![](http://datasheet.mmic.net.cn/120000/5962R9674201TXC_datasheet_3278153/5962R9674201TXC_1.png)
1
TM
CAUTION: These devices are sensitive to electrostatic discharge; follow proper IC Handling Procedures.
1-888-INTERSIL or 321-724-7143
| Intersil (and design) is a trademark of Intersil Americas Inc.
Copyright Intersil Americas Inc. 2002. All Rights Reserved
Satellite Applications Flow (SAF) is a trademark of Intersil Corporation.
HS-508ARH-T
Radiation Hardened 8 Channel CMOS
Analog Multiplexer with Overvoltage
Protection
Intersil‘s Satellite Applications FlowTM (SAF) devices are
fully tested and guaranteed to 100kRAD total dose. This
QML Class T device is processed to a standard flow
intended to meet the cost and shorter lead-time needs of
large volume satellite manufacturers, while maintaining a
high level of reliability.
The HS-508ARH-T is a dielectrically isolated, radiation
hardened, CMOS analog multiplexer incorporating an
important feature; it withstands analog input voltages much
greater than the supplies. This is essential in any system
where the analog inputs originate outside the equipment.
They can withstand a continuous input up to 10V greater
than either supply, which eliminates the possibility of
damage when supplies are off, but input signals are present.
Equally important, it can withstand brief input transient
spikes of several hundred volts; which otherwise would
require complex external protection networks. Necessarily,
ON resistance is somewhat higher than similar unprotected
devices, but very low leakage current combine to produce
low errors. Reference Application Notes 520 and 521,
available from the Semiconductor Products Division of
Intersil, for further information on the HS-508ARH-T
multiplexer in general.
Specifications
Specifications for Rad Hard QML devices are controlled by
the Defense Supply Center in Columbus (DSCC). The SMD
numbers listed below must be used when ordering.
Detailed Electrical Specifications for the HS-508ARH-T
are contained in SMD 5962-96742. A “hot-link” is provided
from our website for downloading.
www.intersil.com/spacedefense/newsafclasst.asp
Intersil‘s Quality Management Plan (QM Plan), listing all
Class T screening operations, is also available on our
website.
www.intersil.com/quality/manuals.asp
Features
QML Class T, Per MIL-PRF-38535
Radiation Performance
- Gamma Dose (
γ) 1 x 105 RAD(Si)
- No Latch-Up, Dielectrically Isolated Device Islands
- SEP LET > 110MeV/mg/cm2
Analog/Digital Overvoltage Protection
Fail Safe with Power Loss (No Latchup)
Break-Before-Make Switching
DTL/TTL and CMOS Compatible
Analog Signal Range
±15V
Fast Access Time
Supply Current at 1MHz Address Toggle (Typ) 4mA
Standby Power (Typ.) 7.5mW
Pinouts
HS1-508ARH-T (SBDIP), CDIP2-T16
TOP VIEW
HS9-508ARH-T (FLATPACK), CDFP4-F16
TOP VIEW
Ordering Information
ORDERING
NUMBER
PART
NUMBER
TEMP.
RANGE
(oC)
5962R9674201TEC
HS1-508ARH-T
-55 to 125
5962R9674201TXC
HS9-508ARH-T
-55 to 125
NOTE:
Minimum order quantity for -T is 150 units through
distribution, or 450 units direct.
14
15
16
9
13
12
11
10
1
2
3
4
5
7
6
8
AO
EN
V-
IN 1
IN 2
IN 3
OUT
IN 4
A1
GND
V+
IN 5
IN 6
IN 7
IN 8
A2
2
3
4
5
6
7
8
116
15
14
13
12
11
10
9
EN
IN1
IN2
IN3
IN4
OUT
GND
IN5
IN6
IN7
IN8
A0
A1
A2
V+
V-
Data Sheet
July 1999
FN4605.1