- 您現在的位置：買賣IC網 > PDF目錄379352 > SC16C754BIA68 (NXP Semiconductors N.V.) 5 V, 3.3 V and 2.5 V quad UART, 5 Mbit-s (max.) with 64-byte FIFOs PDF資料下載
參數資料
| 型號： | SC16C754BIA68 |
| 廠商： | NXP Semiconductors N.V. |
| 元件分類： | 收發器 |
| 英文描述： | 5 V, 3.3 V and 2.5 V quad UART, 5 Mbit-s (max.) with 64-byte FIFOs |
| 封裝： | SC16C754BIA68<SOT188-2 (PLCC68)|<<http://www.nxp.com/packages/SOT188-2.html<1<Always Pb-free,;SC16C754BIA68<SOT188-2 (PLCC68)|<<http://www.nxp.com/packages/SOT188-2.html& |
| 文件頁數： | 12/51頁 |
| 文件大小： | 253K |
| 代理商： | SC16C754BIA68 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁當前第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁第49頁第50頁第51頁
SC16C754B_4
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 04 — 6 October 2008
12 of 51
NXP Semiconductors
SC16C754B
5 V, 3.3 V and 2.5 V quad UART, 5 Mbit/s (max.) with 64-byte FIFOs
6.3 Software flow control
Software flow control is enabled through the enhanced feature register and the modem
control register. Different combinations of software flow control can be enabled by setting
different combinations of EFR[3:0].
Table 3
shows software flow control options.
Remark:
When using software flow control, the Xon/Xoff characters cannot be used for
data characters.
There are two other enhanced features relating to software flow control:
‘Xon Any’ function (MCR[5]):
Operation will resume after receiving any character
after recognizing the Xoff character. It is possible that an Xon1 character is
recognized as an ‘Xon Any’ character, which could cause an Xon2 character to be
written to the RX FIFO.
Special character (EFR[5]):
Incoming data is compared to Xoff2. Detection of the
special character sets the Xoff interrupt (IIR[4]) but does not halt transmission. The
Xoff interrupt is cleared by a read of the IIR. The special character is transferred to the
RX FIFO.
6.3.1
RX
When software flow control operation is enabled, the SC16C754B will compare incoming
data with Xoff1/Xoff2 programmed characters (in certain cases, Xoff1 and Xoff2 must be
received sequentially). When the correct Xoff character is received, transmission is halted
after completing transmission of the current character. Xoff detection also sets IIR[4] (if
enabled via IER[5]) and causes INT to go HIGH.
To resume transmission, an Xon1/Xon2 character must be received (in certain cases
Xon1 and Xon2 must be received sequentially). When the correct Xon characters are
received, IIR[4] is cleared, and the Xoff interrupt disappears.
Table 3.
EFR[3]
0
1
0
1
X
X
X
1
Software flow control options (EFR[3:0])
EFR[2]
EFR[1]
EFR[0]
0
X
X
0
X
X
1
X
X
1
X
X
X
0
0
X
1
0
X
0
1
0
1
1
TX, RX software flow controls
no transmit flow control
transmit Xon1, Xoff1
transmit Xon2, Xoff2
transmit Xon1, Xon2, Xoff1, Xoff2
no receive flow control
receiver compares Xon1, Xoff1
receiver compares Xon2, Xoff2
transmit Xon1, Xoff1
receiver compares Xon1 or Xon2, Xoff1 or Xoff2
transmit Xon2, Xoff2
receiver compares Xon1 or Xon2, Xoff1 or Xoff2
transmit Xon1, Xon2, Xoff1, Xoff2
receiver compares Xon1 and Xon2, Xoff1 and Xoff2
no transmit flow control
receiver compares Xon1 and Xon2, Xoff1 and Xoff2
0
1
1
1
1
1
1
1
0
0
1
1
相關PDF資料 |
PDF描述 |
|---|---|
| SC16C754BIB80 | 5 V, 3.3 V and 2.5 V quad UART, 5 Mbit-s (max.) with 64-byte FIFOs |
| SC16C754BIBM | 5 V, 3.3 V and 2.5 V quad UART, 5 Mbit-s (max.) with 64-byte FIFOs |
| SC16C850IBS | 2.5 V to 3.3 V UART, 5 Mbit-s (max.) with 128-byte FIFOs, infrared (IrDA), and 16 mode or 68 mode parallel bus interface |
| SC16C850IET | 2.5 V to 3.3 V UART, 5 Mbit-s (max.) with 128-byte FIFOs, infrared (IrDA), and 16 mode or 68 mode parallel bus interface |
| SC16C850LIB | 1.8 V single UART, 5 Mbit-s (max.) with 128-byte FIFOs, infrared (IrDA) and 16 mode or 68 mode parallel bus interface |
相關代理商/技術參數 |
參數描述 |
|---|---|
| SC16C754BIA68,512 | 功能描述:UART 接口集成電路 16CB 2.5V-5V 4CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C754BIA68,518 | 功能描述:UART 接口集成電路 4CH. UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C754BIA68,529 | 功能描述:UART 接口集成電路 16CB 2.5V-5V 4CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
| SC16C754BIA68512 | 制造商:NXP Semiconductors 功能描述:IC QUAD UART FIFO 5MBPS 5.5V LCC-68 |
| SC16C754BIA68-S | 功能描述:UART 接口集成電路 16CB 2.5V-5V 4CH UART 64B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel |
發布緊急采購，3分鐘左右您將得到回復。