- 您現在的位置：買賣IC網 > PDF目錄371401 > 250D-5 (Electronic Theatre Controls, Inc.) THERMOPILE TYPE INFRARED SENSOR PDF資料下載
參數資料
| 型號： | 250D-5 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | THERMOPILE TYPE INFRARED SENSOR |
| 中文描述： | 熱電型紅外傳感器 |
| 文件頁數： | 39/44頁 |
| 文件大?。?/td> | 669K |
| 代理商： | 250D-5 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁當前第39頁第40頁第41頁第42頁第43頁第44頁
39
Reliability
ZENAMIC
Characteristics
Test Methods
Criterion
Robustness of
Terminations
(Tensile)
Robustness of
Terminations
(Bending)
Humidity
(Steady State)
Vibration
Solderability
Resistance to
Soldering Heat
High Temperature
Storage/Dry Heat
High Temperature
Load/
Dry Heat Load
Low Temperature
Storage/Cold
Damp Heat Load/
Humidity Load
Temperature
Cycle
Mechanical
Environmental
After gradual applying of the force specified below and keeping the unit fixed
for 10 seconds, the terminal shall be visually examined for any damage.
Terminal diameter
Force
0.6mm, 0.8mm 9.8N(1.0kgf)
1.0mm 19.6N(2.0kgf)
The unit shall be secured with its terminal kept vertical and the force
specified below shall be applied in the axial direction.
The terminal shall gradually be bent by 90
in one direction, then 90
in the
opposite direction, and again back to the original position.
The damage of the terminal shall be visually examined.
After repeated applying of a single harmonic vibration (amplitude:0.75mm,
double amplitude:1.5mm) with 1 minute vibration frequency cycle (10 Hz to
55 Hz to 10Hz) to each of three perpendicular directions for 2 hours.
Thereafter, the unit shall be visually examined.
The specimen shall be subjected to 125 2 C for 1000 hours in a
thermostatic bath without load and then stored at room temperature and
normal humidity for 1 to 2 hours. Thereafter, the change of V
CmA
shall be
measured.
After being continuously applied the Maximum Allowable Voltage at 85
2 C for 1000 hours, the specimen shall be stored at room temperature and
normal humidity for 1 to 2 hours. Thereafter, the change of V
CmA
shall be
measured.
The specimen shall be subjected to 40 2 C, 90 to 95% RH for 1000 hours
without load and then stored at room temperature and normal humidity for 1
to 2 hours. Thereafter, the change of V
CmA
shall be measured.
The specimen shall be subjected to 40 2 C, 90 to 95% RH and the
Maximum Allowable Voltage for1000 hours and then stored at room
temperature and normal humidity for 1 to 2 hours. Thereafter, the change of
V
CmA
shall be measured.
The specimen shall be subjected to 40 2 C without load for1000 hours
and then stored at room temperature and normal humidity for 1 to 2 hours.
Thereafter, the change of V
CmA
shall be measured.
The following temperature cycle shall be repeated five times and then stored
at room temperature and normal humidity for 1 to 2 hours. The change of
V
CmA
and mechanical damage
shall be examined.
After each lead shall be dipped into a solder bath of 260 5 C to a point
2.0 to 2.5mm from the body of the unit, using shielding board (t 1.5mm),
be held there for 10 1s (5 series:5 1s) and then be stored at room
temperature and normal humidity for 1 to 2 hours.
The change of V
CmA
and mechanical damage shall be examined.
After dipping the terminals to a depth of approxirnately 3 mm from the body
in a soldering bath of 235 5 C for 2 0.5seconds, the terminal shall be
visually examined.
Terminal diameter
Force
0.6mm, 0.8mm 4.9N(0.5kgf)
1.0mm 9.8N(1.0kgf)
Step Temperature( C)
Period(minutes)
1 40 3 30 3
2 Room temperature 15 3
3 125 2 30 3
4 Room temperature 15 3
Approximately 95% of
the terminals shall be covered
uniformly with new solder
V
CmA
/V
CmA
No remarkable
mechanical damage
5%
No remarkable
mechanical damage
V
CmA
/V
CmA
No remarkable
mechanical damage
5%
V
CmA
/V
CmA
5%
V
CmA
/V
CmA
10%
V
CmA
/V
CmA
10%
V
CmA
/V
CmA
5%
V
CmA
/V
CmA
5%
相關PDF資料 |
PDF描述 |
|---|---|
| 252CT-4 | THERMOPILE TYPE INFRARED SENSOR |
| 25KD-5 | THERMOPILE TYPE INFRARED SENSOR |
| 250JB-L | Single Phase Bridge Rectifiers(單相橋式整流器) |
| 250R15C101A6T | C-SERIES HIGH FREQUENCY CHIP CAPACITORS |
| 250R15C101AV4T | C-SERIES HIGH FREQUENCY CHIP CAPACITORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 250DBL-22F1 | 制造商:Misc 功能描述: |
| 250DC-5X | 制造商:TE Connectivity 功能描述: |
| 250DFC6 | 制造商:TE Connectivity 功能描述: |
| 250DFC6-P | 功能描述:電磁干擾直通濾波器 250A 1000nF DC Filter -Class Y4 RoHS:否 制造商:Tusonix 電容:0.027 uF 電壓額定值:50 V 電路類型: 最大直流電流: 最大直流電阻: 工作溫度范圍:- 55 C to + 125 C 系列:4403 螺紋大小:4-40 UNC-2A |
| 250DFC6-Q | 功能描述:電磁干擾直通濾波器 250A 3300nF DC Filter -Class Y4 RoHS:否 制造商:Tusonix 電容:0.027 uF 電壓額定值:50 V 電路類型: 最大直流電流: 最大直流電阻: 工作溫度范圍:- 55 C to + 125 C 系列:4403 螺紋大小:4-40 UNC-2A |
發布緊急采購，3分鐘左右您將得到回復。