參數資料
型號: L6566BTR
廠商: 意法半導體
英文描述: Multi-mode controller for SMPS
中文描述: 多模式開關電源控制器
文件頁數: 37/51頁
文件大?。?/td> 401K
代理商: L6566BTR
L6566B
Application information
37/51
Equation 15
where T
BLANK2
= 2 μs; this is also illustrated in the diagram of
Figure 24
.
5.12
Brownout protection
Brownout Protection is basically a not-latched device shutdown function activated when a
condition of mains undervoltage is detected. There are several reasons why it may be
desirable to shut down a converter during a brownout condition, which occurs when the
mains voltage falls below the minimum specification of normal operation.
Firstly, a brownout condition may cause overheating of the primary power section due to an
excess of RMS current. Secondly, spurious restarts may occur during converter power
down, hence causing the output voltage not to decay to zero monotonically.
L6566B shutdown upon brownout is accomplished by means of an internal comparator, as
shown in the block diagram of
Figure 25 on page 38
, which shows the basic usage. The
inverting input of the comparator, available on the AC_OK pin (16), is supposed to sense a
voltage proportional to the RMS (peak) mains voltage; the non-inverting input is internally
referenced to 0.485V with 35 mV hysteresis. If the voltage applied on the AC_OK pin before
the device starts operating does not exceed 0.485V or if it falls below 0.45 V while the
device is running, the AC_FAIL signal goes high and the device shuts down, with the soft-
start capacitor discharged and the gate-drive output low. Additionally, if the device has been
latched off by some protection function (testified by Vcc oscillating between V
ccON
and
V
ccON
- 0.5V) the AC_OK voltage falling below 0.45 V clears the latch. This may allow a
quicker restart as the input source is removed.
While the brownout protection is active the start-up generator keeps on working but, being
there no PWM activity, the Vcc voltage continuously oscillates between the start-up and the
HV generator restart thresholds, as shown in the timing diagram of
Figure 25
.
Figure 24. Maximum allowed duty cycle vs. switching frequency for correct OVP
detection
1
f
T
D
sw
2
BLANK
+
5
.
10
4
1
.
10
5
1.5
.
10
5
2
.
10
5
2.5
.
10
5
3
.
10
5
3.5
.
10
5
4
.
10
5
0.2
0.3
0.4
0.5
0.6
0.7
0.8
0.725
fsw [Hz]
Dmax
相關PDF資料
PDF描述
L6567 HIGH VOLTAGE DRIVER FOR CFL
L6567D HIGH VOLTAGE DRIVER FOR CFL
L6571B High Voltage Half Bridge Driver with Oscillator(帶晶振的高電壓半橋驅動器)
L6585D PFC and Ballast Control IC
L6585DTR PFC and Ballast Control IC
相關代理商/技術參數
參數描述
L6566BTR-CUT TAPE 制造商:ST 功能描述:L6566B Series 23 V 4.6 mA SMPS Multi-Mode Controller Surface Mount - SOIC-16N
L6567 制造商:STMICROELECTRONICS 制造商全稱:STMicroelectronics 功能描述:HIGH VOLTAGE DRIVER FOR CFL
L6567D 制造商:STMicroelectronics 功能描述:CFL DRVR 18V 14SOP - Rail/Tube
L6569 功能描述:功率驅動器IC Hi-Volt Half Bridge RoHS:否 制造商:Micrel 產品:MOSFET Gate Drivers 類型:Low Cost High or Low Side MOSFET Driver 上升時間: 下降時間: 電源電壓-最大:30 V 電源電壓-最小:2.75 V 電源電流: 最大功率耗散: 最大工作溫度:+ 85 C 安裝風格:SMD/SMT 封裝 / 箱體:SOIC-8 封裝:Tube
L6569 制造商:STMicroelectronics 功能描述:IC HALF BRIDGE+OSC 6569 DIP8