- 您現在的位置：買賣IC網 > PDF目錄362744 > EPC16QI100 (Altera Corporation) 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet PDF資料下載
參數資料
| 型號： | EPC16QI100 |
| 廠商： | Altera Corporation |
| 英文描述： | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
| 中文描述： | 2。增強型配置器件（EPC4，EPC8 |
| 文件頁數： | 5/36頁 |
| 文件大?。?/td> | 421K |
| 代理商： | EPC16QI100 |
第1頁第2頁第3頁第4頁當前第5頁第6頁第7頁第8頁第9頁第10頁第11頁第12頁第13頁第14頁第15頁第16頁第17頁第18頁第19頁第20頁第21頁第22頁第23頁第24頁第25頁第26頁第27頁第28頁第29頁第30頁第31頁第32頁第33頁第34頁第35頁第36頁
Altera Corporation
August 2005
2–5
Configuration Handbook, Volume 2
Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet
In addition to transmitting configuration data to the FPGAs, the
configuration circuit is also responsible for pausing configuration
whenever there is insufficient data available for transmission. This occurs
when the flash read bandwidth is lower than the configuration write
bandwidth. Configuration is paused by stopping the
DCLK
to the FPGA,
when waiting for data to be read from the flash or for data to be
decompressed. This technique is called “Pausing
DCLK
.”
The enhanced configuration device flash memories feature a 90-ns access
time (approximately 10 MHz). Hence, the flash read bandwidth is limited
to about 160 megabits per second (Mbps) (16-bit flash data bus,
DQ[]
, at
10 MHz). However, the configuration speeds supported by Altera FPGAs
are much higher and translate to high configuration write bandwidths.
For instance, 100-MHz Stratix FPP configuration requires data at the rate
of 800 Mbps (8-bit
DATA[]
bus at 100 MHz). This is much higher than the
160 Mbps the flash memory can support, and is the limiting factor for
configuration time. Compression increases the effective flash read
bandwidth since the same amount of configuration data takes up less
space in the flash memory after compression. Since Stratix configuration
data compression ratios are approximately two, the effective read
bandwidth doubles to about 320 Mbps.
Finally, the configuration controller also manages errors during
configuration. A
CONF_DONE
error occurs when the FPGA does not de-
assert its
CONF_DONE
signal within 64 DCLK cycles after the last bit of
configuration data is transmitted. When a
CONF_DONE
error is detected,
the controller pulses the
OE
line low, which pulls
nSTATUS
low and
triggers another configuration cycle.
A cyclic redundancy check (CRC) error occurs when the FPGA detects
corruption in the configuration data. This corruption could be a result of
noise coupling on the board such as poor signal integrity on the
configuration signals. When this error is signaled by the FPGA (by
driving the
nSTATUS
line low), the controller stops configuration. If the
Auto-Restart Configuration After Error
option is enabled in the FPGA,
it releases its
nSTATUS
signal after a reset time-out period and the
controller attempts to reconfigure the FPGA.
After the FPGA configuration process is complete, the controller drives
DCLK
low and the
DATA[]
pins high. Additionally, the controller tri-
states its internal interface to the flash memory, enables the weak internal
pull-ups on the flash address and control lines, and enables bus-keep
circuits on flash data lines.
The following sections briefly describe the different configuration
schemes supported by the enhanced configuration device: FPP, PS, and
concurrent configuration.
相關PDF資料 |
PDF描述 |
|---|---|
| EPC8xxx | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
| EPC8QC100 | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
| EPC8QI100 | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
| EPC16xxx | 435882001 |
| EPC4QC100 | 2. Enhanced Configuration Devices (EPC4, EPC8 & EPC16) Data Sheet |
相關代理商/技術參數 |
參數描述 |
|---|---|
| EPC16QI100N | 功能描述:FPGA-配置存儲器 IC - Ser. Config Mem Flash 16Mb 33 MHz RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20 |
| EPC16UC88 | 功能描述:FPGA-配置存儲器 IC - Ser. Config Mem Flash 16Mb 33 MHz RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20 |
| EPC16UC88AA | 功能描述:IC CONFIG DEVICE 16MBIT 88-UBGA RoHS:否 類別:集成電路 (IC) >> 存儲器 - 用于 FPGA 的配置 Proms 系列:EPC 產品變化通告:Product Discontinuation 28/Jul/2010 標準包裝:98 系列:- 可編程類型:OTP 存儲容量:300kb 電源電壓:3 V ~ 3.6 V 工作溫度:-40°C ~ 85°C 封裝/外殼:8-SOIC（0.154"，3.90mm 寬） 供應商設備封裝:8-TSOP 包裝:管件 |
| EPC16UC88N | 功能描述:FPGA-配置存儲器 IC - Ser. Config Mem Flash 16Mb 33 MHz RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20 |
| EPC16UI88AA | 功能描述:FPGA-配置存儲器 IC - Ser. Config Mem Flash 16Mb 33 MHz RoHS:否 制造商:Altera Corporation 存儲類型:Flash 存儲容量:1.6 Mbit 工作頻率:10 MHz 電源電壓-最大:5.25 V 電源電壓-最小:3 V 電源電流:50 uA 最大工作溫度:+ 85 C 最小工作溫度:- 40 C 安裝風格:SMD/SMT 封裝 / 箱體:PLCC-20 |
發布緊急采購，3分鐘左右您將得到回復。