參數資料
型號: SAF-XC2785X-104F80L
廠商: INFINEON TECHNOLOGIES AG
元件分類: 微控制器/微處理器
英文描述: 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
封裝: 0.50 MM PITCH, GREEN, PLASTIC, LQFP-144
文件頁數: 99/141頁
文件大?。?/td> 1793K
代理商: SAF-XC2785X-104F80L
XC2785X
XC2000 Family / Base Line
Functional Description
Data Sheet
60
V2.1, 2011-07
3.8
Capture/Compare Unit (CAPCOM2)
The CAPCOM2 unit supports generation and control of timing sequences on up to
16 channels with a maximum resolution of one system clock cycle (eight cycles in
staggered mode). The CAPCOM2 unit is typically used to handle high-speed I/O tasks
such as pulse and waveform generation, pulse width modulation (PWM), digital to
analog (D/A) conversion, software timing, or time recording with respect to external
events.
Two 16-bit timers (T7/T8) with reload registers provide two independent time bases for
the capture/compare register array.
The input clock for the timers is programmable to several prescaled values of the internal
system clock, or may be derived from an overflow/underflow of timer T6 in module GPT2.
This provides a wide range or variation for the timer period and resolution and allows
precise adjustments to the application-specific requirements. In addition, an external
count input allows event scheduling for the capture/compare registers relative to external
events.
The capture/compare register array contains 16 dual purpose capture/compare
registers, each of which may be individually allocated to either CAPCOM timer and
programmed for capture or compare function.
All registers have each one port pin associated with it which serves as an input pin for
triggering the capture function, or as an output pin to indicate the occurrence of a
compare event.
When a capture/compare register has been selected for capture mode, the current
contents of the allocated timer will be latched (‘captured’) into the capture/compare
register in response to an external event at the port pin which is associated with this
register. In addition, a specific interrupt request for this capture/compare register is
generated. Either a positive, a negative, or both a positive and a negative external signal
transition at the pin can be selected as the triggering event.
The contents of all registers which have been selected for one of the five compare modes
are continuously compared with the contents of the allocated timers.
When a match occurs between the timer value and the value in a capture/compare
register, specific actions will be taken based on the selected compare mode.
Table 9
Compare Modes
Function
Mode 0
Interrupt-only compare mode;
Several compare interrupts per timer period are possible
Mode 1
Pin toggles on each compare match;
Several compare events per timer period are possible
相關PDF資料
PDF描述
SAK-XC2785X-72F80L 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAK-XC2785X-104F80L 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAF-XC2786X-96F66L66 32-BIT, FLASH, MICROCONTROLLER, PQFP144
SAF-XC2786X-96F80L66 32-BIT, FLASH, 80 MHz, RISC MICROCONTROLLER, PQFP144
SAF-XC886-6FFA5V 8-BIT, FLASH, 24 MHz, MICROCONTROLLER, PQFP48
相關代理商/技術參數
參數描述
SAF-XC2786X-96F66L 制造商:Infineon Technologies AG 功能描述:
SAF-XC822-1FRA 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit Single-Chip Microcontroller
SAF-XC822-1FRA AA 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT
SAF-XC822-1FRI 制造商:INFINEON 制造商全稱:Infineon Technologies AG 功能描述:8-Bit Single-Chip Microcontroller
SAF-XC822-1FRI AA 功能描述:8位微控制器 -MCU 8-Bit Single Chip Microcontroller RoHS:否 制造商:Silicon Labs 核心:8051 處理器系列:C8051F39x 數據總線寬度:8 bit 最大時鐘頻率:50 MHz 程序存儲器大小:16 KB 數據 RAM 大小:1 KB 片上 ADC:Yes 工作電源電壓:1.8 V to 3.6 V 工作溫度范圍:- 40 C to + 105 C 封裝 / 箱體:QFN-20 安裝風格:SMD/SMT