- 您現在的位置：買賣IC網 > PDF目錄377692 > LT1185 (Linear Technology Corporation) Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection PDF資料下載
參數資料
| 型號： | LT1185 |
| 廠商： | Linear Technology Corporation |
| 元件分類： | 基準電壓源/電流源 |
| 英文描述： | Cap-Free, NMOS, 150mA Low Dropout Regulator with Reverse Current Protection |
| 中文描述： | 無電容，NMOS管，150mA的低壓差穩壓器的反向電流保護 |
| 文件頁數： | 11/16頁 |
| 文件大?。?/td> | 216K |
| 代理商： | LT1185 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁當前第11頁第12頁第13頁第14頁第15頁第16頁
11
LT1185
APPLICATIU
Thermal Regulation
IC regulators have a regulation term not found in discrete
designs because the power transistor is thermally coupled
to the reference. This creates a shift in the output voltage
which is proportional to power dissipation in the regulator.
U
W
U
V
OUT
= P(K1 + K2
θ
JA
)
= (I
OUT
)(V
IN
– V
OUT
)(K1 + K2
θ
JA
)
K1 and K2 are constants. K1 is a fast time constant effect
caused by die temperature gradientswhich are estab-
lished within 50ms of a power change. K1 is specified on
the data sheet as thermal regulation, in percent per watt.
K2 is a long time constant term caused by the temperature
drift of the regulator reference voltage. It is also specified,
but in percent per degree centigrade. It must be multiplied
by overall thermal resistance, junction-to-ambient,
θ
JA
.
As an example, assume a 5V regulator with an input
voltage of 8V, load current of 2A, and a total thermal
resistance of 4
°
C/W, including junction-to-case, (use
control area specification), interface, and heat sink resis-
tance. K1 and K2, respectively, from the data sheet are
0.014%/W and 0.01%/
°
C.
V
OUT
= (2A)(8V –5V)(0.014 + 0.01 4)
= 0.32%
This shift in output voltage could be in either direction
because K1 and K2 can be either positive or negative.
Thermal regulation is already included in the worst case
reference specification.
Output Voltage Reversal
Some IC regulators suffer from a latch-up state when their
output is forced to a reverse voltage of as little as one diode
drop. The latch-up state can be triggered without a fault
condition when the load is connected to an opposite
polarity supply instead of to ground. If the second supply
is turned on first, it will pull the output of the first supply
to a reverse voltage through the load. The first supply may
then latch off when turned on. This problem is particularly
annoying because the diode clamps which should always
be used to protect against polarity reversal do not usually
stop the latch-up problem.
The LT1185 is designed to allow output reverse polarity of
several volts without damage or latch-up, so that a simple
diode clamp can be used.
相關PDF資料 |
PDF描述 |
|---|---|
| LT1186 | 9-Bit Odd/Even Parity Generators/Checkers 14-SOIC 0 to 70 |
| LT1186FCS | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1186F | 9-Bit Odd/Even Parity Generators/Checkers 14-PDIP 0 to 70 |
| LT1186FC | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
| LT1186FI | RADIATION HARDENED HIGH EFFICIENCY, 5 AMP SWITCHING REGULATORS |
相關代理商/技術參數 |
參數描述 |
|---|---|
| LT1185CQ | 功能描述:IC REG LDO NEG ADJ 3A DDPAK-5 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3V 輸入電壓:2.3 V ~ 5.5 V 電壓 - 壓降（標準）:0.035V @ 150mA 穩壓器數量:2 電流 - 輸出:150mA 電流 - 限制（最?。?300mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 裸露焊盤，6-TMLF? 供應商設備封裝:6-TMLF?（1.6x1.6） 包裝:Digi-Reel® 產品目錄頁面:1104 (CN2011-ZH PDF) 其它名稱:576-3018-6 |
| LT1185CQ#PBF | 功能描述:IC REG LDO NEG ADJ 3A DDPAK-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:3,000 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3V 輸入電壓:最高 5.5V 電壓 - 壓降（標準）:0.12V @ 150mA 穩壓器數量:1 電流 - 輸出:150mA（最小值） 電流 - 限制（最?。?220mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:SOT-23-5 細型，TSOT-23-5 供應商設備封裝:TSOT-23-5 包裝:帶卷 (TR) 其它名稱:ADP160AUJZ-3.0-R7TR |
| LT1185CQ#TR | 功能描述:IC REG LDO NEG ADJ 3A DDPAK-5 RoHS:否 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3V 輸入電壓:2.3 V ~ 5.5 V 電壓 - 壓降（標準）:0.035V @ 150mA 穩壓器數量:2 電流 - 輸出:150mA 電流 - 限制（最?。?300mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 裸露焊盤，6-TMLF? 供應商設備封裝:6-TMLF?（1.6x1.6） 包裝:Digi-Reel® 產品目錄頁面:1104 (CN2011-ZH PDF) 其它名稱:576-3018-6 |
| LT1185CQ#TRPBF | 功能描述:IC REG LDO NEG ADJ 3A DDPAK-5 RoHS:是 類別:集成電路 (IC) >> PMIC - 穩壓器 - 線性 系列:- 標準包裝:1 系列:- 穩壓器拓?fù)浣Y(jié)構:正，固定式 輸出電壓:3V 輸入電壓:2.3 V ~ 5.5 V 電壓 - 壓降（標準）:0.035V @ 150mA 穩壓器數量:2 電流 - 輸出:150mA 電流 - 限制（最?。?300mA 工作溫度:-40°C ~ 125°C 安裝類型:表面貼裝 封裝/外殼:6-UFDFN 裸露焊盤，6-TMLF? 供應商設備封裝:6-TMLF?（1.6x1.6） 包裝:Digi-Reel® 產品目錄頁面:1104 (CN2011-ZH PDF) 其它名稱:576-3018-6 |
| LT1185CQPBF | 制造商:Linear Technology 功能描述:LDO Regulator Neg/Pos 2.5-25V 3A DDPAK6 |
發布緊急采購，3分鐘左右您將得到回復。