- 您現在的位置：買賣IC網 > PDF目錄374436 > MHE1205S (CRANE ELECTRONICS INC) DC/DC CONVERTERS 12 AND 28 VOLT INPUT PDF資料下載
參數資料
| 型號： | MHE1205S |
| 廠商： | CRANE ELECTRONICS INC |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | DC/DC CONVERTERS 12 AND 28 VOLT INPUT |
| 中文描述： | 1-OUTPUT 15 W DC-DC REG PWR SUPPLY MODULE |
| 文件頁數： | 1/11頁 |
| 文件大?。?/td> | 148K |
| 代理商： | MHE1205S |
MODELS
VDC O
UTPUT
SINGLE
5
12
15
DUAL
±12
±15
DESCRIPTION
The MHE Series and the MLP Series DC/DC converters offer
the high efficiencies associated with switching regulators, yet have
full isolation and the excellent regulation typical of linear regulators.
No external components are required for operation. MHE Series and
MLP Series converters are built using thick-film hybrid technology,
and are sealed in metal packages for military, aerospace, and other
high-reliability applications. Unscreened models are solder sealed
and are guaranteed to pass a gross leak test (maximum leak rate of
1 x 10
-3
atm.-cc/sec). Environmentally screened models are
hermetically sealed and are screened as described in Section C2.
The MHE Series and MLP Series converters are pulse-width modu-
lated switching regulators operating in the forward mode, with a
nominal switching frequency of 125 to 140 kHz. Isolation is achieved
through the use of a transformer in the forward power circuit, and an
optocoupler is used in the feedback/control loop. The full load output
power is available over the full input voltage range. Short-term tran-
sients of 50 volts will not impair normal operation for 28 volt input
models.
The efficiency is typically greater than 80% over the entire input
voltage range and from approximately 25% of full load to full load.
This feature makes the MHE/MLP Series converters ideal for either
battery or aircraft power applications.
An inhibit function is provided on MHE/MLP Series converters to
allow power shutdown and startup from a logic input. The unit is
inhibited when the inhibit input pin (pin 2) is connected to the input
common (pin 10). The open circuit voltage of the inhibit pin is 8 to
10 VDC for 12 V input models or 11 to 13 VDC for 28 V input
models. During inhibit, the input inhibit pin must sink approximately
1 mA. In the inhibit mode, converter output drops to less than 1 V
and the input current is typically 8 mA.
Automatic current limiting circuitry protects the MHE/MLP Series
converters against short circuits.
MHE/MLP Series converters are rated to operate at full load up to a
case temperature of 85°C, with the output power derated linearly to
zero at 115°C. Because of the unit’s high efficiency, heat sinking
requirements are minimized, but due consideration should be given
to removing self-generated heat when operating the device at
maximum ratings. To increase dissipation, heat conducting material
(PCB, copper sheet, heat sink, etc.) should be brought into contact
with the converter’s baseplate.
When the MHE/MLP Series converters are used in applications
requiring full power operation for extended periods of time, or in
shock and vibration environments, it is highly recommended that the
flange-mount option be used. This option provides improved thermal
transfer capabilities as well as a mechanically secure mounting
configuration.
DC/DC C
ONVERTERS
12
AND
28 V
OLT
I
NPUT
MHE/MLP SERIES
20 WATT
B4-13
Size (max.): Non-flanged 2.125 x 1.125 x 0.495 MHE (case H6) inches
or 0.417 MLP (case H4)
(53.98 x 28.58 x 12.57 (MHE) or 10.59 (MLP) mm)
Flanged 2.910 x 1.125 x 0.495 MHE (case K7) inches
or 0.417 MLP (case K5)
(73.91 x 28.58 x 12.57 (MHE) or 10.59 (MLP) mm)
See Section B8, cases H4, H6, K5, and K7, for dimensions.
50 grams typical
Screening: Standard or ES. See Section C2 for screening options, see
Section A5 for ordering information.
Weight:
F
EATURES
–55°C to +85°C operation
10 to 16 VDC input or
16 to 36 VDC input typical
Fully isolated
Opto-coupler feedback
Fixed frequency 125 kHz typical
Topology – Push-Pull Forward
Transient protection
50 V for up to 50 ms 28 Vin models
Inhibit function
Indefinite short circuit protection
Trimmable output on single models
Up to 83% efficiency
相關PDF資料 |
PDF描述 |
|---|---|
| MHF283R3S | DC/DC CONVERTERS 28 VOLT INPUT |
| MHL0512D | DC/DC CONVERTERS 5 VOLT INPUT |
| MHP27005S | DC/DC CONVERTERS 270 VOLT INPUT |
| MHV12-2.0K1000N | HV-Power Supplies |
| MHV12-2.0K1000P | HV-Power Supplies |
相關代理商/技術參數 |
參數描述 |
|---|---|
| MHE1205SF/ES | 制造商:INTERPOINT 制造商全稱:INTERPOINT 功能描述:DC/DC CONVERTERS 12 AND 28 VOLT INPUT |
| MHE1212SF/ES | 制造商:INTERPOINT 制造商全稱:INTERPOINT 功能描述:DC/DC CONVERTERS 12 AND 28 VOLT INPUT |
| MHE1215SF/ES | 制造商:INTERPOINT 制造商全稱:INTERPOINT 功能描述:DC/DC CONVERTERS 12 AND 28 VOLT INPUT |
| MHE-1310 | 功能描述:固定接線端子 PCB5mm RoHS:否 制造商:Phoenix Contact 產品:Fixed Terminal Blocks 類型:Wire to Board 節距:5.08 mm 位置/觸點數量:2 線規量程:26-16 電流額定值:13.5 A 電壓額定值:250 V 安裝風格:Through Hole 安裝角:Straight 端接類型:Screw 觸點電鍍: |
| MHE-1311 | 功能描述:固定接線端子 PCB5mm RoHS:否 制造商:Phoenix Contact 產品:Fixed Terminal Blocks 類型:Wire to Board 節距:5.08 mm 位置/觸點數量:2 線規量程:26-16 電流額定值:13.5 A 電壓額定值:250 V 安裝風格:Through Hole 安裝角:Straight 端接類型:Screw 觸點電鍍: |
發布緊急采購，3分鐘左右您將得到回復。