- 您現在的位置：買賣IC網 > PDF目錄68805 > 110IMX7-03-9DM 1-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE PDF資料下載
參數資料
| 型號： | 110IMX7-03-9DM |
| 元件分類： | 電源模塊 |
| 英文描述： | 1-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 9/18頁 |
| 文件大?。?/td> | 299K |
| 代理商： | 110IMX7-03-9DM |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁當前第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁
Board Mountable
DC-DC Converters
IMX 7 Series
Edition 6/5.2000
17/18
AC-DC
front
end
DC-DC
con-
verter
Mains
Fuse
Battery
Earth
connection
Suppressor
diode
SELV
Earth
connection
+
–
~
10004
Fig. 27
Schematic safety concept. Use fuse, suppressor diode
and earth connection as per table: Safety concept leading
to an SELV output circuit
.
Table 16: Insulation concept leading to an SELV output circuit
Conditions Front end
DC-DC converter
Result
Supply
Minimum required grade
Maximum
Minimum required safety
Measures to achieve the
Safety status of
voltage
of isolation, to be provided DC output
status of the front end
specified safety status of the
the DC-DC
by the AC-DC front end,
voltage
output circuit
converter output
including mains supplied
from the
circuit
battery charger
front end 1
Mains
Basic
≤60 V
Earthed SELV circuit 2
Operational insulation (pro-
SELV circuit
≤250 V AC
vided by the DC-DC converter)
ELV circuit
Input fuse 3 output suppressor
Earthed SELV
>60 V
Hazardous voltage
diode(s) 4, and earthed
circuit
secondary circuit
output circuit(s) 2
Double or reinforced
≤60 V
SELV circuit
Operational insulation (pro-
SELV circuit
vided by the DC-DC converter)
>60 V
TNV-2 circuit
Supplementary insulation,
Double or reinforced insu-
based on the maximum input
lated unearthed hazardous
voltage (provided by the
voltage secondary circuit 5
DC-DC converter)
1 The front end output voltage should match the specified input voltage range of the DC-DC converter.
2 The earth connection has to be provided by the installer according to the relevant safety standard, e.g. IEC/EN 60950.
3 The installer shall provide an approved fuse (type with the lowest rating suitable for the application) in a non-earthed input line directly
at the input of the DC-DC converter (see fig.:
Schematic safety concept). For UL’s purpose, the fuse needs to be UL-listed. See also:
Input Fuse.
4 Each suppressor diode should be dimensioned in such a way, that in the case of an insulation fault the diode is able to limit the output
voltage to SELV (<60 V) until the input fuse blows (see fig.:
Schematic safety concept).
5 Has to be insulated from earth by basic insulation according to the relevant safety standard, based on the maximum output voltage
from the front end.
Safety of operator accessible output circuit
If the output circuit of a DC-DC converter is operator acces-
sible, it shall be an SELV circuit according to IEC/EN 60950
related safety standards.
The insulation concept table below shows some possible
installation configurations, compliance with which causes
the output circuit of the DC-DC converter to be an SELV cir-
cuit according to IEC/EN 60950 up to a configured output
voltage (sum of nominal voltages if in series or +/– configu-
ration) of 46 V.
However, it is the sole responsibility of the installer to en-
sure the compliance with the relevant and applicable safety
regulations. More information is given in:
Technical Infor-
mation: Safety.
Description of Options
Table 17: Survey of options
Option
Function
Characteristics
-8
Operational temperature range
TA = –40...85°C
Extended temperature range. Excludes option D.
D
Signal Out OK
Available for single output units. Excludes option -8.
M
Surface mount version, SMD
Excludes option C.
C
C-pinout
Excludes option M as well as galvanic isolation between output 1
and 2 of double output units. Not available for 70/110 IMX 7 types.
Option -8
Extension of the temperature range from standard
–25...71
°C to –40...85°C. The modules will provide full out-
put power with free air convection cooling. UL recognition
up to 80
°C. This option excludes option D.
相關PDF資料 |
PDF描述 |
|---|---|
| 110IMX7-24-24-8 | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 110IMX7-24-24-9 | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 110IMX7-15-15-8M | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 110IMX7-03-9M | 1-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
| 110IMX7-12-12-8 | 2-OUTPUT 7 W DC-DC REG PWR SUPPLY MODULE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 110IMX7-05-05-8 | 功能描述:DC/DC轉換器 7W (2x 5V) DC Input (60-150V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 110IMX7-05-05-8G | 功能描述:DC/DC轉換器 RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 110IMX7-05-05-9 | 制造商:POWER-ONE 制造商全稱:Power-One 功能描述:7 Watt DC-DC Converters |
| 110IMX7-05-8 | 功能描述:DC/DC轉換器 7W (5V) DC Input (60-150V) RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
| 110IMX7-05-8G | 功能描述:DC/DC轉換器 RoHS:否 制造商:Murata 產品: 輸出功率: 輸入電壓范圍:3.6 V to 5.5 V 輸入電壓（標稱）: 輸出端數量:1 輸出電壓（通道 1）:3.3 V 輸出電流（通道 1）:600 mA 輸出電壓（通道 2）: 輸出電流（通道 2）: 安裝風格:SMD/SMT 封裝 / 箱體尺寸: |
發布緊急采購，3分鐘左右您將得到回復。