- 您現在的位置：買賣IC網 > PDF目錄98004 > LX2207ILD-TR (MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP) 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO12 PDF資料下載
參數資料
| 型號： | LX2207ILD-TR |
| 廠商： | MICROSEMI CORP-ANALOG MIXED SIGNAL GROUP |
| 元件分類： | 電源管理 |
| 英文描述： | 1-CHANNEL POWER SUPPLY SUPPORT CKT, PDSO12 |
| 封裝： | ROHS COMPLIANT, PLASTIC, MLPD-12 |
| 文件頁數： | 13/14頁 |
| 文件大?。?/td> | 399K |
| 代理商： | LX2207ILD-TR |
LX2207
PRODUCTION DATA SHEET
Microsemi
Analog Mixed Signal Group
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 8
Copyright
2007
Rev. 1.0a, 2007-10-08
WWW
.Microse
m
i
.CO
M
Three Level Lithium Ion Battery Charger
TM
APPLICATION NOTE
LAYOUT
In the layout of the Printed Circuit Board (PCB) it is
important to provide a solid path from the IC power and
ground pins to the power and ground planes of the PCB to
provide a good conduction path for heat. This insures the
LX2207 stays cool and can provide the maximum charge
current to minimize the time required to charge the battery.
For stability, and to reduce turn on – turn off transients, it
is important to place capacitors close to the IN and BAT
pins. Use a 10uF capacitor (X5R or X7R dielectric) for this
purpose.
The CMP pin resistor and capacitor should be located
close to the CMP pin. The CMP pin is located next to the
IN pin to facilitate this. The 1K resistor is not required for
stability, but reduces the inrush current into the CMP pin
when the IN voltage transient is applied.
CURRENT PROGRAMMING RESISTORS
The LX2207 has two programming resistors to control
the battery charging current during the constant current
charging mode of the battery charging cycle.
When the
H/L pin is high (selecting the High Current charging mode),
the charge current is determined by the value of the HCP
programming resistor. The maximum charge current is
determined by the programming current at either the HCP
or LCP programming pins (depending on the state of H/L);
the range of each of these channels is identical.
The
programming current is the HCP or LCP pin voltage
(typically 1.25V) divided by the value of the programming
resistor. For example, the HCP current with a 110k resistor
to GND is:
11.4A
110k
1.25
R
1.25
I
HCP
=
Charge Current vs IHCP (or ILCP)
0
200
400
600
800
1000
1200
0.00
50.00
100.00
150.00
IHCP (in uA)
C
h
a
rge
C
u
rr
e
n
t
(i
n
m
A
)
Using the table below it can be seen that for a
programming current value of 11.4A, the corresponding
maximum charge current is 92mA.
The termination current determines the point at which
the charge cycle is terminated and the battery is determined
to be fully charged. The termination current is determined
by the value of the HCP programming current as
determined by the HCP programming resistor. For a value
of IHCP = 11.4A (as was used in the previous example),
the termination current from the chart below can be seen to
be 9mA.
Term ination Current vs IHCP
0
20
40
60
80
100
120
0.00
50.00
100.00
150.00
IHCP (in uA)
Te
rm
in
a
ti
on
C
u
rr
e
n
t
(i
n
m
A
)
The termination current is always roughly 10% of the
maximum charge current set by the HCP resistor.
INDEPENDENT TERMINATION CURRENT PROGRAMMING
For applications where a termination current other than
10% is required, the termination current can be set using
the HCP resistor and the charge current can be set using
the LCP resistor. In this case, the H/L pin is held low so
that the HCP charge mode is never utilized. In this way
the HCP pin only programs the termination current and
conditioning current.
AA
PP
LL
IICC
AA
TT
IIOO
NN
SS
相關PDF資料 |
PDF描述 |
|---|---|
| LY510ALHTR | SPECIALTY ANALOG CIRCUIT, PBGA16 |
| LZ0P3817 | SPECIALTY ANALOG CIRCUIT, CQCC36 |
| M0280RJ240 | 123 A, 2400 V, SILICON, RECTIFIER DIODE |
| M0280SJ220 | 123 A, 2200 V, SILICON, RECTIFIER DIODE |
| M1022LC140 | 1022 A, 1400 V, SILICON, RECTIFIER DIODE |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LX2208 | 制造商:MICROSEMI 制造商全稱:Microsemi Corporation 功能描述:2 Amp Three Level Lithium Ion Battery Charger |
| LX2208 EVAL KIT | 制造商:Microsemi Corporation 功能描述:LINEAR - LITHIUM ION - Bulk |
| LX2208ILD | 制造商:Microsemi Corporation 功能描述: 制造商:Microsemi Corporation 功能描述:LINEAR - LITHIUM ION - Bulk |
| LX2240B | 制造商:未知廠家 制造商全稱:未知廠家 功能描述:杭州正芯微電子有限公司是一家專業的ＩＣ設計公司，產品涉及的的領域為家電產品 |
| LX2260ILQ | 制造商:Microsemi Corporation 功能描述:IC - Bulk |
發布緊急采購，3分鐘左右您將得到回復。