- 您現在的位置：買賣IC網 > PDF目錄67336 > 5962-9312101MPA (MAXIM INTEGRATED PRODUCTS INC) 2 A SWITCHING REGULATOR, 190 kHz SWITCHING FREQ-MAX, CDIP8 PDF資料下載
參數資料
| 型號： | 5962-9312101MPA |
| 廠商： | MAXIM INTEGRATED PRODUCTS INC |
| 元件分類： | 穩壓器 |
| 英文描述： | 2 A SWITCHING REGULATOR, 190 kHz SWITCHING FREQ-MAX, CDIP8 |
| 封裝： | CERAMIC, DIP-8 |
| 文件頁數： | 9/11頁 |
| 文件大?。?/td> | 250K |
| 代理商： | 5962-9312101MPA |
Detailed Description
The MAX4734 is a low 0.8
(max) (at V+ = 2.7V) on-
resistance, low-voltage, 4-channel CMOS analog multi-
plexer that operates from a 1.6V to 3.6V single supply.
CMOS switch construction allows switching analog sig-
nals that range from GND to V+.
When powered from a 2.7V supply, the 0.8
(max) RON
allows high continuous currents to be switched in a
variety of applications.
Applications Information
Proper power-supply sequencing is recommended for
all CMOS devices. Do not exceed the absolute maxi-
mum ratings, because stresses beyond the listed rat-
ings can cause permanent damage to the devices.
Always sequence V+ on first, followed by NO_ or COM.
Although it is not required, power-supply bypassing
improves noise margin and prevents switching noise
propagation from the V+ supply to other components.
A 0.1F capacitor, connected from V+ to GND, is ade-
quate for most applications.
Logic Inputs
The MAX4734 logic inputs can be driven up to 3.6V
regardless of the supply voltage. For example, with a
1.8V supply, A_ and EN may be driven low to GND and
high to 3.6V. Driving A_ and EN rail-to-rail minimizes
power consumption.
Analog Signal Levels
Analog signals that range over the entire supply voltage
(V+ to GND) can be passed with very little change in on-
resistance (see the Typical Operating Characteristics).
The switches are bidirectional, so the NO_ and COM_
pins can be used as either inputs or outputs.
Layout
High-speed switches require proper layout and design
procedures for optimum performance. Reduce stray
inductance and capacitance by keeping traces short
and wide. Ensure that bypass capacitors are as close
to the device as possible. Use large ground planes
where possible.
MAX4734
0.8
, Low-Voltage, 4-Channel
Analog Multiplexer
_______________________________________________________________________________________
7
50%
tOFF
tR < 5ns
tF < 5ns
0
VEN = VIH + 0.5
VOUT
90%
tON
V+
VOUT
GND
V+
A1
A0
EN
NO1
NO2–NO4
COM
VNO_
RL
MAX4734
35pF
VEN
V+
Figure 1. Switching Time
Test Circuits/Timing Diagrams
相關PDF資料 |
PDF描述 |
|---|---|
| 5962-9313001M2A | VIDEO AMPLIFIER, CQCC20 |
| 5962-9313201MPX | 1 CHANNEL, VIDEO AMPLIFIER, CDIP8 |
| 5962-9316202HXC | 1-OUTPUT 60 W DC-DC REG PWR SUPPLY MODULE |
| 5962-9319302HXC | 2-OUTPUT 65 W DC-DC REG PWR SUPPLY MODULE |
| 5962-9316302HXC | 1-OUTPUT 50 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 5962-9312403MXA | 制造商:QP Semiconductor 功能描述:FIFO Mem Async Single Uni-Dir 2K x 9 |
| 5962-9312403MYA | 制造商:QP Semiconductor 功能描述:FIFO Mem Async Single Uni-Dir 2K x 9 32-Pin LCC |
| 5962-9312403MZA | 制造商:QP Semiconductor 功能描述:FIFO Mem Async Single Uni-Dir 2K x 9 32-Pin CDIP |
| 5962-9312501M2C | 功能描述:監控電路 RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
| 5962-9312501MEA | 功能描述:監控電路 MCU Supervisor RoHS:否 制造商:STMicroelectronics 監測電壓數: 監測電壓: 欠電壓閾值: 過電壓閾值: 輸出類型:Active Low, Open Drain 人工復位:Resettable 監視器:No Watchdog 電池備用開關:No Backup 上電復位延遲（典型值）:10 s 電源電壓-最大:5.5 V 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:UDFN-6 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。