參數資料
型號: SAA7146AHZ
廠商: NXP SEMICONDUCTORS
元件分類: 消費家電
英文描述: Circular Connector; No. of Contacts:66; Series:MS27472; Body Material:Aluminum; Connecting Termination:Crimp; Connector Shell Size:18; Circular Contact Gender:Pin; Circular Shell Style:Wall Mount Receptacle; Insert Arrangement:18-35 RoHS Compliant: No
中文描述: SPECIALTY CONSUMER CIRCUIT, PQFP208
封裝: PLASTIC, SOT-316, SQFP-208
文件頁數: 109/144頁
文件大小: 645K
代理商: SAA7146AHZ
1998 Apr 09
109
Philips Semiconductors
Product specification
Multimedia bridge, high performance
Scaler and PCI circuit (SPCI)
SAA7146A
Table 94
Overview of peak data rates for non-increment (burst) block transfer configurations at 33 MHz PCI clock
Note
1.
These peak data rates could be reached for transfers with large BLOCKLENGTH settings, in a well performing
PCI-bus system with low bus load and an appropriate target system without cycle stretching or interrupts.
No cycle stretching by RDY/DTACK possible.
2.
PROTOCOL
MODE
TIMEOUT
VALUE
WORD
WIDTH
FAST
MODE
TRANSFER
DIRECTION
TARGET SIDE
PEAK DATA
RATE
OVERALL
PEAK DATA
RATE
(1)
Intel/Motorola
(2)
Intel/Motorola
(2)
Intel/Motorola
Intel/Motorola
Intel/Motorola
(2)
Intel/Motorola
0
0
1
3
0
1
16 bit
8 bit
16 bit
16 bit
16 bit
16 bit
enabled
enabled
enabled
enabled
disabled
disabled
R/W
R/W
R/W
R/W
R/W
R/W
33 Mbytes/s
16.5 Mbytes/s
22 Mbytes/s
13.2 Mbytes/s
22 Mbytes/s
16.5 Mbytes/s
23.0 Mbytes/s
13.5 Mbytes/s
17.0 Mbytes/s
11.2 Mbytes/s
17.0 Mbytes/s
13.5 Mbytes/s
It is possible to halt an actual block transfer by external
interrupt. This is achieved by setting the XIRQ_EN bit in
the DEBI_CONFIG register and asserting the GPIO3 pin
input to LOW while an block transfer is active. If the
XRESUME bit is set to 0, this will end the current block
transfer within the next two Dwords. When XRESUME = 1
the transfer will go to a wait state, but the transfer
operation will not end (DEBI_ACTIVE still asserted). When
GPIO3 is de-asserted to HIGH the block transfer will
resume. The contents of DEBI_AD and DEBI_COMMAND
registers are steadily updated on actual address and block
length values during block transfer. Due to this it is
possible to abort the transfer, read back actual status, do
other transfers and resume later with the saved
information. It should be noted that after a Dword aligned
read block transfer (i.e. if
BLOCKLENGTH [1:0] + A16 [1:0] = 4 or A16 [1:0] = 0) the
read back value of the DEBI_AD register points to the
consecutive address of the just filled PCI memory range.
After a Dword unaligned transfer the read back DEBI_AD
value points 1 Dword further (it should be noted that this
also effects the value of the remaining BLOCKLENGTH
after interrupt; A16 target address read back is not effected
by this). RPS is able to react on the GPIO3 pin events.The
16 AD lines are set to 3-state while DEBI is in XIRQ wait
state (XRESUME enabled). To support target devices of
different endian type the swap register has to be
configured.
Fig.37 Endian swapping.
handbook, full pagewidth
3
2
1
0
2
3
0
1
3
2
1
0
4-byte swap
the four bytes in a double word
are swapped
2-byte swap
the two bytes in a 2-byte word
are swapped
0
1
2
3
MHB069
相關PDF資料
PDF描述
SAA7146AH .012UF/400VDC METAL POLY CAP
SAA7146A Multimedia bridge, high performance Scaler and PCI circuit SPCI
SAA7151 Digital multistandard colour decoder with SCART interface DMSD2-SCART
SAA7151B Digital multistandard colour decoder with SCART interface DMSD2-SCART
SAA7157 Clock signal generator circuit for digital TV systems SCGC
相關代理商/技術參數
參數描述
SAA7151 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Digital multistandard colour decoder with SCART interface DMSD2-SCART
SAA7151B 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Digital multistandard colour decoder with SCART interface DMSD2-SCART
SAA7152 制造商:PHILIPS 制造商全稱:NXP Semiconductors 功能描述:Digital Video Comb Filter DCF
SAA7154E/V2/G,557 制造商:NXP Semiconductors 功能描述:
SAA7154H/V2,557 制造商:NXP Semiconductors 功能描述: