參數資料
型號: L6567D
廠商: 意法半導體
英文描述: HIGH VOLTAGE DRIVER FOR CFL
中文描述: 高壓驅動節能燈
文件頁數: 6/15頁
文件大?。?/td> 115K
代理商: L6567D
L6567
6/15
Figure 1. Start up
Oscillator
The circuit starts oscillating when the voltage supply V
S
has reached the V
S HIGH1
threshold. In steady state
condition the oscillator capacitor C
F
(at pin12) is charged anddischarged symmetrically with a current setmain-
ly by the external resistor R
REF
connected to pin 10. The value of the frequency is determined by capacitor C
F
and resistor R
REF
. This fixed value is called F
MIN
. A dead time T
DT
between the ON phases of the transistors
is provided for avoiding cross conduction, so the duty cycle for each is less than 50%. The dead time depends
on R
REF
value (fig. 7).
The IC oscillating frequency is between F
MIN
and F
MAX
= 2.5 · F
MIN
in all conditions.
Preheatingmode
The oscillator starts switching at the maximum frequency F
MAX
. Then the frequency decreases at once to reach
the programmed preheating frequency (fig.2). The rate of decreasing (df/dt) is determined by the external ca-
pacitor C
I
(pin 14). The preheat time T
PRE
is adjustable with external components (R
REF
and C
P
). The preheat
current is adjusted by sense resistance R
SHUNT
. During the preheating time the load current is sensed with the
sense resistor R
SHUNT
(connected between pin 9-R
S
- and pin 7-PGND-). At pin 9 the voltage drop on R
SHUNT
is sensed at themoment the low side MOS FET is turnedoff. There is an internal comparator with a fixed thresh-
old V
PH
: ifV
RS
> V
PH
the frequency isdecreased and ifV
RS
<V
PH
thefrequency is increased. If the V
PH
thresh-
old is reached, the frequency is held constant for the programmed preheating time T
PRE
.
T
PRE
is determined by the external capacitor C
P
(pin8) and by the resistor R
REF
: C
P
is charged 16 times with a
current that depends on R
REF
, and these 16 cycles determine the T
PRE
.
So the preheat mode is programmable with external components as far as T
PRE
is concerned (R
REF
&C
P
) and
as far as the preheating current is concerned (choosing properly R
SHUNT
and the resonant load components:
L and C
L
).
The circuit is held in the preheating mode when pin 8 (C
P
) is grounded.
In case F
MIN
is reached during preheat, the IC assumes an open load. Consequently the oscillation stops with
the low side MOS transistor gate on and the high side gate off. This condition is kept until V
S
undershoots V
SLOW1
.
V
SLOW1
V
SHIGH1
V
G
low side mosfet
V
G
-V
S
high side mosfet
C
F
V
S
T
DT
TIME
0
0
0
0
相關PDF資料
PDF描述
L6571B High Voltage Half Bridge Driver with Oscillator(帶晶振的高電壓半橋驅動器)
L6585D PFC and Ballast Control IC
L6585DTR PFC and Ballast Control IC
L6590 Fully Integrated Power Supply FIPSTM(完全集成電源)
L6598D013TR HIGH VOLTAGE RESONANT CONTROLLER
相關代理商/技術參數
參數描述
L6569 功能描述:功率驅動器IC Hi-Volt Half Bridge RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
L6569 制造商:STMicroelectronics 功能描述:IC HALF BRIDGE+OSC 6569 DIP8
L6569A 功能描述:功率驅動器IC Hi-Volt Half Bridge RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
L6569A 制造商:STMicroelectronics 功能描述:IC HALF BRIDGE+OSC 6569 DIP8
L6569AD 功能描述:功率驅動器IC Hi-Volt Half Bridge RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube