Application Section
FEEDBACK RESISTOR
The LMH6702 achieves its excellent pulse and distortion
performance by using the current feedback topology. The
loop gain for a current feedback op amp, and hence the
frequency response, is predominantly set by the feedback
resistor value. The LMH6702 is optimized for use with a
237
feedback resistor. Using lower values can lead to
excessive ringing in the pulse response while a higher value
will limit the bandwidth. Application Note OA-13 discusses
this in detail along with the occasions where a different R
F
might be advantageous.
HARMONIC DISTORTION
The LMH6702 has been optimized for exceptionally low
harmonic distortion while driving very demanding resistive or
capacitive loads. Generally, when used as the input amplifier
to very high speed flash ADCs, the distortions introduced by
the converter will dominate over the low LMH6702 distor-
tions. The capacitor C
SS, shown across the supplies in Fig- nd
harmonic distortion. For absolute minimum distortion levels,
it is also advisable to keep the supply decoupling currents
(ground connections to C
Figure 2) separate from the ground connections to sensitive
input circuitry (such as R
G,RT, and RIN ground connections).
Splitting the ground plane in this fashion and separately
routing the high frequency current spikes on the decoupling
caps back to the power supply (similar to "Star Connection"
layout technique) ensures minimum coupling back to the
input circuitry and results in best harmonic distortion re-
sponse (especially 2
nd order distortion).
If this lay out technique has not been observed on a particu-
lar application board, designer may actually find that supply
decoupling caps could adversely affect HD2 performance by
increasing the coupling phenomenon already mentioned.
Figure 3 below shows actual HD2 data on a board where the
ground plane is "shared" between the supply decoupling
capacitors and the rest of the circuit. Once these capacitors
are removed, the HD2 distortion levels reduce significantly,
especially between 10MHz-20MHz, as shown in
Figure 3below:
At these extremely low distortion levels, the high frequency
behavior of decoupling capacitors themselves could be sig-
nificant. In general, lower value decoupling caps tend to
have higher resonance frequencies making them more ef-
fective for higher frequency regions. A particular application
board which has been laid out correctly with ground returns
"split" to minimize coupling, would benefit the most by having
low value and higher value capacitors paralleled to take
advantage of the effective bandwidth of each and extend low
distortion frequency range.
20151628
FIGURE 1. Recommended Non-Inverting Gain Circuit
20151627
FIGURE 2. Recommended Inverting Gain Circuit
20151622
FIGURE 3. Decoupling Current Adverse Effect on a
Board with Shared Ground Plane
LMH6702QML
www.national.com
8