參數資料
型號: IRF7105
廠商: Microsemi Corporation
英文描述: EVALUATION KIT
中文描述: 評估板
文件頁數: 9/18頁
文件大?。?/td> 339K
代理商: IRF7105
LXE1710 E
VALUATION
B
OARD
U
SER
G
UIDE
Microsemi
Linfinity Microelectronics Division
11861 Western Avenue, Garden Grove, CA. 92841, 714-898-8121, Fax: 714-893-2570
Page 9
Copyright
2000
Rev. 1.1, 2000-12-01
A
PPLICATION
I
NFORMATION
! &' (
LX1710 Filter Implementation, 1-stage vs. 2- stage
0.001
100
50
0.002
0.005
0.01
0.02
0.05
0.2
1
2
5
10
20
0.55626
0.12572
P
50m
30
100m
200m
500m
1
2
5
10
20
25.04
1.15
Watts(W)
2-Stage
1-Stage
F
ILTER
D
ESIGN
T
RADEOFFS
(1-
STAGE VS
. 2-
STAGE
)
A 1-stage or 2-stage filter may be used depending on
your application and performance targets. The main
tradeoff in this selection is price (number of
components, component costs, PCB area) vs.
performance. The primary advantage of the single
stage filter is lower cost whereas the main benefit to a
2-stage filter is that it will provide steeper attenuation.
This allows the corner frequency to be selected further
outside of the audio band (to minimize the effects of
impedance variations in the passband) and still
provide adequate RF attenuation.
Single Stage Filter Advantages
Low Cost: The 1-stage LC filter uses one half
the number of inductors/capacitors resulting in
a substantial cost savings over a 2-stage
design. Key parameters such as THD+N,
frequency response, and nose performance
do not change significantly.
Power Loss: Since current will flow in two
inductors and not four, the inductor power loss
will be less in the single stage design. The
overall amplifier will have a wider dynamic
range and improved efficiency.
Filter Design: This easy-to-design filter can
limit audio signal changes within +/- 3dB
across the audio band with impedance
vari
" ) *+ ,!
a steeper rolloff with the 2-stage filter,
impedance changes could result in a +/- 6dB
change.
THD: There are minimal differences between
the 1-stage and 2-stage implementations with
other parameters such as THD+N as seen in
the above graph.
Single Stage Filter Disadvantages
EMI and Switching Frequency: For the 1-
stage, the switching frequency must be higher
than 400kHz to ensure the corner frequency
will provide adequate amplifier performance in
the high end of the audio frequency range. If
f
S
< 400kHz, then
f
C
<
f
S
/10 = 40kHz which is
too close to the desired audio band. A higher
oscillation frequency could translate into
greater MOSFET switching losses, slightly
lower efficiency, and increased EMI effects.
With a 2-stage 4th order filter, the switching
frequency
f
S
can be reduced to 120kHz. If
f
S
=
120kHz, then
f
C
=
f
S
/3 = 40kHz. The lower
oscillation frequency could help minimize EMI
issues.
LC F
ILTER
D
ESIGN
The output filter helps to reconstruct the amplified
audio signal and filter out the switching frequency.
The design of the filter depends on the type of
attenuation and frequency response desired at the
output. The output filter designed into the LXE1710
相關PDF資料
PDF描述
IRF7205 HEXFET Power MOSFET
IRF7207 HEXFET Power MOSFET
IRF7240 HEXFET Power MOSFET
IRF7241PBF HEXFET Power MOSFET
IRF7241 HEXFET Power MOSFET
相關代理商/技術參數
參數描述
IRF7105PBF 功能描述:MOSFET 25V DUAL N / P CH 20 VGS MAX V RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS(導通):0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube
IRF7105Q9BF 制造商:IRF 制造商全稱:International Rectifier 功能描述:HEXFET POWER MOSFET
IRF7105QPBF 功能描述:MOSFET RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS(導通):0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube
IRF7105QPBF_10 制造商:IRF 制造商全稱:International Rectifier 功能描述:HEXFETPOWERMOSFET
IRF7105QTRPBF 功能描述:MOSFET RoHS:否 制造商:STMicroelectronics 晶體管極性:N-Channel 汲極/源極擊穿電壓:650 V 閘/源擊穿電壓:25 V 漏極連續電流:130 A 電阻汲極/源極 RDS(導通):0.014 Ohms 配置:Single 最大工作溫度: 安裝風格:Through Hole 封裝 / 箱體:Max247 封裝:Tube