- 您現在的位置：買賣IC網 > PDF目錄1887 > 20-101-1319 (Rabbit Semiconductor)MINCORE MODULE RCM6710 PDF資料下載
參數資料
| 型號： | 20-101-1319 |
| 廠商： | Rabbit Semiconductor |
| 文件頁數： | 112/119頁 |
| 文件大?。?/td> | 0K |
| 描述： | MINCORE MODULE RCM6710 |
| 產品培訓模塊： | Enabling Remote Devices Overview |
| 標準包裝： | 1 |
| 系列： | MiniCore™ |
| 模塊/板類型： | MPU 核心模塊 |
| 適用于相關產品： | RCM6710 |
| 其它名稱： | 316-1188 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁第73頁第74頁第75頁第76頁第77頁第78頁第79頁第80頁第81頁第82頁第83頁第84頁第85頁第86頁第87頁第88頁第89頁第90頁第91頁第92頁第93頁第94頁第95頁第96頁第97頁第98頁第99頁第100頁第101頁第102頁第103頁第104頁第105頁第106頁第107頁第108頁第109頁第110頁第111頁當前第112頁第113頁第114頁第115頁第116頁第117頁第118頁第119頁
MiniCore RCM5700/RCM6700 User’s Manual
92
F.2 TCP/IP Primer on IP Addresses
Obtaining IP addresses to interact over an existing, operating, network can involve a number of
complications, and must usually be done with cooperation from your ISP and/or network systems
administrator. For this reason, it is suggested that the user begin instead by using a direct connec-
tion between a PC and the Interface Board using a CAT 4/5 Ethernet cable or a simple arrange-
ment with a hub.
In order to set up this direct connection, the user will have to use a PC without networking, or dis-
connect a PC from the corporate network, or install a second Ethernet adapter and set up a sepa-
rate private network attached to the second Ethernet adapter. Disconnecting your PC from the
corporate network may be easy or nearly impossible, depending on how it is set up. If your PC
boots from the network or is dependent on the network for some or all of its disks, then it probably
should not be disconnected. If a second Ethernet adapter is used, be aware that Windows TCP/IP
will send messages to one adapter or the other, depending on the IP address and the binding order
in Microsoft products. Thus you should have different ranges of IP addresses on your private net-
work from those used on the corporate network. If both networks service the same IP address,
then Windows may send a packet intended for your private network to the corporate network. A
similar situation will take place if you use a dial-up line to send a packet to the Internet. Windows
may try to send it via the local Ethernet network if it is also valid for that network.
The following IP addresses are set aside for local networks and are not allowed on the Internet:
10.0.0.0 to 10.255.255.255, 172.16.0.0 to 172.31.255.255, and 192.168.0.0 to 192.168.255.255.
The Interface Board uses a 10/100Base-T type of Ethernet connection, which is the most common
scheme. The RJ-45 connectors are similar to U.S. style telephone connectors, except they are
larger and have 8 contacts.
An alternative to the direct connection using a CAT 4/5 Ethernet cable is a direct connection using
a hub. The hub relays packets received on any port to all of the ports on the hub. Hubs are low in
cost and are readily available. The RCM5700/RCM6700 uses 10/100Mps Ethernet, so the hub or
Ethernet adapter can be a 10 Mbps unit or a 10/100 Mbps unit.
In a corporate setting where the Internet is brought in via a high-speed line, there are typically
machines between the outside Internet and the internal network. These machines include a combi-
nation of proxy servers and firewalls that filter and multiplex Internet traffic. In the configuration
below, the MiniCore could be given a fixed address so any of the computers on the local network
would be able to contact it. It may be possible to configure the firewall or proxy server to allow
hosts on the Internet to directly contact the controller, but it would probably be easier to place the
controller directly on the external network outside of the firewall. This avoids some of the config-
uration complications by sacrificing some security.
相關PDF資料 |
PDF描述 |
|---|---|
| 20-668-0024 | IC CPU RABBIT4000 128-LQFP |
| 5AGXMB3G6F31C6NES | IC ARRIA V FPGA 362K 896FBGA |
| 5CGXFC7D7F31C8NES | IC CYCLONE V FPGA 150K 896-FBGA |
| 668-0003-C | IC CPU RABBIT2000 30MHZ 100PQFP |
| 668-0011 | IC MPU RABIT3000A 55.5MHZ128LQFP |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 20-101-1320 | 功能描述:以太網模塊 RCM6750 MiniCore RoHS:否 制造商:Lantronix 產品:Device Servers 數據速率:300 bps to 921.6 kbps, 10 Mbps, 100 Mbps 接口類型:Ethernet, Serial 工作電源電壓:5 V to 15 V 工作電源電流:133 mA to 400 mA 最大工作溫度:+ 70 C |
| 20-101-1321 | 功能描述:以太網模塊 RCM6760 MiniCore RoHS:否 制造商:Lantronix 產品:Device Servers 數據速率:300 bps to 921.6 kbps, 10 Mbps, 100 Mbps 接口類型:Ethernet, Serial 工作電源電壓:5 V to 15 V 工作電源電流:133 mA to 400 mA 最大工作溫度:+ 70 C |
| 20-101-1322 | 功能描述:網絡模塊 RCM6600W Cloud Mod Ethr to Wi-Fi Bridge RoHS:否 制造商:Digi International 產品:ZigBee to Ethernets 處理器類型: 頻率: 隨機存取存儲器: 閃光: 數據速率: 接口類型:Ethernet, RF 工作電源電壓:5 V 最大工作溫度:+ 40 C 尺寸:70 mm x 95 mm x 32 mm |
| 20-101-1323 | 功能描述:網絡模塊 RCM6600W Cloud Mod Ethr to Wi-Fi Bridge RoHS:否 制造商:Digi International 產品:ZigBee to Ethernets 處理器類型: 頻率: 隨機存取存儲器: 閃光: 數據速率: 接口類型:Ethernet, RF 工作電源電壓:5 V 最大工作溫度:+ 40 C 尺寸:70 mm x 95 mm x 32 mm |
| 20-101-1328 | 功能描述:模塊化系統 - SOM RCM3710 Core Module RoHS:否 制造商:Digi International 外觀尺寸:ConnectCore 9P 處理器類型:ARM926EJ-S 頻率:150 MHz 存儲容量:8 MB, 16 MB 存儲類型:NOR Flash, SDRAM 接口類型:I2C, SPI, UART 工作電源電壓:3.3 V 最大工作溫度:+ 85 C 尺寸:1.97 in x 1.97 in x 6.1 in |
發布緊急采購，3分鐘左右您將得到回復。