參數資料
型號： 40430C
英文描述： 4kbit EEPROM, Triple Voltage Monitor with Integrated CPU Supervisor
中文描述： 4kbit的EEPROM，三電壓監視器集成CPU監控
文件頁數： 8/24頁
文件大?。?/td> 421K
代理商： 40430C
X40430/X40431 – Preliminary Information
Characteristics subject to change without notice.
8 of 24
REV 1.2.3 11/28/00
www.xicor.com
BP1, BP0: Block Protect Bits (Nonvolatile)
The Block Protect Bits, BP1 and BP0, determine which
blocks of the array are write protected. A write to a pro-
tected block of memory is ignored. The block protect
bits will prevent write operations to one of eight seg-
ments of the array.
PUP1, PUP0: Power Up Bits (Nonvolatile)
The Power Up bits, PUP1 and PUP0, determine the
t
PURST
time delay. The nominal power up times are
shown in the following table.
WD1, WD0: Watchdog Timer Bits (Nonvolatile)
The bits WD1 and WD0 control the period of the
Watchdog Timer. The options are shown below.
Writing to the Control Registers
Changing any of the nonvolatile bits of the control and
trickle registers requires the following steps:
– Write a 02H to the Control Register to set the Write
Enable Latch (WEL). This is a volatile operation, so
there is no delay after the write. (Operation preceded
by a start and ended with a stop).
– Write a 06H to the Control Register to set the
Register Write Enable Latch (RWEL) and the WEL
bit. This is also a volatile cycle. The zeros in the data
byte are required. (Operation proceeded by a start
and ended with a stop).
– Write one byte value to the Control Register that has
all the control bits set to the desired state. The Con-
trol register can be represented as
qxys t
01
r
in
binary, where
xy
are the WD bits, and
st
are the BP
bits and
qr
are the power up bits. This operation pro-
ceeded by a start and ended with a stop bit. Since
this is a nonvolatile write cycle it will take up to 10ms
(max.) to complete. The RWEL bit is reset by this
cycle and the sequence must be repeated to change
the nonvolatile bits again. If bit 2 is set to ‘1’ in this
third step (
qxys t
11
r
) then the RWEL bit is set, but
the WD1, WD0, PUP1, PUP0, BP1 and BP0 bits
remain unchanged. Writing a second byte to the con-
trol register is not allowed. Doing so aborts the write
operation and returns a NACK.
– A read operation occurring between any of the previ-
ous operations will not interrupt the register write
operation.
– The RWEL bit cannot be reset without writing to the
nonvolatile control bits in the control register, power
cycling the device or attempting a write to a write
protected block.
To illustrate, a sequence of writes to the device consist-
ing of [02H, 06H, 02H] will reset all of the nonvolatile
bits in the Control Register to 0. A sequence of [02H,
06H, 06H] will leave the nonvolatile bits unchanged
and the RWEL bit remains set.
Fault Detection Register (FDR)
The Fault Detection Register provides the user the
status of what causes the system reset active. The
Manual Reset Fail, Watchdog Timer Fail and Three
Low Voltage Fail bits are volatile
The FDR is accessed with a special preamble in the
slave byte (1011) and is located at address 0FFh. It
can only be modified by performing a byte write opera-
tion directly to the address of the register and only one
data byte is allowed for each register write operation.
There is no need to set the WEL or RWEL in the
control register to access this FDR.
B
B
Protected Addresses
(Size)
None
180h – 1FFh (128 bytes)
100h – 1FFh (256 bytes)
000h – 1FFh (512 bytes)
Array Lock
None
Upper 1/4 (Q4)
Upper 1/2 (Q3,Q4)
Full Array (All)
0
0
1
1
0
1
0
1
PUP1
0
0
1
1
PUP0
0
1
0
1
Power on Reset Delay (
t
PURST
)
50ms
200ms
400ms
800ms
WD1
0
0
1
1
WD0
0
1
0
1
Watchdog Time Out Period
1.4 seconds
200 milliseconds
25 milliseconds
disabled
7
6
5
4
3
2
0
1
0
0
0
LV1F
LV2F
LV3F
WDF
MRF
相關PDF資料
PDF描述
40430X 4kbit EEPROM, Triple Voltage Monitor with Integrated CPU Supervisor
40430A 4kbit EEPROM, Triple Voltage Monitor with Integrated CPU Supervisor
40430B 4kbit EEPROM, Triple Voltage Monitor with Integrated CPU Supervisor
4043B Quadruple R/S latch with 3-state outputs
4044-UCA 300mA LDO Linear Regulators with Internal Microprocessor Reset Circuit
相關代理商/技術參數
參數描述
40430X 制造商:XICOR 制造商全稱:Xicor Inc. 功能描述:4kbit EEPROM, Triple Voltage Monitor with Integrated CPU Supervisor
404310 制造商:MAGNUM / COOPER 功能描述:
40431-0010 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:MS4800-ADPT-TXS
40431-0020 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:MS4800-ADPT-TXM
40431-0030 制造商:OMRON INDUSTRIAL AUTOMATION 功能描述:MS4800-ADPT-RX
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*