- 您現在的位置：買賣IC網 > PDF目錄380765 > STLC5411FN (意法半導體) 2B1Q U INTERFACE DEVICE PDF資料下載
參數資料
| 型號： | STLC5411FN |
| 廠商： | 意法半導體 |
| 英文描述： | 2B1Q U INTERFACE DEVICE |
| 中文描述： | 2B1Q U接口裝置 |
| 文件頁數： | 6/72頁 |
| 文件大小： | 739K |
| 代理商： | STLC5411FN |
第1頁第2頁第3頁第4頁第5頁當前第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁第52頁第53頁第54頁第55頁第56頁第57頁第58頁第59頁第60頁第61頁第62頁第63頁第64頁第65頁第66頁第67頁第68頁第69頁第70頁第71頁第72頁
PIN FUNCTIONS
(noSpecific Microwire / GCIMode)
Note: all pin number are referred to PlasticDIP28 package.
Pin
1, 4
Name
LO+, LO-
In/Out
Out, Out
Description
Transmit 2B1Q signaldifferential outputs to the line transformer. When
used with an appropriate 1:1.5 step-up transformer and the proper line
interface circuit the line signal conforms to the output specifications in ANSI
standard with anominal pulse amplitude of 2.5 Volts.
Receive 2B1Q signal differential inputs from the line transformer.
Positive power supply input for the analog and digital sections, which must
be +5 Volts +/-5% and must be directlyconnected together.
Negative power supply pins, which must be connected together close to
the device.
All digitaland analog signals are referred to these pins, which are normally
at the system Ground.
(LT configuration only)
This pin is an open drain output normally in the high impedance state which
pulls low when B1 and B2 time-slots are active. It can be used to enable the
Tristate control of a backplane line-driver.
(NT configuration only)
15.36 MHz clock output which isfrequency locked to the received line
signal activeas soon as UID is powered up except in NT1 Auto
configuration (active only if S line activation is requested)
The output of the crystal oscillator, which should be connected to one end
of the crystal, if used. Otherwise, this pin must be left not connected.
The master clock input, which requires either a parallel resonance crystal to
be tied between this pin and XTAL2, or a logic level clock input from a
stable source. This clock does not need to be synchronized to the digital
interface clocks (FSa, BCLK).Crystal specifications: 15.36 MHz +/-50ppm
parallel resonant; Rs
≤
20ohms; load with 33pF to GND each side.
MICROWIRE selection: When set high, MICROWIRE control interface is
selected. When set low, GCI interface is selected.
2, 3
5, 8
LI+, LI-
VCCA, VCCD
In, In
In, In
24, 9
23
GNDA,GNDD1
GNDD2
In, In
In
10
TSRb
Out
SCLK
Out
20
XTAL2
Out
21
XTAL1
In
28
MW
In
PIN FUNCTIONS
(specific Micro Wire mode)
Pin
6
Name
FSa
In/Out
In Out
Description
Input or Outputdepending of the CMS bit in CR1 register, FSa is a 8 KHz
clock which indicates the start of the frame on Bx when FSa is input,or Bx
and Br when FSa is output.
Input or Output,the location of FSa relative to the frame on Bx orBx and Br
depens of DDM bit in CR1 register, also the selected format.
Input or Outputdepending of the CMS bit in CR1 register, FSb is a 8 KHz
clock which indicates the start of the frame on Br when it is an input. When
it is an output, FSb is a 8 KHz pulse conforming with the selected format
and always indicating the second 64Kbit/sec channel of the frame on Br.
Input or Output,the location of FSb relative to the frame on Br depends of
DDM bit in CR1 register,also the selected format.
2B+D datas tristate output. Datas received from the line areshifted out on
the rising edge (at the BCLK frequency or the half BCLK frequency if format
4 is selected) during the assigned time slot. Br is in high impedance state
outside the assignedtime slot and during the assigned time slot of the
channel if it is disabled.
When D channel port is enabled, only B1 B2 are on Br.
7
FSb
In Out
11
Br
Out
STLC5411
6/72
相關PDF資料 |
PDF描述 |
|---|---|
| STLC5411P | 2B1Q U INTERFACE DEVICE |
| STLC5411 | 2B1Q U Interface Device(2BIQ U接口裝置) |
| STLC5412 | 2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC5412FN | 2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC5412P | 2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| STLC5411P | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2B1Q U INTERFACE DEVICE |
| STLC5412 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC5412FN | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC5412P | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:2B1Q U INTERFACE DEVICE ENHANCED WITH DECT MODE |
| STLC54155 | 功能描述:電信集成電路 155MBit Coaxial Intr RoHS:否 制造商:STMicroelectronics 類型:Telecom IC - Various 工作電源電壓:4.75 V to 5.25 V 電源電流: 工作溫度范圍:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體:PQFP-100 封裝:Tray |
發布緊急采購，3分鐘左右您將得到回復。