參數資料
型號: LT1185I
廠商: Linear Technology Corporation
英文描述: 9-Bit Odd/Even Parity Generators/Checkers 14-SOIC 0 to 70
中文描述: 低壓差穩壓器
文件頁數: 11/16頁
文件大小: 211K
代理商: LT1185I
11
LT1185
APPLICATIU
Thermal Regulation
IC regulators have a regulation term not found in discrete
designs because the power transistor is thermally coupled
to the reference. This creates a shift in the output voltage
which is proportional to power dissipation in the regulator.
U
W
U
V
OUT
= P(K1 + K2
θ
JA
)
= (I
OUT
)(V
IN
– V
OUT
)(K1 + K2
θ
JA
)
K1 and K2 are constants. K1 is a fast time constant effect
caused by die temperature gradientswhich are estab-
lished within 50ms of a power change. K1 is specified on
the data sheet as thermal regulation, in percent per watt.
K2 is a long time constant term caused by the temperature
drift of the regulator reference voltage. It is also specified,
but in percent per degree centigrade. It must be multiplied
by overall thermal resistance, junction-to-ambient,
θ
JA
.
As an example, assume a 5V regulator with an input
voltage of 8V, load current of 2A, and a total thermal
resistance of 4
°
C/W, including junction-to-case, (use
control area specification), interface, and heat sink resis-
tance. K1 and K2, respectively, from the data sheet are
0.014%/W and 0.01%/
°
C.
V
OUT
= (2A)(8V –5V)(0.014 + 0.01 4)
= 0.32%
This shift in output voltage could be in either direction
because K1 and K2 can be either positive or negative.
Thermal regulation is already included in the worst case
reference specification.
Output Voltage Reversal
Some IC regulators suffer from a latch-up state when their
output is forced to a reverse voltage of as little as one diode
drop. The latch-up state can be triggered without a fault
condition when the load is connected to an opposite
polarity supply instead of to ground. If the second supply
is turned on first, it will pull the output of the first supply
to a reverse voltage through the load. The first supply may
then latch off when turned on. This problem is particularly
annoying because the diode clamps which should always
be used to protect against polarity reversal do not usually
stop the latch-up problem.
The LT1185 is designed to allow output reverse polarity of
several volts without damage or latch-up, so that a simple
diode clamp can be used.
相關PDF資料
PDF描述
LT1185IT 9-Bit Odd/Even Parity Generators/Checkers 14-SOIC 0 to 70
LT1185M 9-Bit Odd/Even Parity Generators/Checkers 14-SOIC 0 to 70
LT1185MK 9-Bit Odd/Even Parity Generators/Checkers 14-SOIC 0 to 70
LT1185 Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection
LT1186 9-Bit Odd/Even Parity Generators/Checkers 14-SOIC 0 to 70
相關代理商/技術參數
參數描述
LT1185IQ 制造商:Linear Technology 功能描述:LDO Regulator Neg/Pos -2.5V to -25V2.5V to 25V 3A 6-Pin(5+Tab) DDPAK
LT1185IQ#PBF 功能描述:IC REG LDO NEG ADJ 3A 5-DD RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓撲結構:正,固定式 輸出電壓:8V 輸入電壓:10.5 V ~ 23 V 電壓 - 壓降(標準):1.7V @ 40mA 穩壓器數量:1 電流 - 輸出:100mA(最小值) 電流 - 限制(最?。?- 工作溫度:0°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:8-SOIC(0.154",3.90mm 寬) 供應商設備封裝:8-SOIC 包裝:剪切帶 (CT) 產品目錄頁面:1075 (CN2011-ZH PDF) 其它名稱:296-24390-1
LT1185IQ#PBF 制造商:Linear Technology 功能描述:VOLTAGE REGULATOR LDO ADJ 3 制造商:Linear Technology 功能描述:VOLTAGE REGULATOR, LDO, ADJ, 3A, TO-263-
LT1185IQ#TR 制造商:Linear Technology 功能描述:LDO Regulator Neg/Pos -2.5V to -25V2.5V to 25V 3A 6-Pin(5+Tab) DDPAK T/R
LT1185IQ#TRPBF 功能描述:IC REG LDO NEG ADJ 3A 5-DD RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓撲結構:正,固定式 輸出電壓:3V 輸入電壓:2.3 V ~ 5.5 V 電壓 - 壓降(標準):0.035V @ 150mA 穩壓器數量:2 電流 - 輸出:150mA 電流 - 限制(最?。?300mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 裸露焊盤,6-TMLF? 供應商設備封裝:6-TMLF?(1.6x1.6) 包裝:Digi-Reel® 產品目錄頁面:1104 (CN2011-ZH PDF) 其它名稱:576-3018-6