- 您現在的位置：買賣IC網 > PDF目錄361325 > QT301 (Electronic Theatre Controls, Inc.) CAPACITANCE TO ANALOG CONVERTER PDF資料下載
參數資料
| 型號： | QT301 |
| 廠商： | Electronic Theatre Controls, Inc. |
| 英文描述： | CAPACITANCE TO ANALOG CONVERTER |
| 中文描述： | 電容模擬轉換器 |
| 文件頁數： | 3/10頁 |
| 文件大小： | 247K |
| 代理商： | QT301 |
2.2 CS / CX Dependency
The signal value is a direct function of Cs and Cx, where Cs
is the fixed sample capacitor, and Cx is the unknown
capacitance. These two values influence device sensitivity,
resolution and response time, making them very important
parameters.
Sensitivity and resolution are also a function of the size,
shape, and composition of the electrode, the composition
and thickness of any dielectric overlaying the electrode, the
composition and aspect of the object being sensed, and the
degree of mutual coupling between the electrode and the
object being sensed.
2.3 Burst Length
The burst length is described by the following formula:
k
Cs
Cs
+
Cx
)
BL
=
ln
(
Where ‘k’ is a constant, typical -0.51 (this may vary slightly
from device to device).
The response is thus a logarithmic curve; each doubling of
Cs increases the signal level and differential sensitivity by a
factor of two. Likewise, doubling Cx reduces the signal level
and differential sensitivity by a factor of two (Figures 6-1, 6-2,
page 8).
2.4 Sync Input
Bursts can be synchronized to external noise sources such
as mains frequency to suppress the effects of interference
coupled from such sources using a circuit such as that
shown in Figure 2-6. By synchronizing with noise sources,
the noise itself becomes highly correlated with the acquired
data, and AC alias components effectively disappear from
the signal. Sync works best on low frequency, highly
repeatable signals, such as mains frequency (50/60 Hz).
Figure 2-2 shows the effect of sync pulses on the burst rate.
A sync signal triggers a burst on the rising edge.
There is a Sync timeout of 100ms as shown in Figure 2-3. If
Sync pulses cease for >100ms, the Sync signal will be
treated as being lost and the device will start to acquire at its
own default rate again. When using the Sync feature it is
important that the Sync pulses are spaced less than 100ms
apart.
Figure 2-2 shows the acquisition burst in relation to Sync
pulses. If no rising edge is detected for 100ms, the QT301
will revert to the default timing shown in Figure 2-1. Figure
2-4 shows the sudden start of a train of Sync pulses and the
effect on the acquisition bursts.
Should the sync signal overclock the acquisition bursts
(Figure 2-5), the device will trigger on the next rising edge
after a delay of Tbd+2.5ms.
The 2.5ms is the minimum gap between bursts is to allow Cs
to properly discharge; Sync is not possible during this interval
nor is it possible to re-sync during a burst.
L
Q
3
QT301 R1.04 21/09/03
Figure 2-2 Acquisition Burst with Sync Signal
Acquisition
Burst
Sync Signal
Figure 2-3 Acquisition Burst: Sync Lost
100ms
Acquisition
Burst
Sync Signal
Figure 2-4 Acquisition Burst: Sync Reacquired
Sync Signal
Acquisition
Burst
Figure 2-5 Sync Overclocked
Sync Signal
Acquisition
Burst
相關PDF資料 |
PDF描述 |
|---|---|
| QT310 | PROGRAMMABLE CAPACITANCE SENSOR IC |
| QT310-D | PROGRAMMABLE CAPACITANCE SENSOR IC |
| QT310-IS | PROGRAMMABLE CAPACITANCE SENSOR IC |
| QT320 | 2 CHANNEL PROGAMMABLE ADVANCED SENSOR IC |
| QT320-D | 2 CHANNEL PROGAMMABLE ADVANCED SENSOR IC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| QT301-D | 功能描述:SENSOR IC CAC ANALOG OUT 8-DIP RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| QT301-IS | 功能描述:SENSOR IC CAC ANALOG OUT 8-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - ADCs/DAC - 專用型 系列:- 產品培訓模塊:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 標準包裝:50 系列:- 類型:數據采集系統（DAS） 分辨率（位）:16 b 采樣率（每秒）:21.94k 數據接口:MICROWIRE?，QSPI?，串行，SPI? 電壓電源:模擬和數字 電源電壓:1.8 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 安裝類型:表面貼裝 封裝/外殼:40-WFQFN 裸露焊盤 供應商設備封裝:40-TQFN-EP（6x6） 包裝:托盤 |
| QT310 | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:PROGRAMMABLE CAPACITANCE SENSOR IC |
| QT310-D | 制造商:Quantum Corp 功能描述:IC TOUCH SENSOR 1CH DIP8 310 |
| QT310-IS | 功能描述:SENSOR IC TOUCH PROG 1CH 8-SOIC RoHS:否 類別:集成電路 (IC) >> 數據采集 - 觸摸屏控制器 系列:QProx™ 標準包裝:96 系列:- 類型:- 觸摸面板接口:- 輸入數/鍵:- 分辨率（位）:- 評估套件:* 數據接口:- 數據速率/采樣率 (SPS，BPS):- 電壓基準:- 電源電壓:- 電流 - 電源:- 工作溫度:- 安裝類型:表面貼裝 封裝/外殼:16-TSSOP（0.173"，4.40mm 寬） 供應商設備封裝:16-TSSOP 包裝:帶卷 (TR) |
發布緊急采購，3分鐘左右您將得到回復。