參數資料
型號： SC16C850IBS
廠商： NXP Semiconductors N.V.
元件分類： 收發器
英文描述： 2.5 V to 3.3 V UART, 5 Mbit-s (max.) with 128-byte FIFOs, infrared (IrDA), and 16 mode or 68 mode parallel bus interface
封裝： SC16C850IBS<SOT617-1 (HVQFN32)|<<http://www.nxp.com/packages/SOT617-1.html<1<Always Pb-free,;SC16C850IBS<SOT617-1 (HVQFN32)|<<http://www.nxp.com/packages/SOT617-1.html<
文件頁數： 8/55頁
文件大?。?/td> 394K
代理商： SC16C850IBS
SC16C850
All information provided in this document is subject to legal disclaimers.
NXP B.V. 2010. All rights reserved.
Product data sheet
Rev. 2 — 11 November 2010
8 of 55
NXP Semiconductors
SC16C850
2.5 to 3.3 V UART with 128-byte FIFOs and IrDA encoder/decoder
[1]
HVQFN32 package die supply ground is connected to both V
SS
pin and exposed center pad. V
SS
pin must be connected to supply
ground for proper device operation. For enhanced thermal, electrical, and board level performance, the exposed pad needs to be
soldered to the board using a corresponding thermal pad on the board and for proper heat conduction through the board, thermal vias
need to be incorporated in the PCB in the thermal pad region.
RTS
D2
21
O
Request to Send (active LOW).
A logic 0 on the RTS pin indicates the
transmitter has data ready and waiting to send. Writing a logic 1 in the modem
control register MCR[1] will set this pin to a logic 0, indicating data is available.
After a reset this pin will be set to a logic 1.
UART receive data.
The RX signal will be a logic 1 during reset, idle (no
data), or when not receiving data. During the local loopback mode, the RX
input pin is disabled and TX data is connected to the UART RX input,
internally.
UART transmit data.
The TX signal will be a logic 1 during reset, idle (no
data), or when the transmitter is disabled. During the local loopback mode, the
TX output pin is disabled and TX data is internally connected to the UART RX
input.
Power supply input.
Signal and power ground.
Crystal or external clock input.
Functions as a crystal input or as an external
clock input. A crystal can be connected between this pin and XTAL2 to form an
internal oscillator circuit. Alternatively, an external clock can be connected to
this pin to provide custom data rates (see
Section 6.9 “Programmable baud
rate generator”
). See
Figure 8
.
Output of the crystal oscillator or buffered clock.
(See also XTAL1.)
Crystal oscillator output or buffered clock output. Should be left open if an
external clock is connected to XTAL1.
RX
C6
6
I
TX
C5
7
O
V
DD
V
SS
XTAL1
A1, D4
C2, C4
A6
28
13
[1]
10
I
I
I
XTAL2
A5
11
O
Table 2.
Symbol
Pin description
…continued
Pin
TFBGA36
HVQFN32
Type
Description
相關PDF資料
PDF描述
SC16C850IET 2.5 V to 3.3 V UART, 5 Mbit-s (max.) with 128-byte FIFOs, infrared (IrDA), and 16 mode or 68 mode parallel bus interface
SC16C850LIB 1.8 V single UART, 5 Mbit-s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 mode or 68 mode parallel bus interface
SC16C850LIBS 1.8 V single UART, 5 Mbit-s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 mode or 68 mode parallel bus interface
SC16C850LIET 1.8 V single UART, 5 Mbit-s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 mode or 68 mode parallel bus interface
SC16C850SVIBS 1.8 V single UART, 20 Mbit-s (max.) with 128-byte FIFOs, infrared (IrDA), and XScale VLIO bus interface
相關代理商/技術參數
參數描述
SC16C850IBS,128 功能描述:UART 接口集成電路 UART 1-CH 128Byte FIFO 2.5V/3.3V 32Pin RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C850IBS,151 功能描述:UART 接口集成電路 16C 2.5-5V 5MBPS UART 128BFIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C850IBS,157 功能描述:UART 接口集成電路 UART1CH 128Byte FIFO 2.5V/3.3V 32-Pin RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C850IBS/Q900,5 功能描述:UART 接口集成電路 3.3V 1CHAN 5Mbps RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C850IBS/Q900,528 制造商:NXP Semiconductors 功能描述:Cut Tape 制造商:NXP Semiconductors 功能描述:0
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*