- 您現在的位置：買賣IC網 > PDF目錄373749 > TWL2214CA High voltage fast-switching NPN power transistor PDF資料下載
參數資料
| 型號： | TWL2214CA |
| 英文描述： | High voltage fast-switching NPN power transistor |
| 中文描述： | 電源管理IC和鋰離子電池充電控制 |
| 文件頁數： | 27/36頁 |
| 文件大?。?/td> | 511K |
| 代理商： | TWL2214CA |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁當前第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
SLVS321A
–
OCTOBER 2001
–
REVISED JANUARY 2002
27
POST OFFICE BOX 655303
DALLAS, TEXAS 75265
APPLICATION INFORMATION
control register
—
FCR1 (1BH)
BIT
NAME
DESCRIPTION
7
CHGSTR
Set this bit to 1 to start the charger operation. This bit is cleared if the charger is terminated. (Refer to
status register table below for terminated conditions)
6
ADC ENABLE
Set this bit to 1 to enable ADC operation, 0 to stop.
5
ADC FUNCTION
Set this bit to 1 to have ADC operate continuously. Set to 0 to have ADC to operate one cycle only.
4
ADBV
Set this bit to 1 to enable the VBAT input channel to ADC. Clear this bit to 0 to disable the input channel.
Set this bit to 1 to enable the VTS input channel to ADC. Clear this bit to 0 to disable the input channel.
3
VTS
2
ADCIN1
Set this bit to 1 to enable the ADCIN1 input channel.
1
ADCIN2
Set this bit to 1 to enable the ADCIN2 input channel.
0
IRQ
Status of IRQ terminal (refer to IRQ operation section).
ADC has four input channels (ADBV, VTS, ADCIN1, and ADCIN2). Each channel can be enabled or disabled
individually. The selected channel must be enabled before ADC FUNCTION and ADC ENABLE bits are
enabled, the channel is included in the ADC operation.
IRQ control/status
The TWL2214CA device uses IRQ signal to inform the external controller about the exception condition of the
V
CHG
input and the charger status. Bit 0 reflects the state of the IRQ signal. IRQ occurs in the following five
conditions:
1.
V
CHG
returns to operating range from nonoperating range.
V
CHG
goes out of range from operating range.
Battery error
—
occurs only during the charging cycle.
2.
3.
4.
Battery temperature out of range
—
occurs only during the charging cycle. The charger is suspended
temporarily. IRQ is cleared when the temperature returns to normal and the charger resumes automatically.
5.
Charge complete.
The controller must clear the IRQ signal by writing 0 to bit 0 in the interrupt service routine, except in the VBOT
condition. The controller may miss the next interrupt if it fails to write the 0. In the VBOT condition, the
TWL2214CA device clears the IRQ when the condition goes away.
相關PDF資料 |
PDF描述 |
|---|---|
| TX-1033S | TX-1033S |
| TX-S | SMALL POLARIZED RELAY WITH HIGH SENSITIVITY 50mW |
| TXC-20049-DCMM | N-channel 25V - 0.0068O - 60A - DPAK - IPAK STripFET™ III Power MOSFET |
| TXC-20153-DCMM | N-channel 30V - 0.0059 Ohm - 70A - DPAK / IPAK STripFET III Power MOSFET |
| TXC06303AIBG | N-CHANNEL 24V - 0.010 Ohm - 40A DPAK/IPAK ULTRA LOW GATE CHARGE STRIPFET POWER MOSFET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TWL2214CAPFB | 制造商:Rochester Electronics LLC 功能描述:POWER SUPPLY MANAGEMENT IC:LION - Bulk 制造商:Texas Instruments 功能描述:CHGR LI-ION/LI-POL 150MA 2.8V 48TQFP - Tape and Reel |
| TWL2214CAPFBR | 制造商:Rochester Electronics LLC 功能描述:POWER SUPPLY MANAGEMENT IC:LION - Bulk 制造商:Texas Instruments 功能描述:CHGR LI-ION/LI-POL 150MA 2.8V 48TQFP - Tape and Reel |
| TWL2217CGGMR | 制造商:Texas Instruments 功能描述: |
| TWL2217CZQER | 制造商:Texas Instruments 功能描述: |
| TWL3014CGGMR | 制造商:Fairchild Semiconductor Corporation 功能描述: |
發布緊急采購，3分鐘左右您將得到回復。