參數資料
型號: STLC2500
廠商: 意法半導體
英文描述: BLUETOOTH⑩ SINGLE CHIP
中文描述: 單芯片藍牙⑩
文件頁數: 13/23頁
文件大小: 241K
代理商: STLC2500
13/23
STLC2500
– Identification of the system clock frequency (13 MHz, 26MHz, 19.2 MHz or 38.4 MHz)
– Identification of the low power clock (3.2 KHz, 16.384 KHz, 32 KHz or 32.768 KHz)
Remark: The STLC2500 assumes that the low power clock is available at all times.
7.6
The user can program the GPIOs as external interrupt sources.
Interrupts
7.7
To save power, three low power modes are supported.
Depending of the Bluetooth and of the Host's activity, the STLC2500 autonomously decides to use Deep
Sleep Mode, Sleep Mode or active mode.
Complete Power Down is entered only after an explicit command from the Host.
Low power modes
Table 18. Low power modes
Some examples for the usage of the low power modes:
7.7.1
The STLC2500 is in active mode with a Bluetooth connection, once the connection is concluded, SNIFF
or PARK is programmed. Once one of these two states is entered, the STLC2500 goes into Sleep Mode.
After that, the Host may decide to place the STLC2500 in Deep Sleep Mode by putting the UART LINK in
low power mode. The Deep Sleep Mode allows for lower power consumption. When the STLC2500 needs
to send or receive a packet (e.g. at TSNIFF or at the beacon instant), it requires the clock and it goes into
active mode for the needed transmission/reception. Immediately afterwards, it will go back to Deep Sleep
Mode. If some HCI transmission is needed, the UART link will be reactivated, using one of the two ways
explained in 7.8, and the STLC2500 will move from Deep Sleep Mode to Sleep Mode.
SNIFF OR PARK
7.7.2
When only inquiry scan or page scan is enabled, the STLC2500 will go in Sleep Mode or Deep Sleep
Mode outside the receiver activity. The selection between Sleep Mode and Deep Sleep Mode depends on
the UART activity like in SNIFF or PARK.
INQUIRY/PAGE SCAN
Low power mode
Sleep Mode
Description
The STLC2500:
- Accepts HCI commands from the Host.
- Supports all types of Bluetooth links.
- Can transfer data over Bluetooth links.
- Dynamically switches between sleep and active mode when needed.
- The system clock is still active in part of the design.
- Parts of the chip can be dynamically powered off depending on the Bluetooth activity.
The STLC2500:
- Does not accept HCI commands from the Host.
- Supports page- and inquiry scans.
- Supports Bluetooth links that are in Sniff, Hold or Park.
- Does not transfer data over Bluetooth links.
- Dynamically switches between deep sleep and active mode during Bluetooth activity.
- The system clock is not active in any part of the design.
- Parts of the chip can be dynamically powered off depending on the Bluetooth activity.
The STLC2500 is effectively powered down:
- No Bluetooth activity is supported.
- The HCI interface is shut down.
- The system clock is not active in any part of the design.
- Most parts of the chip are completely powered off.
- RAM content is not maintained (initialisation is required at wakeup).
Deep Sleep Mode
Complete Power Down
相關PDF資料
PDF描述
STLC3055 WLL & ISDN-TA SUBSCRIBER LINE INTERFACE CIRCUIT
STLC3055Q WLL & ISDN-TA SUBSCRIBER LINE INTERFACE CIRCUIT
STLC3055QTR WLL & ISDN-TA SUBSCRIBER LINE INTERFACE CIRCUIT
STLC3065 WLL SUBSCRIBER LINE INTERFACE CIRCUIT
STLC3065QTR WLL SUBSCRIBER LINE INTERFACE CIRCUIT
相關代理商/技術參數
參數描述
STLC2500A 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Bluetooth Single Chip
STLC2500ATR 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:Bluetooth Single Chip
STLC2500C 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:BluetoothTM EDR Single Chip
STLC2500DB-EDB2G 制造商:ST Ericsson 功能描述:PCB DAUGHTERBOARD WITH STLC2500DB DEVICE ASSEMBLED?????? - Bulk 制造商:ST-Ericsson 功能描述:PCB DAUGHTERBOARD WITH STLC2500DB DEVICE ASSEMBLED?????? - Bulk 制造商:ST-Ericsson 功能描述:STLC2500DB-EDB2G Full Bluetooth 3.0 + HS Lisbon
STLC2541 制造商:STMicroelectronics 功能描述:EVALBOARD - Bulk