and FIR clock frequencies remain at 5 MHz. When
[M40MHZ, M26MHZ] = [0,1], the CE, ADC, FIR, and MPU clock frequencies are shifted to 6.6 MHz. This
increases the ADC sample rate by 33%. In sleep mode, the M40MHZ and M26MHZ inputs to the clock
generator are forced low.
In brownout mode, the clocks are derived from the crystal oscillator, and the clock frequencies are scaled
by 7/8.
1.4.3
Real-Time Clock (RTC)
The RTC is driven directly by the crystal oscillator. It is powered by the net RTC_NV (battery-backed up
supply). The RTC consists of a counter chain and output registers. The counter chain consists of regis-
ters for seconds, minutes, hours, day of week, day of month, month, and year. The RTC is capable of
processing leap years. Each counter has its own output register. The RTC registers will not be affected
by the reset pin, watchdog timer resets, or by transitions between the battery modes and mission mode.
Whenever the MPU reads the seconds register, all other output registers are automatically updated.
Since the RTC clock is not coherent to the MPU clock, the MPU must read the seconds register until two
consecutive reads are the same (this requires either 2 or 3 reads). At this point, all RTC output registers
will have the correct time. Regardless of the MPU clock speed, RTC reads require one wait state.
RTC time is set by writing to the RTC_SEC through RTC_YR registers. Each write operation must be pre-
ceded by a write operation to the WE register in I/O RAM. The value written to the WE register is un-
important.
Time adjustments are written to the RTCA_ADJ, PREG and QREG registers. Updates to PREG and QREG
must occur after the one second interrupt, and must be finished before reaching the next one-second
boundary. The new values are loaded into the counters at the next one-second boundary.
PREG and QREG are separate registers in the device hardware, but the bits are 16-bit contiguous so the
MPU firmware can treat them as a single register. A single binary number can be calculated and then
loaded into them at the same time.
The 71M6533 and 71M6534 have two rate adjustment mechanisms. The first is an analog rate adjust-
ment, using RTCA_ADJ[6:0], which trims the crystal load capacitance. Setting RTCA_ADJ[6:0] to 00 mi-
nimizes the load capacitance, maximizing the oscillator frequency. Setting RTCA_ADJ[6:0] to 0x3F max-
imizes the load capacitance, minimizing the oscillator frequency. The adjustable capacitance is ap-
proximately:
pF
ADJ
RTCA
C
ADJ
5
.
16
128
_
=
The adjustment range is approximately -12 ppm to +22 ppm. The precise amount of adjustment will de-
pend on the crystal properties. The adjustment may occur at any time, and the resulting clock frequency
can be measured over a one-second interval.
The second rate adjustment is a digital rate adjust using PREG and QREG, which can be used to adjust
the clock rate up to
± 988 ppm, with a resolution of 3.8 ppm. Updates must occur after a one second in-
相關PDF資料 |
PDF描述 |
|---|---|
| 71M6534H-IGTR/F | SPECIALTY ANALOG CIRCUIT, PQFP120 |
| 71M6533-IGT/F | SPECIALTY ANALOG CIRCUIT, PQFP100 |
| 71M6534-IGT/F | SPECIALTY ANALOG CIRCUIT, PQFP120 |
| 71M6533-IGTR/F | SPECIALTY ANALOG CIRCUIT, PQFP100 |
| 71M6534H-IGT/F | SPECIALTY ANALOG CIRCUIT, PQFP120 |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 71M6534 | 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:Energy Meter IC |
| 71M6534H | 制造商:TERIDIAN 制造商全稱:TERIDIAN 功能描述:Energy Meter IC |
| 71M6534H-DB | 功能描述:開發板和工具包 - 8051 71M6534H Demo Brd RoHS:否 制造商:Silicon Labs 產品:Development Kits 工具用于評估:C8051F960, Si7005 核心: 接口類型:USB 工作電源電壓: |
| 71M6534H-IGT/F | 功能描述:計量片上系統 - SoC Precision Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel |
| 71M6534H-IGTR/F | 功能描述:計量片上系統 - SoC Precision Energy Meter IC RoHS:否 制造商:Maxim Integrated 核心:80515 MPU 處理器系列:71M6511 類型:Metering SoC 最大時鐘頻率:70 Hz 程序存儲器大小:64 KB 數據 RAM 大小:7 KB 接口類型:UART 可編程輸入/輸出端數量:12 片上 ADC: 安裝風格:SMD/SMT 封裝 / 箱體:LQFP-64 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。