參數資料
型號： SC16C550BIA44
廠商： NXP Semiconductors N.V.
元件分類： 收發器
英文描述： 5 V, 3.3 V and 2.5 V UART with 16-byte FIFOs
封裝： SC16C550BIA44<SOT187-2 (PLCC44)|<<http://www.nxp.com/packages/SOT187-2.html<1<week 51, 2004,;SC16C550BIA44<SOT187-2 (PLCC44)|<<http://www.nxp.com/packages/SOT187-2.html&l
文件頁數： 8/48頁
文件大?。?/td> 240K
代理商： SC16C550BIA44
SC16C550B_5
NXP B.V. 2008. All rights reserved.
Product data sheet
Rev. 05 — 1 October 2008
8 of 48
NXP Semiconductors
SC16C550B
5 V, 3.3 V and 2.5 V UART with 16-byte FIFOs
RI
[2]
43
41
39
27
I
Ring indicator.
RI is a modem status signal. Its condition
can be checked by reading bit 6 (RI) of the Modem Status
Register. Bit 2 (
RI) of the Modem Status Register
indicates that RI has changed from a LOW to a HIGH level
since the last read from the Modem Status Register. If the
modem status interrupt is enabled when this transition
occurs, an interrupt is generated.
Request to send.
When active, RTS informs the modem
or data set that the UART is ready to receive data. RTS is
set to the active level by setting the RTS Modem Control
Register bit and is set to the inactive (HIGH) level either as
a result of a Master Reset or during loopback mode
operations or by clearing bit 1 (RTS) of the MCR. This pin
has no effect on the UART’s transmit or receive operation.
Receiver ready.
Receiver Direct Memory Access (DMA)
signaling is available with RXRDY. When operating in the
FIFO mode, one of two types of DMA signaling can be
selected using the FIFO Control Register bit 3 (FCR[3]).
When operating in the 16C450 mode, only DMA mode 0 is
allowed. Mode 0 supports single-transfer DMA in which a
transfer is made between CPU bus cycles. Mode 1
supports multi-transfer DMA in which multiple transfers are
made continuously until the receiver FIFO has been
emptied. In DMA mode 0 (FCR[0] = 0 or FCR[0] = 1,
FCR[3] = 0), when there is at least one character in the
receiver FIFO or Receiver Holding Register, RXRDY is
active (LOW). When RXRDY has been active but there are
no characters in the FIFO or holding register, RXRDY goes
inactive (HIGH). In DMA mode 1 (FCR[0] = 1, FCR[3] = 1),
when the trigger level or the time-out has been reached,
RXRDY goes active (LOW); when it has been active but
there are no more characters in the FIFO or holding
register, it goes inactive (HIGH). This function does not
exist in the HVQFN32 package.
Serial data input.
RX is serial data input from a connected
communications device.
Serial data output.
TX is composite serial data output to a
connected communication device. TX is set to the marking
(HIGH) level as a result of Master Reset.
Transmitter ready.
Transmitter DMA signaling is available
with TXRDY. When operating in the FIFO mode, one of
two types of DMA signaling can be selected using FCR[3].
When operating in the 16C450 mode, only DMA mode 0 is
allowed. Mode 0 supports single-transfer DMA in which a
transfer is made between CPU bus cycles. Mode 1
supports multi-transfer DMA in which multiple transfers are
made continuously until the transmit FIFO has been filled.
This function does not exist in the HVQFN32 package.
2.5 V, 3.3 V or 5 V supply voltage.
Ground voltage.
RTS
36
32
32
21
O
RXRDY
32
29
29
-
O
RX
11
7
10
6
I
TX
13
8
11
7
O
TXRDY
27
23
24
-
O
V
DD
V
SS
44
22
42
18
40
20
28
9, 13
[1]
power
power
Table 2.
Symbol
Pin description
…continued
Pin
PLCC44 LQFP48 DIP40 HVQFN32
Type
Description
相關PDF資料
PDF描述
SC16C550BIB48 5 V, 3.3 V and 2.5 V UART with 16-byte FIFOs
SC16C550BIBS 5 V, 3.3 V and 2.5 V UART with 16-byte FIFOs
SC16C650BIB48 5 V, 3.3 V and 2.5 V UART with 32-byte FIFOs and infrared (IrDA) encoder-decoder
SC16C650BIBS 5 V, 3.3 V and 2.5 V UART with 32-byte FIFOs and infrared (IrDA) encoder-decoder
SC16C652BIBS 5 V, 3.3 V and 2.5 V dual UART, 5 Mbit-s (max.) with 32-byte FIFOs and infrared (IrDA) encoder-decoder
相關代理商/技術參數
參數描述
SC16C550BIA44,512 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550BIA44,518 功能描述:UART 接口集成電路 1CH. UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550BIA44,529 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
SC16C550BIA44512 制造商:NXP Semiconductors 功能描述:IC SINGLE UART FIFO 3MBPS 5.5V LCC44
SC16C550BIA44-S 功能描述:UART 接口集成電路 16CB 2.5V-5V 1CH UART 16B FIFO RoHS:否 制造商:Texas Instruments 通道數量:2 數據速率:3 Mbps 電源電壓-最大:3.6 V 電源電壓-最小:2.7 V 電源電流:20 mA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 封裝 / 箱體:LQFP-48 封裝:Reel
發布緊急采購，3分鐘左右您將得到回復。

采購需求

(若只采購一條型號，填寫一行即可)

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

發布成功！您可以繼續發布采購。也可以進入我的后臺，查看報價

*型號 *數量 廠商 批號 封裝
添加更多采購

我的聯系方式

*
*
*