- 您現在的位置：買賣IC網 > PDF目錄372454 > TISP61089BD-S (Electronic Theatre Controls, Inc.) TISP61089B High Voltage Ringing SLIC Protector PDF資料下載
參數資料
| 型號： | TISP61089BD-S |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | TISP61089B High Voltage Ringing SLIC Protector |
| 中文描述： | TISP61089B高壓振鈴用戶接口保護 |
| 文件頁數： | 12/22頁 |
| 文件大小： | 411K |
| 代理商： | TISP61089BD-S |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁
OCTOBER 2000 - REVISED FEBRUARY 2005
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.
TISP61089B High Voltage Ringing SLIC Protector
‘1089 Section 4.5.5 - Test Generators (Continued)
The exception to these two conditions of independence and limit waveshape values is the alternative IEEE C.62.41, 1.2/50-8/20 combination
wave generator which may be used for testing in ‘1089 Sections 4.5.7, 4.5.8 and 4.5.9. Here, the quoted waveshape values are nominal with
defined tolerance. The open-circuit voltage waveshape is 1.2
μ
s
±
0.36
μ
s front time and 50
μ
s
±
10
μ
s duration. The short-circuit current
waveshape is 8
μ
s+1.0
μ
s, -2.5
μ
s front time and 20
μ
s+8
μ
s, -4
μ
s duration. The generator fictive source impedance (peak open-circuit
voltage divided by peak short-circuit current) is 2.0
±
0.25
.
To get the same peak short-circuit currents as the 2/10 generator, for the same peak open-circuit voltage setting, ‘1089 specifies that the
1.2/50-8/20 generator be used with external resistors for current limiting and sharing. When working into a finite resistive load, the delivered
1.2/50-8/20 generator current waveshape moves towards the 1.2/50 voltage waveshape. Thus, although the 1.2/50-8/20 delivered peak
current is similar to the 2/10 generator, the much longer current duration means that a much higher stress is imposed on the equipment
protection circuit. This can cause fuses to operate which are perfectly satisfactory on the normal 2/10 generator. Testing with the 1.2/50-8/20
generator gives higher stress levels than the 2/10 generator and, because it is seldom used, will not be covered in this analysis.
Figure 14. Longitudinal (also Called Common Mode) Testing
Test Generator
Output 1
Ring
Return
EUT
(Equipment
Under Test)
Ground
Tip
Output 2
V1
V2
AI6XCK
Figure 15. Transverse (also Called Differential or Metallic) Testing
Test Generator
Output 1
Ring
Return
EUT
(Equipment
Under Test)
Ground
Tip
Output 2
V1
Test Generator
Output 1
Ring
Return
EUT
(Equipment
Under Test)
Ground
Tip
Output 2
V2
AI6XCM
相關PDF資料 |
PDF描述 |
|---|---|
| TISP61089BDR-S | TISP61089B High Voltage Ringing SLIC Protector |
| TISP6L7591 | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP6L7591DR-S | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TISP6L7591DR | DUAL FORWARD-CONDUCTING P-GATE THYRISTORS PROGRAMMABLE OVERVOLTAGE PROTECTORS |
| TL064 | LOW POWER J-FET QUAD OPERATIONAL AMPLIFIERS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| TISP61089BGDR-S | 功能描述:PROTECTOR PROGRAMMABLE SLIC RoHS:是 類別:過電壓，電流，溫度裝置 >> TVS - 晶閘管 系列:- 產品變化通告:Product Discontinuation 19/Jul/2012 標準包裝:2,500 系列:- 電壓 - 擊穿:400V 電壓 - 斷路:320V 電壓 - 導通狀態:4V 電流 - 峰值脈沖(8 x 20µs):250A 電流 - 峰值脈沖(10 x 1000µs):80A 電流 - 保持 (Ih):150mA 元件數:1 電容:29pF 封裝/外殼:DO-214AA，SMB 包裝:帶卷 (TR) |
| TISP61089BSDR-S | 功能描述:SCR PROTECTOR - QUAD PROGRAMMABLE RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP61089D | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP61089DR | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
| TISP61089DR-S | 功能描述:SCR Dual P Gate Forward Conducting RoHS:否 制造商:STMicroelectronics 最大轉折電流 IBO:480 A 額定重復關閉狀態電壓 VDRM:600 V 關閉狀態漏泄電流（在 VDRM IDRM 下）:5 uA 開啟狀態 RMS 電流 (It RMS): 正向電壓下降:1.6 V 柵觸發電壓 (Vgt):1.3 V 最大柵極峰值反向電壓:5 V 柵觸發電流 (Igt):35 mA 保持電流（Ih 最大值）:75 mA 安裝風格:Through Hole 封裝 / 箱體:TO-220 封裝:Tube |
發布緊急采購，3分鐘左右您將得到回復。