- 您現在的位置：買賣IC網 > PDF目錄380765 > STLC5411P (意法半導體) 2B1Q U INTERFACE DEVICE PDF資料下載
參數資料
| 型號： | STLC5411P |
| 廠商： | 意法半導體 |
| 英文描述： | 2B1Q U INTERFACE DEVICE |
| 中文描述： | 2B1Q U接口裝置 |
| 文件頁數： | 45/72頁 |
| 文件大?。?/td> | 739K |
| 代理商： | STLC5411P |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁當前第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
MOB = 1: All
interrupts issued
RXM56
RXEOC
masked. It is still possible to read
these registers via RXOH.
CTC
CorruptedTransmit CRC Control
from
RXM4,
and
CR5
are
CTC = 0: Allows the normal calculation of the
CRCfor the transmitteddata tothe line.
CTC = 1: The CRC result transmitted to the line
in the next Superframe is inverted.
This ensure transmission of corrupted
CRC as long as CTCequal 1.
Configuration Register 5 (CR5)
Significant in GCI only.
After reset: FFH
IO4
IO3
IO2
IO1
D4
D3
D2
D1
IO4, IO3, IO2, IO1
Input/Outputselect for I/Opins
(14, 15, 16, 18)
IOi = 1: IOi pin is selected as an input. An on-
chip pull up resistor ensures a stable
logical 1 at power-on reset or if IOi pin
is not connectedto stable source.
IOi = 0: IOi pin is selectedas an output.
Each
I/O
pin
independentlyfrom the others.
D4, D3, D2, D1
I/O pin logical level com-
mand/status.
D4, D3, D2, D1 bits are associated with IO4, IO3,
IO2,IO1 pins respectively. WhenIOi pinis selected
asan output, the associatedDibit canbe written to
control the logical level of the output; Di equals 1
commands a high level on IOi. When IOi pin is se-
lected as an input, the associated Di bit indicates
the status of the input; Di equals one indicates a
highlevel on IOi. CR5registeris bufferedin thein-
terrupt stack each time a statuschange is detected
on an input. It is also possible to read-backat any
timeCR5.
can
be
selected
Configuration register 6 (CR6)
After reset: 0FH
T15E
ACTA
UT
PUPAUT
QM
AIS
TFB0
RFS LFS
T15E
Timer 15 seconds extension
T15E = 0: The on chip T4 or T6 timer is done for
the ANSI standard:15 seconds.
T15E = 1: The on chip T4 or T5 timer is
extendedto 20 seconds.
Note: the T15D bit in CR3 register enables or
desables the
T4/T5 timer
theT15Ebit.
independently of
ACTAUT:
ActivationAutomatic
ACTAUT = 1: If UID is powered up, a 10KHz
tone
from the line
activation without need of extra
commands (like AR), except when
QM (Quiet mode) is enterred.
ACTAUT = 0 A detection of a 10KHz tone from
the
line
activation: UID waits a primitive
command (normaly AR).
starts the
does
not
start
the
PUPAUT
PUPAutomatic
PUPAUT = 1: If UID is powered up, a 10KHz
tone
from the line
automaticpower up of the UID.
Notes if ACTAUT is set to 1, from a power down
state a 10KHz tone automatically starts the acti-
vation.
allows an
PUPAUT = 0: A detection of a 10KHz tone from
the line does not power up the
device: UID waits a PUP primitive
command.
QM
Quietmode.
QM =1: has the same effect of the QM primitive
command enterred in TXACT register.
An or logic is done with the QM bit and
the QM primitive. The goal of this bit is
to allow a quiet mode for an UID in
power down state in some applications.
QM =0: no effect.
AIS
AnalogInterface Select.
AIS = 1: selects an analog interface using 27mh
transformer.
AIS = 0: selects an analog interface using 15mh
transformer
TFB0
Transmit febe equal 0
TFB0 = 0: A permanent febe bit = 0 is sent on
the line as long as TFB0 = 0
TFB0 = 1: The febe bit sent on the line is
normaly computed.
RFS
Remotefebe select.
Please report to the figure 10. RFS is usefull in
report application to transfertor not the anomalies
STLC5411
45/72
相關PDF資料 |
PDF描述 |
|---|---|
| STLC5411 | 2B1Q U Interface Device(2BIQ U接口裝置) |
| STLC5412 | 2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC5412FN | 2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC5412P | 2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC5444 | Quad Feed Power Supply(ISDN四饋電電源) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| STLC5412 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC5412FN | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC5412P | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC54155 | 功能描述:電信集成電路 155MBit Coaxial Intr RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray |
| STLC5432 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2Mbit CEPT & PRIMARY RATE CONTROLLER DEVICE |
發布緊急采購，3分鐘左右您將得到回復。