參數資料
型號: 333-2UYD/S530-A3
廠商: Everlight Electronics Co Ltd
文件頁數: 7/7頁
文件大?。?/td> 1145K
描述: LED 5MM SUPER YELLOW DIFF RND
標準包裝: 500
顏色:
Millicandela 等級: 320mcd
正向電壓: 2V
電流 - 測試: 20mA
波長 - 主: 589nm
波長 - 峰值: 591nm
視角: 30°
透鏡類型: 散射,有色
透鏡樣式/尺寸: 圓形,帶圓頂,5mm
封裝/外殼: 徑向
高度: 8.60mm
安裝類型: 通孔
包裝: 散裝
DATASHEET
LAMP 
333-2UYD/S530-A3
 
 
7 
Copyright ?2010, Everlight All Rights Reserved. Release Date : Jul. 12. 2013. Issue No: DAE-0000704_Rev.2
www.everlight.com 
 
 
Although the recommended soldering conditions are specified in the above table, dip or hand soldering at the lowest
possible temperature is desirable for the LEDs.
 
 
Wave soldering parameter must be set and maintain according to recommended temperature and dwell time in the solder
wave.
4.    Cleaning
 
When necessary, cleaning should occur only with isopropyl alcohol at room temperature for a duration of no more than
one minute. Dry at room temperature before use.
 
Do not clean the LEDs by the ultrasonic. When it is absolutely necessary, the influence of ultrasonic cleaning on the LEDs
depends on factors such as ultrasonic power and the assembled condition. Ultrasonic cleaning shall be pre-qualified to
ensure this will not cause damage to the LED
5.    Heat Management
 
Heat management of LEDs must be taken into consideration during the design stage of LED application. The current
should be de-rated appropriately by referring to the de-rating curve found in each product specification.
 
The temperature surrounding the LED in the application should be controlled. Please refer to the data sheet de-rating
curve.
6.   ESD (Electrostatic Discharge)
 
The products are sensitive to static electricity or surge voltage. ESD can damage a die and its reliability.
When handling the products, the following measures against electrostatic discharge are strongly
recommended:
Eliminating the charge
Grounded wrist strap, ESD footwear, clothes, and floors
Grounded workstation equipment and tools
ESD table/shelf mat made of conductive materials
 
Proper grounding is required for all devices, equipment, and machinery used in product assembly.
Surge protection should be considered when designing of commercial products.
 
If tools or equipment contain insulating materials such as glass or plastic,
the following measures against electrostatic discharge are strongly recommended:
Dissipating static charge with conductive materials
Preventing charge generation with moisture
Neutralizing the charge with ionizers
7.    Other
 
Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above
specification.
 
When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these
specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does
not comply
with the absolute maximum ratings and the instructions included in these specification sheets.
 
These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please dont
reproduce or cause anyone to reproduce them without EVERLIGHTs consent.
 
 
 
相關PDF資料
PDF描述
334-15/T2C1-1UWA LED 5MM WHITE WATER CLEAR ROUND
383-2UYC/S400-A6 LED 5MM SUPER YELLOW WATER CLEAR
4300F5LC LED GREEN BRITE T-1
4300H5LC LED BRITE GREEN T1-3/4 LOW CURR
4301F11/17 LED T-1 RED/YELLOW WHT DIFF TH
相關代理商/技術參數
參數描述
333-2UYOD/S530-A4-L 制造商:Everlight Electronics Co 功能描述:
333-2UYT/S530-A2 功能描述:標準LED-通孔 Yellow Translucent 589nm 1600mcd RoHS:否 制造商:Vishay Semiconductors 照明顏色:Red 光強度:0.7 mcd 波長/色溫:615 nm 顯示角:45 deg 透鏡顏色/類型:Clear, Non-Diffused 正向電流:70 mA 正向電壓:1.83 V to 3.03 V LED 大小:2 mm 系列: 封裝:Tube
333-2UYT/S530-A3 功能描述:標準LED-通孔 5mm LED RoHS:否 制造商:Vishay Semiconductors 照明顏色:Red 光強度:0.7 mcd 波長/色溫:615 nm 顯示角:45 deg 透鏡顏色/類型:Clear, Non-Diffused 正向電流:70 mA 正向電壓:1.83 V to 3.03 V LED 大小:2 mm 系列: 封裝:Tube
3332X WAF 制造商:Advanced Micro Devices 功能描述:
3333 制造商:HIOKI 功能描述:ANALYSER POWER 制造商:Steinel America Inc 功能描述:GLUE GUN HOT MELT 制造商:Steinel America Inc 功能描述:GLUE GUN, HOT MELT, UK PLUG