- 您現在的位置：買賣IC網 > PDF目錄371415 > 27010 (Texas Instruments, Inc.) Li-Ion AND Li-Pol BATTERY GAS GAUGE IC FOR PORTABLE APPLICATIONS (bqJUNIOR) PDF資料下載
參數資料
| 型號： | 27010 |
| 廠商： | Texas Instruments, Inc. |
| 英文描述： | Li-Ion AND Li-Pol BATTERY GAS GAUGE IC FOR PORTABLE APPLICATIONS (bqJUNIOR) |
| 中文描述： | 鋰離子和鋰聚合物電池電量監(jiān)測計芯片的便攜式應用（bqJUNIOR） |
| 文件頁數： | 17/30頁 |
| 文件大?。?/td> | 337K |
| 代理商： | 27010 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁當前第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁
www.ti.com
Time-to-Full Registers (TTFL/TTFH) — Address 0x18/0x19
This register pair reports calculated time-to-full at the measured charge rate. The time computed at the average
current charge rate is extended by 50% to estimate the effect of the current taper. TTF is reported in minutes.
The equation for TTF is:
Standby Current Registers (SIL/SIH) — Address 0x1A/0x1B
This register pair reports measured standby current through the sense resistor. The standby current is an
adaptive measurement. Initially, the register pair reports the standby current programmed in EEPROM and after
spending some time in standby, the register pair reports the measured standby current. The register value is
updated every 5.12 seconds when the measured current is above the DMF threshold and is less than or equal
to 2x the initial programmed standby current value. Each new SI value is computed as follows:
Standby Time-to-Empty Registers (STTEL/STTEH) — Address 0x1C/0x1D
This register pair reports calculated time-to-empty at the measured standby current value. This value is based
on the nominal available charge and the standby current. STTE is reported in minutes. STTE is calculated by:
Compensated End-of-Discharge Registers (CEDVL/CEDVH) – Address 0x20/0x21
The EDV1 threshold can be compensated for discharge rate and temperature. The compensated, or computed,
EDV1 threshold is displayed in this register pair. The CEDV display is only updated during discharge. There is a
floor set for the EDV1 threshold. The EDV1 threshold will be the greater of the computed CEDV threshold and
EDVF + 32 mV. CEDV is displayed in millivolts. The host system has read-only access to this register pair.
Time-to-Empty at Constant Power Registers (TTECPL/TTECPH) – Address 0x26/0x27
TTECP is the time-to-empty in minutes with a constant-power load. TTECP is equal to the TTE constant-current
value scaled to reflect a future drop in battery voltage that would cause the load current to increase. The
calculation assumes a linear voltage drop down to EDVF, yielding a conservative (smaller) run-time than
expected.
Cycle Count Since Learning Cycle Registers (CYCLL/CYCLH) — Address 0x28/0x29
CYCL is the cycle count since the last learning cycle. Each count indicates an increment of CYCT since there
was a learning cycle. This register is cleared every time there is a learning cycle. When this count reaches 32, it
forces the CI flag in FLAGS to a 1. The host system has read-only access to this register pair.
Cycle Count Total Registers (CYCTL/CYCTH) — Address 0x2A/0x2B
CYCT is the cycle count since a full reset. A full reset clears this register. Each count indicates a cumulative
discharge equal to the Design Capacity (256 * ILMD). The host system has read-only access to this register pair.
bq27010, bq27210
SLUS707B–APRIL 2006–REVISED JANUARY 2007
TTF = 60 * 1.50 * (LMD-NAC) / AI
The host system has read-only access to this register pair.
SI
NEW
= (15/16) * SI
OLD
+ (1/16) * AI
This filter function allows the reported standby current to shift towards the actual measured current with a time
constant of approximately 67 seconds. The value is reported with a resolution of 3.57 μV per bit. Use the
following equation to convert the value to mA, where R
S
is the sense resistor value in milliohms:
Standby Load Current = (256 * SIH + SIL) * (3.57 / R
S
)
The host system has read-only access to this register pair.
STTE = 60 * NAC/SI
The host system has read-only access to this register pair.
TTECP = TTE * (VOLT + EDVF) / (2 * VOLT)
The host system has read-only access to this register pair.
17
Submit Documentation Feedback
相關PDF資料 |
PDF描述 |
|---|---|
| 27210 | Li-Ion AND Li-Pol BATTERY GAS GAUGE IC FOR PORTABLE APPLICATIONS (bqJUNIOR) |
| 270KD05JX | 11 to 460 Volts Varistor 0.7 to 29 Joule |
| 271KD05JX | 11 to 460 Volts Varistor 0.7 to 29 Joule |
| 270KD05NX | 4 to 460 Volts Varistor 0.20 to 22.5 Joule |
| 271KD05NX | 4 to 460 Volts Varistor 0.20 to 22.5 Joule |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 27-010 | 制造商:Distributed By MCM 功能描述:3.5mm F to 1/4 in M Stereo Adaptor 制造商:MCM 功能描述:COMPUTERS; Body Style:Straight Adapter; Convert From:3.5mm Female; Convert To:0.25" Male; Pin Size:3.5mm |
| 270-10 | 功能描述:金屬膜電阻器 - 透孔 10ohms 1% 50PPM RoHS:否 制造商:IRC 電阻:63.4 kOhms 容差:1 % 功率額定值:100 mW 電壓額定值:200 V 溫度系數:100 PPM / C 端接類型:Axial 工作溫度范圍: 尺寸:2.3 mm Dia. x 6.4 mm L 封裝:Bulk |
| 270-10.2 | 功能描述:金屬膜電阻器 - 透孔 10.2ohms 1% 50PPM RoHS:否 制造商:IRC 電阻:63.4 kOhms 容差:1 % 功率額定值:100 mW 電壓額定值:200 V 溫度系數:100 PPM / C 端接類型:Axial 工作溫度范圍: 尺寸:2.3 mm Dia. x 6.4 mm L 封裝:Bulk |
| 270-10.2/AP | 功能描述:金屬膜電阻器 - 透孔 USE 270-10.2/AP-RC 50PPM RoHS:否 制造商:IRC 電阻:63.4 kOhms 容差:1 % 功率額定值:100 mW 電壓額定值:200 V 溫度系數:100 PPM / C 端接類型:Axial 工作溫度范圍: 尺寸:2.3 mm Dia. x 6.4 mm L 封裝:Bulk |
| 270-10.2/AP-RC | 功能描述:金屬膜電阻器 - 透孔 10.2ohms 1% 50PPM RoHS:否 制造商:IRC 電阻:63.4 kOhms 容差:1 % 功率額定值:100 mW 電壓額定值:200 V 溫度系數:100 PPM / C 端接類型:Axial 工作溫度范圍: 尺寸:2.3 mm Dia. x 6.4 mm L 封裝:Bulk |
發(fā)布緊急采購，3分鐘左右您將得到回復。