參數資料
型號： 2BT-5
廠商： Electronic Theatre Controls, Inc.
英文描述： THERMOPILE TYPE INFRARED SENSOR
中文描述： 熱電型紅外傳感器
文件頁數： 39/44頁
文件大小： 669K
代理商： 2BT-5
39
Reliability
ZENAMIC
Characteristics
Test Methods
Criterion
Robustness of
Terminations
(Tensile)
Robustness of
Terminations
(Bending)
Humidity
(Steady State)
Vibration
Solderability
Resistance to
Soldering Heat
High Temperature
Storage/Dry Heat
High Temperature
Load/
Dry Heat Load
Low Temperature
Storage/Cold
Damp Heat Load/
Humidity Load
Temperature
Cycle
Mechanical
Environmental
After gradual applying of the force specified below and keeping the unit fixed
for 10 seconds, the terminal shall be visually examined for any damage.
Terminal diameter
Force
0.6mm, 0.8mm 9.8N(1.0kgf)
1.0mm 19.6N(2.0kgf)
The unit shall be secured with its terminal kept vertical and the force
specified below shall be applied in the axial direction.
The terminal shall gradually be bent by 90
in one direction, then 90
in the
opposite direction, and again back to the original position.
The damage of the terminal shall be visually examined.
After repeated applying of a single harmonic vibration (amplitude:0.75mm,
double amplitude:1.5mm) with 1 minute vibration frequency cycle (10 Hz to
55 Hz to 10Hz) to each of three perpendicular directions for 2 hours.
Thereafter, the unit shall be visually examined.
The specimen shall be subjected to 125 2 C for 1000 hours in a
thermostatic bath without load and then stored at room temperature and
normal humidity for 1 to 2 hours. Thereafter, the change of V
CmA
shall be
measured.
After being continuously applied the Maximum Allowable Voltage at 85
2 C for 1000 hours, the specimen shall be stored at room temperature and
normal humidity for 1 to 2 hours. Thereafter, the change of V
CmA
shall be
measured.
The specimen shall be subjected to 40 2 C, 90 to 95% RH for 1000 hours
without load and then stored at room temperature and normal humidity for 1
to 2 hours. Thereafter, the change of V
CmA
shall be measured.
The specimen shall be subjected to 40 2 C, 90 to 95% RH and the
Maximum Allowable Voltage for1000 hours and then stored at room
temperature and normal humidity for 1 to 2 hours. Thereafter, the change of
V
CmA
shall be measured.
The specimen shall be subjected to 40 2 C without load for1000 hours
and then stored at room temperature and normal humidity for 1 to 2 hours.
Thereafter, the change of V
CmA
shall be measured.
The following temperature cycle shall be repeated five times and then stored
at room temperature and normal humidity for 1 to 2 hours. The change of
V
CmA
and mechanical damage
shall be examined.
After each lead shall be dipped into a solder bath of 260 5 C to a point
2.0 to 2.5mm from the body of the unit, using shielding board (t 1.5mm),
be held there for 10 1s (5 series:5 1s) and then be stored at room
temperature and normal humidity for 1 to 2 hours.
The change of V
CmA
and mechanical damage shall be examined.
After dipping the terminals to a depth of approxirnately 3 mm from the body
in a soldering bath of 235 5 C for 2 0.5seconds, the terminal shall be
visually examined.
Terminal diameter
Force
0.6mm, 0.8mm 4.9N(0.5kgf)
1.0mm 9.8N(1.0kgf)
Step Temperature( C)
Period(minutes)
1 40 3 30 3
2 Room temperature 15 3
3 125 2 30 3
4 Room temperature 15 3
Approximately 95% of
the terminals shall be covered
uniformly with new solder
V
CmA
/V
CmA
No remarkable
mechanical damage
5%
No remarkable
mechanical damage
V
CmA
/V
CmA
No remarkable
mechanical damage
5%
V
CmA
/V
CmA
5%
V
CmA
/V
CmA
10%
V
CmA
/V
CmA
10%
V
CmA
/V
CmA
5%
V
CmA
/V
CmA
5%
相關PDF資料
PDF描述
2BZX84C36A surface mount silicon Zener diodes
2BZX84C4V3A surface mount silicon Zener diodes
2BZX84C4V7A surface mount silicon Zener diodes
2BZX84C5V1A surface mount silicon Zener diodes
2BZX84C5V6A surface mount silicon Zener diodes
相關代理商/技術參數
參數描述
2BT6 功能描述:開關配件 Spare Boot for Booted Act.22 mm, Blue RoHS:否 制造商:C&K Components 類型:Cap 用于:Pushbutton Switches 設計目的:
2BT7 功能描述:開關配件 Spare Boot for Flush Act.22 mm,Clear RoHS:否 制造商:C&K Components 類型:Cap 用于:Pushbutton Switches 設計目的:
2BT8 功能描述:開關配件 Spare Boot for Booted Act.22 mm,Yellow RoHS:否 制造商:C&K Components 類型:Cap 用于:Pushbutton Switches 設計目的:
2BTX 制造商:ALTECH 制造商全稱:Altech corporation 功能描述:Boots for 22 mm Booted Actuators 2BTx (x=color)
2BU03 功能描述:斷路器 .3A MCB B CHAR 480Y/277VAC UL 508 RoHS:否 制造商:Phoenix Contact 產品:Device Circuit Breakers 產品類型:Thermomagnetic 電流額定值:2 A 電壓額定值 AC:240 V, 277 V 電壓額定值 DC:50 V 極數:1 Pole 執行器類型:Slide 電路功能:Trip Free 系列:CB TM1 工作溫度范圍:- 30 C to + 60 C 照明:No
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*