參數資料
型號: STLC3065
廠商: 意法半導體
英文描述: WLL SUBSCRIBER LINE INTERFACE CIRCUIT
中文描述: 環路用戶線路接口電路
文件頁數: 7/27頁
文件大?。?/td> 194K
代理商: STLC3065
Table 2 shows all the possible combinations be-
tween switches configurations and operating
modes.
A detailed description of each configuration can
be found in the ”O(jiān)PERATING MODES” descrip-
tion section.
OPERATINGMODES
Power Down (PWD)
D0
D1
D2
P1
P2
DET
DET1
DET2
0
0
X
0
0
disable
disable
disable
DC CHARACTERISTIC & SUPERVISION
When this mode is selected both 2W ports
(TIP1/RING1and TIP2/RING2) are in high imped-
ance; all switches Sw1 to Sw6 are open (see
fig.1)
The SLIC core is switched off and the line detec-
tors are disabled therefore the off-hook condition
cannot be detected.
This mode can be selected in emergency condi-
tion when it is necessary to cut any current deliv-
ered to the line.
This mode is also forced by STLC3065in case of
thermaloverload(Tj > 140
°
C).
In this case the device goes back to the previous
status as soon as the junction temperature de-
crease underthe hysteresisthreshold.
AC CHARACTERISTICS
Both the 2W ports (TIP1/RING1and TIP2/RING2)
are set in high impedance,the TX outputbufferis
a low impedance output, no AC transmission is
possible.
High ImpedanceFeeding(HI-Z)
D0
D1
D2
P1
P2
DET
DET1
DET2
0
0
X
1
1
off/hk
line 1+2
off/hk
line 1
off/hk
line 2
0
0
X
0
1
off/hk
line 2
disable
off/hk
line 1
0
0
X
1
0
off/hk
line 1
off/hk
line 1
disable
DC CHARACTERISTIC & SUPERVISION
This operating mode is normally selected when
the telephoneis in on-hookin order to monitorthe
line status keeping the power consumption at the
minimum.
The SLIC core of STLC3065 is
(see fig.1 or FUNCTIONAL DIAGRAM); the two
line series switches (Sw1; Sw2) are open. De-
pending on P1, P2 the 2W ports (TIP1/RING1
and TIP2/RING2) can be in high impedance or
connected to
the built in
(2x1500
) via SW3T and SW5R or SW4T and
SW6R.
P1
controls
TIP1/RING1
TIP2/RING2(seeFig.1 and Table 2).
When this mode is selectednormally both P1, P2
bitsshould be set to one.
The output voltage in on-hook condition is equal
to the self generated batteryvoltage(-50Vtyp).
When off-hook occurs on 2W port 1 (2) the cur-
rent flowing through the RING1(2) wire activates
the DET1 (2_) detector indicating the line status
change. When DET1 or DET2 are activated also
the DET becomeactive (low logiclevel).
The off-hook threshold in HI-Z mode is the same
value programmedin ACTIVEmode.
The DC characteristic in HI-Z mode is just equal
to the self generated battery with 2x(1500W+Rp)
in PWD mode
feeding resistors
and
P2
controls
Where:
”O(jiān)pen”:
the line port termination is in high impedance.
”To P.S. via Res”:
the TIP(n) wire is connected to BGND through a 1500
resistor , the RING(n) wire is
connected to VBAT by a 1500
resistor. Thecurrent flowing in the second resistoris used
to detect the off-hook .
”To Buffer”:
the TIP(n) wire and RING(n) wire are connected to the SLIC core line driver and the off-
hook detection is performed using the SLIC core supervision circuit that drives the DET
output.
”300
μ
A bias”:
the TIP(n) wire is connected to BGND through a 1500
resistor , the RING(n) wire is
biased by a 300
μ
A current generator to negative battery (Vbat)
Note: see also Appendix C
STLC3065
7/27
相關PDF資料
PDF描述
STLC3065QTR WLL SUBSCRIBER LINE INTERFACE CIRCUIT
STLC3065Q WLL SUBSCRIBER LINE INTERFACE CIRCUIT
STLC3080 SUBSCRIBER LINE INTERFACE CIRCUIT
STLC5046 PROGRAMMABLE FOUR CHANNEL CODEC AND FILTER
STLC5048 FULLY PROGRAMMABLE FOUR CHANNEL CODEC AND FILTER
相關代理商/技術參數
參數描述
STLC3065Q 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:WLL SUBSCRIBER LINE INTERFACE CIRCUIT
STLC3065QTR 制造商:STMicroelectronics 功能描述:
STLC3075 制造商:STMicroelectronics 功能描述:
STLC3075_09 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Integrated POTS interface for home access gateway and WLL
STLC3080 功能描述:電信線路管理 IC Subscriber Ln Intrfc RoHS:否 制造商:STMicroelectronics 產品:PHY 接口類型:UART 電源電壓-最大:18 V 電源電壓-最小:8 V 電源電流:30 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:VFQFPN-48 封裝:Tray