- 您現在的位置：買賣IC網 > PDF目錄380765 > STLC3080 (意法半導體) SUBSCRIBER LINE INTERFACE CIRCUIT PDF資料下載
參數資料
| 型號： | STLC3080 |
| 廠商： | 意法半導體 |
| 英文描述： | SUBSCRIBER LINE INTERFACE CIRCUIT |
| 中文描述： | 用戶線路接口電路 |
| 文件頁數： | 14/23頁 |
| 文件大小： | 201K |
| 代理商： | STLC3080 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁當前第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁
The flow-chart in Fig.A1 describes the sequence
of state machine supervising the STLC3080 op-
eration when the control is set for Active mode,
D0 D1 D2= 1 X X.
The state machine is a synchronous sequential
circuit internally clocked by a free running oscilla-
tor ; the ringing frequency applied at the CKRING
input is used to generate the
WTIME=128xCKRING necessary for proper op-
eration as further described.
External control is supposed to be set for Active
mode :
D0 D1 D2= 1 X X.
OH-HI : line status flag , set High when Off-Hook
condition is detected in High ImpedanceFeeding;
it differs from OHK because it’s sensitive to the
longitudinalcurrent.
OHK: line status flag , set High when Off-Hook
condition is detected in Stand-By or in Active
mode; it differs from OH-HI for its immunity to lon-
gitudinal current .
DLY: time-out flag, it is set High to resume, with
a given delay, the High ImpedanceFeeding when
an On-Hook condition (OHK=Low) is detected in
Stand-Byor Activestate.
1) Note that in this section the word ”mode” has
been used to indicate the operating status set
with D0, D1 and D2 pin: the word ”state” has
been used to indicate an internal status of the
finite state machine.
long time delay
Flow-chart Description
H) A Reset condition, generated at Power On or
setting RES pin Low,
condition.
A) High Impedance Feeding is entered after the
Active mode word is setand its maintained un-
forces a Power-Down
til
HI=High); in this case Stand-Bystate entered.
B) Stand-By state is set
check of the Off-Hook status of the line before
entering
Active
state.
(OH=High),
immediately Active state is en-
tered.
If not , Stand-By state remains set for a time
period WTIME generated through a counter
that times out after 128 x CKRING ; DLY=High
signals the state machine the time out to re-
sume the High ImpedanceFeeding.
An OHK = High detected during WTIMEwill im-
mediatelyenter Active state.
C) Active state is set for conversation
DET=Low signals to the controller the Off-Hook
conditionof theline.
The status remains set as long as OHK=High
(Off-Hook).
D) When OHK=Low is detected (On Hook), DET
is immediately set High whereas Active state is
maintained for the period WTIME; when it ex-
pires
DLY is set High and High Impedance
Feeding is resumed.
If, during WTIME, OHK=High is detected Off
Hook), the state is returned to C) , i.e. Active
with DET=Low.
E) RingingmodeissetwhenD0=D1=0andD2 =1.
After ring trip detection the SLIC is automat-
ically set in Active state (reverse or normal po-
larity according to D2 value set before ringing
mode). Ring trip detection is indicated by DET
pin: when it happens the SW must remove the
ringing mode word (001) and set the Active
modeword (100).
F) On-Hook Tx mode is selected when D0 = 0,
D1 = 1 and D2 = X.
After Off Hook detection the SLIC is automat-
ically set in Activestate.
an Off-Hook condition is detected (OH-
to perform a validity
If
it
is
confirmed
and
APPENDIX A
STLC3080
14/23
相關PDF資料 |
PDF描述 |
|---|---|
| STLC5046 | PROGRAMMABLE FOUR CHANNEL CODEC AND FILTER |
| STLC5048 | FULLY PROGRAMMABLE FOUR CHANNEL CODEC AND FILTER |
| STLC5411FN | 2B1Q U INTERFACE DEVICE |
| STLC5411P | 2B1Q U INTERFACE DEVICE |
| STLC5411 | 2B1Q U Interface Device(2BIQ U接口裝置) |
相關代理商/技術參數 |
參數描述 |
|---|---|
| STLC3080EVAL | 功能描述:網絡開發工具 Eval Board STLC3080 RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| STLC3080R-EVAL | 功能描述:網絡開發工具 Eval Board STLC30R80 RoHS:否 制造商:Rabbit Semiconductor 產品:Development Kits 類型:Ethernet to Wi-Fi Bridges 工具用于評估:RCM6600W 數據速率:20 Mbps, 40 Mbps 接口類型:802.11 b/g, Ethernet 工作電源電壓:3.3 V |
| STLC3080S | 功能描述:射頻無線雜項 Subscriber Ln Intrfc RoHS:否 制造商:Texas Instruments 工作頻率:112 kHz to 205 kHz 電源電壓-最大:3.6 V 電源電壓-最小:3 V 電源電流:8 mA 最大功率耗散: 工作溫度范圍:- 40 C to + 110 C 封裝 / 箱體:VQFN-48 封裝:Reel |
| STLC3080TR | 功能描述:電信線路管理 IC SUBSCRIBER CIRCUIT RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray |
| STLC3085 | 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Integrated Pots Interface for Home Access Gateway and WLL |
發布緊急采購，3分鐘左右您將得到回復。