- 您現在的位置：買賣IC網 > PDF目錄362811 > IS89LV51 CMOS Single Chip Low Voltage 8-Bit Microcontroller PDF資料下載
參數資料
| 型號： | IS89LV51 |
| 英文描述： | CMOS Single Chip Low Voltage 8-Bit Microcontroller |
| 中文描述： | CMOS單芯片低電壓8位微控制器 |
| 文件頁數： | 18/48頁 |
| 文件大小： | 776K |
| 代理商： | IS89LV51 |
第1頁第2頁第3頁第4頁第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁當前第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁第37頁第38頁第39頁第40頁第41頁第42頁第43頁第44頁第45頁第46頁第47頁第48頁
IS89LV51
18
1-800-379-4774 — Integrated Silicon Solution, Inc.
ADVANCE INFORMATION
MC020-0A
10/27/98
ISSI
SERIAL INTERFACE
The Serial port is full duplex, which means it can transmit
and receive simultaneously. It is also receive-buffered,
which means it can begin receiving a second byte before
a previously received byte has been read from the receive
register. (However, if the first byte still has not been read
when reception of the second byte is complete, one of the
bytes will be lost.) The serial port receive and transmit
registers are both accessed at Special Function Register
SBUF. Writing to SBUF loads the transmit register, and
reading SBUF accesses a physically separate receive
register.
The serial port can operate in the following four modes:
Mode 0:
Serial data enters and exits through RXD. TXD outputs the
shift clock. Eight data bits are transmitted/received, with
the LSB first. The baud rate is fixed at 1/12 the oscillator
frequency (see Figure 12).
Mode 1:
Ten bits are transmitted (through TXD) or received (through
RXD): a start bit (0), eight data bits (LSB first), and a stop
bit (1). On receive, the stop bit goes into RB8 in Special
Function Register SCON. The baud rate is variable (see
Figure 13).
Mode 2:
Eleven bits are transmitted (through TXD) or received
(through RXD): a start bit (0), eight data bits (LSB first), a
programmable ninth data bit, and a stop bit (1). On transmit,
the ninth data bit (TB8 in SCON) can be assigned the value
of 0 or 1. Or, for example, the parity bit (P, in the PSW) can
be moved into TB8. On receive, the ninth data bit goes into
RB8 in Special Function Register SCON, while the stop bit
is ignored. The baud rate is programmable to either 1/32 or
1/64 the oscillator frequency (see Figure 14).
Mode 3:
Eleven bits are transmitted (through TXD) or received
(through RXD): a start bit (0), eight data bits (LSB first), a
programmable ninth data bit, and a stop bit (1). In fact,
Mode 3 is the same as Mode 2 in all respects except the
baud rate, which is variable in Mode 3 (see Figure 15).
In all four modes, transmission is initiated by any instruction
that uses SBUF as a destination register. Reception is
initiated in Mode 0 by the condition RI = 0 and REN = 1.
Reception is initiated in the other modes by the incoming
start bit if REN = 1.
相關PDF資料 |
PDF描述 |
|---|---|
| ISB18006-DIE | ASIC |
| ISB18010-DIE | ASIC |
| ISB18013-DIE | ASIC |
| ISB18018-DIE | ASIC |
| ISB18026-DIE | ASIC |
相關代理商/技術參數 |
參數描述 |
|---|---|
| IS8DH33 | 制造商:Newport Electronics Inc 功能描述:1/8 DUAL/H,ST/P,CN |
| IS90 | 制造商:IDEC CORPORATION 功能描述:SENS.IND. 2W/F 24-230VAC NC |
| IS900 | 制造商:ISOCOM 制造商全稱:ISOCOM 功能描述:MICROPROCESSOR COMPATIBLE SCHMITT TRIGGER OPTICALLY COUPLED ISOLATOR |
| IS902-300ML | 制造商:MG Chemicals 功能描述:Silicone; Potting and Encapsulating; 300 ml Cartridge |
| IS90D | 制造商:IDEC CORPORATION 功能描述:SENS.IND. 2W/F 24-230VAC NC |
發布緊急采購，3分鐘左右您將得到回復。