- 您現在的位置：買賣IC網 > PDF目錄226111 > 48IMS25-15-9 1-OUTPUT 24 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | 48IMS25-15-9 |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 24 W DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 2/11頁 |
| 文件大小： | 225K |
| 代理商： | 48IMS25-15-9 |
Board Mountable
DC-DC Converters
IMS 25 Series
Edition 2/4.2000
10/11
Safety and Installation Instructions
Installation Instruction
Installation of the DC-DC converters must strictly follow the
national safety regulations in compliance with the enclo-
sure, mounting, creepage, clearance, casualty, markings
and segregation requirements of the end-use application.
Connection to the system shall be made via a printed circuit
board with hole diameters of 1.4 mm
±0.1 mm for the pins.
The units should be connected to a secondary circuit.
Check for hazardous voltages before altering any connec-
tions.
Do not open the module.
Ensure that a unit failure (e.g. by an internal short-circuit)
does not result in a hazardous conditions. See also:
Safety
of operator accessible output circuit.
Input Fuse
To prevent excessive current flowing through the input sup-
ply line in case of a short-circuit across the converter input
an external fuse should be installed in a non earthed input
supply line. We recommend a fast acting fuse F5A for
24 IMS 25 types and F3.15A for 48 IMS 25 types.
Standards and approvals
All DC-DC converters are pending to be UL recognized
according to UL 1950, UL recognized for Canada to CAN/
CSA C22.2 No. 950-95 and LGA approved to IEC/EN
60950 standards.
The units have been evaluated for:
Building in
Supplementary insulation input to output, based on their
maximum input voltage
The use in a pollution degree 2 environment
Connecting the input to a secondary circuit which is sub-
ject to a maximum transient rating of 1500 V
After approvals the DC-DC converters are subject to manu-
facturing surveillance in accordance with the above men-
tioned UL, CSA, EN and ISO 9001 standards.
Isolation
The electric strength test is performed as factory test in ac-
cordance with IEC/EN 60950 and UL 1950 and should not
be repeated in the field. Power-One will not honour any
guarantee claims resulting from electric strength field tests.
Table 12: Electric strength test voltages
Characteristic
Input to output
Unit
Electric strength
1.1
kVrms
test voltage 1 s
1.5
kV DC
Coupling capacitance
≈2.2
nF
Insulation resistance
>100
M
at 500 V DC
Partial discharge
Consult
kV
extinction voltage
factory
Fig. 13
Pin allocation
Protection Degree
The protection degree of the DC-DC converters is IP 40.
Cleaning Agents
In order to avoid possible damage, any penetration of
cleaning fluids should be prevented, since the power sup-
plies are not hermetically sealed (use option Z).
Safety of Operator Accessible Output Circuit
If the output circuit of a DC-DC converter is operator acces-
sible, it shall be an SELV circuit according to IEC/EN 60950
related safety standards
The following table shows some possible installation con-
figurations, compliance with which causes the output circuit
of the DC-DC converter to be an SELV circuit according to
IEC/EN 60950 up to a configured output voltage of 42 V.
However, it is the sole responsibility of the installer to en-
sure the compliance with the relevant and applicable safety
regulations. More information is given in:
Technical Infor-
mation: Safety.
1
2
4
3
13
17
15
09116
Table 13: Pin allocation
Pin No.
Single output
option i
1Vi+
Vi+
2Vi–
Vi–
3W
W
4SD
i
13
Vo+
15
Vo–
17
Trim
相關PDF資料 |
PDF描述 |
|---|---|
| 40IMX15-05-9RZ-G | 1-OUTPUT 12.8 W DC-DC REG PWR SUPPLY MODULE |
| 40IMX7-15-15-9C | 2-OUTPUT 7.2 W DC-DC REG PWR SUPPLY MODULE |
| 40IMX7-03-9 | 1-OUTPUT 5 W DC-DC REG PWR SUPPLY MODULE |
| 40IMX7-1212-7C | 2-OUTPUT 7.2 W DC-DC REG PWR SUPPLY MODULE |
| 40IMX4-12-7 | 1-OUTPUT 3 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 48IMS25-15-9Z | 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 15V 1.6A 25W 7PIN - Bulk |
| 48IMS25-2.5-9G | 制造商:Power-One 功能描述: |
| 48IMS25-2.5-9GZ | 功能描述:CONVERT DC/DC 2.5V 15W RoHS:是 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:10 系列:PT4570 類型:隔離 輸出數:1 電壓 - 輸入（最?。?36V 電壓 - 輸入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:3.3A 電源（瓦） - 制造商系列:30W 電壓 - 隔離:1.5kV（1500V） 特點:- 安裝類型:表面貼裝 封裝/外殼:19-SIP SMD 模塊 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包裝:托盤 工作溫度:-40°C ~ 85°C 效率:84% 電源（瓦特）- 最大:30W |
| 48IMS30-0302-9G | 功能描述:CONVERT DC/DC 3.3V & 1.8V 22W RoHS:是 類別:電源 - 板載 >> DC DC Converters 系列:* 標準包裝:10 系列:PT4570 類型:隔離 輸出數:1 電壓 - 輸入（最?。?36V 電壓 - 輸入（最大）:75V Voltage - Output 1:9V Voltage - Output 2:- Voltage - Output 3:- 電流 - 輸出（最大）:3.3A 電源（瓦） - 制造商系列:30W 電壓 - 隔離:1.5kV（1500V） 特點:- 安裝類型:表面貼裝 封裝/外殼:19-SIP SMD 模塊 尺寸/尺寸:3.00" L x 1.19" W x 0.50" H（76.2mm x 30.2mm x 12.7mm） 包裝:托盤 工作溫度:-40°C ~ 85°C 效率:84% 電源（瓦特）- 最大:30W |
| 48IMS30-0503-9G | 制造商:Power-One 功能描述:DC/DC PS DUAL-OUT 5.1V/3.3V 3.1A/4.2A 30W 8PIN - Bulk |
發布緊急采購，3分鐘左右您將得到回復。