![](http://datasheet.mmic.net.cn/90000/5962-0623101HUC_datasheet_3474174/5962-0623101HUC_3.png)
STANDARD
MICROCIRCUIT DRAWING
SIZE
A
5962-06231
DEFENSE SUPPLY CENTER COLUMBUS
COLUMBUS, OHIO 43218-3990
REVISION LEVEL
SHEET
3
DSCC FORM 2234
APR 97
1.2.4 Case outline(s). The case outline(s) are as designated in MIL-STD-1835 and as follows:
Outline letter
Descriptive designator
Terminals
Package style 1/
U
See figure 1
12
Y case configuration with leads bent upwards
X
See figure 1
12
Straight leads with end mounting through holes
Y
See figure 1
12
Straight leads with side mounting through holes
Z
See figure 1
12
Y case configuration with leads bent downwards
1.2.5 Lead finish. The lead finish shall be as specified in MIL-PRF-38534.
1.3 Absolute maximum ratings. 2/
Input voltage range............................................................................
-0.5 V dc to +500 V dc
Lead temperature (soldering, 10 seconds) ........................................
+300
°C
Storage temperature range ...............................................................
-65
°C to +135°C
1.4 Recommended operating conditions.
Input voltage range............................................................................
+160 V dc to +400 V dc
Output power 3/................................................................................
≤ 100 W
Case operating temperature range....................................................
-55
°C to +125°C
2. APPLICABLE DOCUMENTS
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a part
of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in the
solicitation or contract.
DEPARTMENT OF DEFENSE SPECIFICATIONS
MIL-PRF-38534 - Hybrid Microcircuits, General Specification for.
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-883
- Test Method Standard Microcircuits.
MIL-STD-1835 - Interface Standard for Electronic Component Case Outlines.
DEPARTMENT OF DEFENSE HANDBOOKS
MIL-HDBK-103 - List of Standard Microcircuit Drawings.
MIL-HDBK-780 - Standard Microcircuit Drawings.
(Copies of these documents are available online at http://assist.daps.dla.mil;quicksearch/ or www.dodssp.daps.mil or from the
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
2.2 Order of precedence. In the event of a conflict between the text of this drawing and the references cited herein, the text of
this drawing takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a
specific exemption has been obtained.
1/
Leads are ceramic sealed, all package styles.
2/
Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
3/
Derate output power linearly above case temperature +125
°C to 0 at +135°C.