- 您現在的位置：買賣IC網 > PDF目錄299926 > SST26WF032-80-4I-QAE (SILICON STORAGE TECHNOLOGY INC) 32M X 1 SPI BUS SERIAL EEPROM, PDSO8 PDF資料下載
參數資料
| 型號： | SST26WF032-80-4I-QAE |
| 廠商： | SILICON STORAGE TECHNOLOGY INC |
| 元件分類： | PROM |
| 英文描述： | 32M X 1 SPI BUS SERIAL EEPROM, PDSO8 |
| 封裝： | 6 X 5 MM, ROHS COMPLIANT, WSON-8 |
| 文件頁數： | 5/36頁 |
| 文件大小： | 1339K |
| 代理商： | SST26WF032-80-4I-QAE |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
2010 Silicon Storage Technology, Inc.
S71409-01-000
01/10
13
1.8V Serial Quad I/O (SQI) Flash Memory
SST26WF032
Advance Information
Reset-Enable (RSTEN) and Reset (RST)
The Reset operation is used as a system (software) reset that puts the device in normal operating
Ready mode. This operation consists of two commands: Reset-Enable (RSTEN) and Reset (RST).
To reset the SST26WF032, the host drives CE# low, sends the Reset-Enable command (66H), and
drives CE# high. Next, the host drives CE# low again, sends the Reset command (99H), and drives
CE# high, see Figure 7.
The Reset operation requires the Reset-Enable command followed by the Reset command. Any com-
mand other than the Reset command after the Reset-Enable command will disable the Reset-Enable.
A successful command execution will reset the burst length to 8 Bytes and all the bits in the Status reg-
ister to their default states, except for bit 4 (WPLD) and bit 5 (SEC). A device reset during an active
Program or Erase operation aborts the operation, which can cause the data of the targeted address
range to be corrupted or lost. Depending on the prior operation, the reset timing may vary. Recovery
from a Write operation requires more latency time than recovery from other operations.
Figure 7: Reset sequence
1409 F05.0
MODE 3
CLK
SIO(3:0)
CE#
MODE 3
C1
C3 C2
C0
MODE 0
MODE 3
MODE 0
TCPH
Note: C[1:0] = 66H; C[3:2] = 99H
相關PDF資料 |
PDF描述 |
|---|---|
| SST48CF048-C1 | 24M X 16 FLASH 3.3V PROM CARD, 100 ns, XMA50 |
| SST49LF008C-33-4C-NHE | 1M X 8 FLASH 3V PROM, 11 ns, PQCC32 |
| SSU-131MAT | SLIDE SWITCH, SP3T, LATCHED, 0.3A, 4VDC, SURFACE MOUNT-RIGHT ANGLE |
| SSU-121ART | SLIDE SWITCH, SPDT, LATCHED, 0.3A, 4VDC, SURFACE MOUNT-RIGHT ANGLE |
| SSW-102-22-F-D-VS | 4 CONTACT(S), FEMALE, STRAIGHT TWO PART BOARD CONNECTOR, SURFACE MOUNT, SOCKET |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SST26WF032-80-4I-QAE-T | 制造商:Microchip Technology Inc 功能描述:1.65 TO 1.95V 32MBIT SERIAL QUAD I/O FLASH - Tape and Reel |
| SST26WF032-80-4I-S2AE | 功能描述:閃存 1.65 to 1.95V 32Mbit Serial Quad I/O Flsh RoHS:否 制造商:ON Semiconductor 數據總線寬度:1 bit 存儲類型:Flash 存儲容量:2 MB 結構:256 K x 8 定時類型: 接口類型:SPI 訪問時間: 電源電壓-最大:3.6 V 電源電壓-最小:2.3 V 最大工作電流:15 mA 工作溫度:- 40 C to + 85 C 安裝風格:SMD/SMT 封裝 / 箱體: 封裝:Reel |
| SST26WF032-80-4I-S2AE-T | 制造商:Microchip Technology Inc 功能描述:1.65 TO 1.95V 32MBIT SERIAL QUAD I/O FLASH - Tape and Reel |
| SST270 | 功能描述:JFET 45V 2mA RoHS:否 制造商:ON Semiconductor 晶體管極性:N-Channel 漏極電流（Vgs=0 時的 Idss）:50 mA 漏源電壓 VDS:15 V 閘/源擊穿電壓: 漏極連續電流:50 mA 配置: 安裝風格: 封裝 / 箱體:SC-59 封裝:Reel |
| SST270-E3 | 功能描述:JFET 45V 2mA RoHS:否 制造商:ON Semiconductor 晶體管極性:N-Channel 漏極電流（Vgs=0 時的 Idss）:50 mA 漏源電壓 VDS:15 V 閘/源擊穿電壓: 漏極連續電流:50 mA 配置: 安裝風格: 封裝 / 箱體:SC-59 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。